A block of mass 50 kg supported by a lining material made of rubber as shown in fig. When the block placed on the lining, the lining of static deflection is 10 mm. When the vibrator act with force F = 200sin50t N found the vibration amplitude is 2 mm. Determine i. the stiffness coefficient of the lining ii. The natural frequency i. the damping coefficient lining iv. the force exerted by the lining to the floor. vibrator 50 kg

A block of mass 50 kg supported by a lining material made of rubber as shown in fig. When the block placed on the lining, the lining of static deflection is 10 mm. When the vibrator act with force F = 200sin50t N found the vibration amplitude is 2 mm. Determine i. the stiffness coefficient of the lining ii. The natural frequency i. the damping coefficient lining iv. the force exerted by the lining to the floor. vibrator 50 kg

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A single degree of freedom mass-spring-damper system is subject to vibration under the influence of a harmonic force. On my site, it is given as m=2 kg, k=800 N/m, c=64 Ns/m. The amplitude of the harmonic force is F0=256 N and its frequency is w= 20 rad/s. Answer the questions in options a, b, and c according to the given information. 1) Calculate the damping ratio of the system (ξ) a.1 b.0.7 c.0.9 d.0.8 2)Calculate the magnification factor (M) of the system. a.0.86 b.1.25 c.0.312 D.0.625 3-) Calculate the maximum vibration amplitude (X) (meters). a.0.2 b.0.1 c.0.4 D.0.3
a damper, the frequency of oscillation is found to the stiffness of the spring is 1 kN/m. By introducing coefficient of the damper? be 90% of the original value. What is the damping In a spring-mass system, the mass is 0.1 kg and the stiffness of the spring is 1 kN/m. By introducing be 90% of the original value. What is the damping (a) 1.2 Ns/m (b) 3.4 Ns/m (c) 8.7 Ns/m (d) 12.0 Ns/m
330.4691 kg, the stiffnesses K1=546103.6157 N/m, K2 = 417004.9619 N/m, the damping constant C =14789.1815 N.s/m and the length L = 0.3215 m. The damped natural frequency of the free vibration of this system is:
A machine weighing 300lb is mounted on a supporting system consisting of four springs and four dampers. The vertical deflection of the supporting system under the weight of the machine is measured as 0.75in. The dampers are designed to reduce the amplitudeof vertical vibration to one-sixthof the initial amplitude after two complete cycles of free vibration. Find the following undamped natural frequency,damping ratio, and damped natural frequencyofthesystem.
A mass of 5 kg is suspended on a spring and set on oscillations. It is observed that theamplitude reduces to 5% of its initial value after 2 oscillations. It takes 0.5 seconds to do thetwo oscillations. Calculate the following.(i) The damping ratio(ii) The natural frequency(iii) The actual frequency(iv) The spring stiffness(v) The critical damping coefficient(vi) The actual damping coefficient
A vibrating system consists of a mass of 8kg, spring of stiffness 5.6N/m and dashpot of damping coefficient of 40N/m/s. Find, (i)Critical damping coefficient (ii) the damping factor (iii)the natural frequency of damped vibration (iv)the logarithmic decrement (v)the ratio of two consecutive amplitude (vi)the number of cycles after which the original amplitude is reduced to 20 percent.
A mass of flexible machine part, m1 of 30 kg was observed to vibrate badly at frequency of 10 Hz. The vibration was caused by the application of a harmonic force, F of the flexible part. A judgment was made by a mechanical engineer that the viviauon was excessive because the frequency of the harmonic force coincides with the natural frequency of the flexible part. 100 N to (b) If the flexible machine part was be modeled as a spring-mass-damper system, calculate the value of equivalent stiffness, k, of the system. Give final answer in unit of kN/m. (c) Analyze the mass and stiffness of an absorber that would eliminate vibrations of the flexible part at frequency of 10 Hz, if the amplitude motion of the absorber mass, Xa at 10 Hz was observed to be 0.3 cm. (d) If the flexible machine part is operated in the speed range of 500 to 750 rpm, justify whether the design of vibration absorber in Q3(c) is safe to be used or not.
Question 1. A body of mass 100 kKg is suspended by a spring of stifness of 30KN/m and a dashpot of damping constant 1000 N.s/m. Vibration is excited by harmonic force ft)=80 cos (67tt) 1- Write the equation of motion of the system using Lagrange's equation. 2- Find the natural frequency and the driving frequency. 3- Write the complete solution of the vibrating system.
In free vibration we experimentally determine the natural frequency of a mass-spring system to be f, = 120.2796 Hz. The results show that decreasing the stiffness of the system by Ak = 592880.1217 N/m, the natural frequency will be decreased by Af, = 31.6418HZ. What is the
1. A system is needed to be designed as damped spring mass system. Calculate the amplitude of vibration. Stiffness=10 kN/m; mass 2Mg; and dashpot coefficient 2 kNs/m. It is subjected to a harmonic force = 500N @ frequency 0.5Hz ANS. X₁-43mm 2. What is the A length of three springs connected in series and parallel? Change in length of the spring is 4 cm. reelle k₁ llll пише m=160 gram
For a damped single degree of freedom system with natural frequency wn and damping ratio § , what is the least amount of damping ratio that eliminates any potential increase in vibration amplitude with increasing applied force frequency? Answer is 1/sqrt2 but how?
Critical damping means a situation in which the vibrator returns from the extreme position to the equilibrium position as quickly as possible so that the body does not pass over the equilibrium position. If the characteristic frequency of the body is 1.85 Hz and the mass is 590 kg, what is the damping coefficient of the suspension in the case of critical damping? Enter the answer in whole numbers.