A biomass furnace is tested to determine its performance in terms of heating and evaporating water. The furnace has a grate diameter of 0.3 m and a combustion chamber volume of 0.12 cubic meter. Wood is used as fuel with heating value of around 4,000 kcal/kg. Seventy-five liters of water, at 29°C, is used in the test using a stainless-steel boiler for 2.5 hours operation. The amount of water evaporated after the test is 7 liters. The total amount of fuel consumed is 12 kg.   Find the following: Fuel Consumption Rate Power Input Heat Used in Boiling Water

Q: What is the difference between an Insulator and a Dielectric?

A: Insulator- Insulator is a substance that provides tremendous amount of resistance towards the passag...

Q: Find total impedance

A: In this question,  We need to determine the total impedance Z?  We know XL = wL  Xc = 1/wC  

Q: 10 V 60 Hz 100 µF

A:

Q: 2. A uniform line charge with P = 5 µC/m lies along the x axis. Find D at (3, 2, 1) m.

A: using electric flux due to line charge formula calculate electric flux density at point (3,2,1)  due...

Q: 2. a) Draw nominal t model of Transmission Line.

A:

Q: R1 1k R2 R3 3.3k 5.6k R4 VS1 VS2 2.2k 15V 5V

A: The give circuit diagram is shown below:

Q: R1 A Vo R2 B

A:

Q: A series circuit with R= 10 52 L= 50 mH and C= 100 µF is supplied with 200 V/50 Hz. Find (1) the imp...

A: Consider the formula for the impedance of the circuit. Z=R2+XL-XC2 Formula for current in RLC circui...

Q: - Using Boolean algebra, simplify the following expressions: (a) (A + B(A + C) (c) BC+ BCD +B (b) AB...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Q: Find the charge in the volume defined by 1 <r< 3 m in spherical 5 sin?o coordinates if p =

A:

Q: What is the current through the diode? 1 N 2 IDEAL_DIODE R1 12 kn 12 V

A:

Q: Calculate I, in the circuit 20 2 60 2 40 2 24 V 10Ω 50 2 20 Ω ww ww

A: In this question,  We need to determine the current Io.  We are solving this problem using the nodal...

Q: Major: Signal and Systems for elecrtical engineering students Q: 4cos(x)+5sin(x) = A*cos(x-theta) f...

A: It is given that: 4cos(x)+5sin(x)=A*cos(x-theta)    

Q: Q3. Given the following timing chart for a sequential circuit, construct as much of the transition t...

A:

Q: Find the polarization in dielectric material with ᶓr = 2.8, if the electric flux density is 3x10- 7 ...

A: Polarization- Polarization is a property applied for the transverse wave which mark the geometric or...

Q: Problem 4 The magnetic circuit shown in the figure has two windings and two air gaps. The core can b...

A:

Q: Q5. Consider the circuit shown. (a) Construct a transition table and state graph for the following c...

A: J1=x Q2¯ . x¯Q2¯=x Q2+x Q2K1=x Q2J2=Q1+xK2=x+Q1Z=Q1¯+Q2 P.S. I/p           N.S.     Q1 Q2 x J1 ...

Q: 2. Two capacitors in parallel, 2-µF and 4-uF are connected in series with a 3-µF capacitor. The comb...

A:

Q: 7) The circuit shown uses a 36 V mains supply. 12 C 36 Và 242 Calculate the reading in A1 and A2 whe...

A:

Q: Perform the following operations involving eight-bit 2's complement numbers and indicate whether ari...

A:

Q: When Beta(B)=80, Calculate;  a.) IE b.) IB c.) IC e.) VB f.) VE g.) VC h.) VCE

A: The given circuit is a emitter biased CE amplifier and the required parameters can be calculated by ...

Q: ちらゃ。 12 2,5 what is the Value of unlkown ristutor) in the circuit shown, if the Voltage is I All E 1...

A:

Q: Given DC voltage and AC sinewave voltage in series, what would be the total power delivered to a 50o...

A:

Q: 7-12 In a buck-boost converter, consider all components to be ideal. Let Va be 8–40 V, V, = 15 V (re...

A: In a buck-boost converter, and all components to be ideal. Vd=8-40 VV0=15 V (regulated)fs=20 kHzC=47...

Q: a) Figure 1 shows a complex resistor combination circuit. Find the equivalent resistance REQ, Is and...

A:  

Q: Calculate by Thevenin the value of Vo

A: The given circuit is shown below:

Q: Two voltage measurements made across the same resistance are V1 25 V and V2 100 V. Calculate the pow...

A: The solution is given below 

Q: As inductors are added in series, circuit current increases circuit impedance decr...

A: By adding Inductances in series network results in total inductance increases and inductive reactanc...

Q: FROM THE SOLVE DIAGRAM FOR A COMBINATIONAL ELEMENT ACCORDING TO THE NOMENCLATURE FOR IT, WITH SAT DA...

A: In this question,  Find the VALUE OF RB  ?    If VCC = 18V,  VBE = .47V, VBB = 9V, VCE = .92 V IC Sa...

Q: Select any diode from LTSpice Library. (The type of diode should either be RECTIFIER or SILICON) Cre...

A:

Q: The result of capacitance C, = 6 microfarads and C2 connected in series is 3 microfarads. Capacitor ...

A:

Q: What transistor bias circuit with a single Q supply voltage provides good stability for the *polarit...

A: Voltage divider biassing is the process of applying a calculated resistive divider network to the te...

Q: Three phase alternators are invariably connected in star so as to  a. Reduce the size of stator cond...

A:

Q: Two bulbs of 250W, 230V each are connected across a 200V supply. Calculate the total power drawn fro...

A:

Q: What will be the branch voltage when Rx is adjusted to 162? What the magnitude and direction of the ...

A:

Q: Name the principal.components of aninduction motor.

A: The principal components of an induction motor are Stator Rotor Shaft Casing Bearings

Q: A simple one-pole system has transfer function H(s) = What is the magnitude of the frequency respons...

A: Given, A simple one pole system with transfer function Hs=11+τs  

Q: A single-phase transformer has a voltage ratio on open circuit of 7900/660 V. The primary and second...

A:   Transformer: It is a static device that is used to step up and step down the voltages.      

Q: W17.4 We are given a periodic function f with period 2a and such that f(x) = -f(-x+n) for all r. (a)...

A: We are given a periodic function f with period 2π and such that f(x)=-f(-x+π) for all x. a) We need ...

Q: A 20 KVA transformer has a maximum efficiency of 98% when delivering three quarter load at 1.0 pf. D...

A: In this question we need to find a all day efficiency of the given transformer.

Q: Calculate all the voltages and currents in the circuit shown below. I 40 80 13 Vs = 24/60° V (+ V1 }...

A:

Q: 5. Define stepper motor a. Explain the internal structure of stepper motor b. With Table explain the...

A: Stepper Motor: A stepper motor is an electric engine whose principle highlight is that its shaft tur...

Q: 15 V if the switch in the figure is closed the ammeter reading wi indicate

A:

Q: 2. Generating station at Musandam has the following load cycle. (Refer the data sheet below). Determ...

A: In this question,  We need to determine the maximum load,  Unit generated by per day We know 1kWH= 1...

Q: Calculate the phase difference between the Vin (V1) and Vout (Vc) signals in this circuit and expres...

A:

Q: Determine the differential equations of the given system diagram below:

A: In this question We need to Determine the differential equations of the given system.  This system i...

Q: In order to illustrate these definitions and operations, consider a vector field G -D уа, - 2.5 ха, ...

A:

Q: Problem7) Suppose that N(t) is a zero-mean stationary narrowband process. The autocorrelation functi...

A: GIVEN: RZ(τ)=EZ*(t)Z(t+τ) FIND: (a) EZ(t)Z(t+τ)=0            (b)  EV2EV2

Q: What is the direction of the electric field at the position indicated by the dot in the figure? Spec...

A: In this question,  2 electric charges are placed as shown in the circuit.  Find the electric field a...

Q: A complete circuit is shown (see figure), Determine the terminal voltage Vab on the 5.0 V battery. 1...

A: Apply Kirchhoff's voltage law in the loop.Let assume I is the current flowing in the circuit -12+1.4...

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.