ちらゃ。 12 2,5 what is the Value of unlkown ristutor) in the circuit shown, if the Voltage is I All E 1esistors are in ohws. 2,5 V un kown drop across the 500n resistor

Q: Q6. For the following state graph, derive the state table. X{X/Z¡ So X{X÷/Z2 Xq/Zz X¡/0/ X;/0 S X{X/...

A: Given,  We have state graph, we have to design state table. Please find the below attachments for th...

Q: 3. Four resistances R1, R2, R3, and R4 are connected in shunt against 220 V supply. The resistance a...

A: This is a simple problem based on ohm's law. In shunt connection voltage will constant across all re...

Q: 4. A coil of resistance 10 Qand inductance 0.1 H is connected in series with a 150-uF capacitor acro...

A: The solution is given below 

Q: 1-2i 2-i + 3-4i 5i а. b. i2004 + i1997 + i1957

A:

Q: Electrical Engineering Gcopper = 5.813×10" (Nm)', µo=4xx107 H/m, o-8.85x1012 F/m a) Find the high fr...

A: Given: Consider the parameters: σcopper=5.813×107 Ωm-1μo=4π×10-7 H/mεo=8.85×10-12 F/m To find: (a) F...

Q: Assume an op-amp has bias currents of 10.0 LA and 10.2 µA. The input offset current is O 20.2 LA 0.2...

A: Given data, An op-amp has bias current of I-=10.0 μAI+=10.2 μA  

Q: Two alternators running in parallel supply the following loads: 1500 kW at 0.9 lagging pf          ...

A:

Q: Identify the proper plot violations in the theoretical plot below. Plot List all violations 1.600.00...

A: Plot-  Plot is generally define as a graph or a pattern which shows the relation between the two par...

Q: Determine the amount of flux crossing the surface.

A:

Q: a) The power supplied to a three-phase induction motor is 32kW and the stator losses are 1200W. If t...

A: The solution is given below 

Q: Calculate I, in the circuit 20 2 60 2 40 2 24 V 10Ω 50 2 20 Ω ww ww

A: In this question,  We need to determine the current Io.  We are solving this problem using the nodal...

Q: Problem1. Find Vọ in the following circuit, using superposition. 6 A ↑ 10 18 V +

A: In superposition theorem the response that are voltage or current across any element is the algebrai...

Q: Problem8) Determine the signal space representation of the four signals są(1), k = 1, 2, 3, 4, shown...

A:

Q: Q1. Write down the nodal equations for all nodes. 34 20 ww 24 V 22 ww

A: A nodal analysis is a method that provides a common process for analyzing circuits using node voltag...

Q: 14.138. The MOS transistors in the circuit in Fig. 14.30(a) are replaced with npn transistors. What ...

A: Given the circuit, as shown below: The MOS transistors are replaced with NPN transistors. We need t...

Q: 21. Insulators have temperature co-efficient of resistance. * O positive zero O negative none of the...

A: Brief description : In semiconductor devices we have 3 type of materials such as conductor, insulato...

Q: E. Use this graphic for questions 14 and 15. V = 9 V R 100 R3 Vs2 12V R2

A:

Q: When checking a diode, low resistance readings both ways indicate the diode is: Select the correct r...

A:

Q: 8. Find Vo and Io. Show all work! 2 k2 6V 3 12 kO 3 4 k. Vo

A: Here in this question, we need to apply Kirchoff's current law and find the node voltages. After tha...

Q: 4 pole wave wound shunt generato delivers 195A at a terminal voltage of 205V. Ra and Rsh are 0.052 a...

A: Given that I=195ARa=0.05ΩRsh=70ΩVT=205V

Q: 5. A circuit is made up of 10 2resistance, 12 mH inductance and 281.5 µF capacitance in series. The ...

A: We need to find out current at different frequency for given RLC circuit

Q: If A = 3a, – ay – az B = –2ar + 4ay – 3az C = ar + 2ay – az find %3D - Match each item to a choice: ...

A: Unit vector parallel to 3A-2B+4C =0.9831ax-0.1735ay-0.0578az IA+B+Cl =7.3485 2A-B+3C = 11ax-2az I3A-...

Q: With respect to the a and b terminals, formulate an expression which is the equivalent resistance of...

A:

Q: FIND REq 24ko 24Kn 6kn 8kn 2kn Reg 34kn 4Kn 12Kn

A:

Q: Question 1: A single-tone conventional amplitude modulation (AM) signal is given by u(t) = cos(2n x ...

A:

Q: Two alternators A and B operates in parallel and supply a load of 10MW at 0.8 lag power factor. By a...

A: Find the total power to the load then from given data find the active and reactive power of each mac...

Q: b) For the arrangement shown in Figure 2 , determine: 2uF 2µF 2µF 2µF 2uF C 2µF C2 2uF 2µF 50 V Figu...

A:

Q: In your opinion, what happens to the rotor speed and current when mechanical load on an induction mo...

A: given induction motor.we have to calculate effect on rotor speed and current.

Q: In order for a measuring instrument to have less effect on the circuit, its input resistance Rin mus...

A:

Q: Derive the speed torque characteristics of induction motor from its equivalent circuit and also deri...

A: We have given the following problem

Q: Draw the output waveform 4 V +8 V 2.2 kn+ Si -S V

A:

Q: E, fov For the circuit showwn in figure,ind: D Totel current CIt)

A:

Q: What is the current through the diode? IDEAL_ DIODE R 12 kn 12 V Select the correct response: 0.942 ...

A:

Q: Find total impedance

A: In this question,  We need to determine the total impedance Z?  We know XL = wL  Xc = 1/wC  

Q: 43. Using Thevenin's theorem, find the current in 10 Q resistor in the circuit shown. * 40 Ω 60 Ω 12...

A:

Q: /www.thestudentsurvey.com/ The number of poles and the frequency of the applied voltage determine th...

A:

Q: Q2. Find Vo using Mesh Analysis. 12.5 A 82 ww 42 50 V 100 V ww

A:

Q: 39. Using branch current analysis, find the voltage drop across the 1 kN resistor in the figure show...

A: If we consider I1 as current flowing in the first loop in clockwise direction and I2 is the current ...

Q: A circuit consists of four resistors connected in parallel and connected to a 20-V source as shown. ...

A: Given, Available power ratings are 1/8, 1/4 , 1/2 , 1 ,2 watts The minimum power rating of each resi...

Q: ri = 3a, – 2ay + az r2 = 2a, – 4ay – 3a, r3 = -ax + 2ay + 2az Given Find the magnitudes of: Match ea...

A: Brief description : In the given question they have mentioned some vector fields of having position ...

Q: Find the electric field of a distance z above one end of a straight line segment of length L which c...

A: The given line segment is shown below:  The net electric field will have components of both the ele...

Q: A0.2-F capacitor has a voltage waveform v) as shown in Figure P3-5 Determane and plot as functions o...

A:

Q: Solve for the values of Vo and Id if diode is a ideal diode.

A:

Q: PR1 D1 A 1 + V1 R1 Vo 100V 20002

A:

Q: The result of capacitance C, = 6 microfarads and C2 connected in series is 3 microfarads. Capacitor ...

A:

Q: 11. Refer to the graphic C. Answer the following question. The circuit has a total current of 100 mA...

A: Given  Total power P=8W Total current i=100mA =0.1A  

Q: What is the purpose of creation of Republic Act 7920?

A: Public act- It is that branch of the law that governs the relationships between individuals and the ...

Q: ve ) Energy stored in the inductor and capacitor LH 15Ω 5Ω = C µF V

A: Given that V=18vI=8AL=26Hc=19F

Q: Q5) Design 4-16 decoder using 2-4 decoders

A: IMPLEMENTATION OF A 4-16 DECODER USING 2-4 DECODERS: The 2*4 Decoder contains 2 input lines & fo...

Q: What is the bandwidth of an oscilloscope with 17.5ns rise time? Can a 5MHZ square wave with 9 signif...

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.