A 54 conductors/phase single phase line has a GMR of 15.9mm and a GMD of 2.3m. The axial length is 50m. Calculate the total inductance of this single phase line. Ο 50 ΜΗ Ο 65 ΜΗ Ο 70 μΗ Ο 60 ΜΗ Ο 55 ΜΗ

Q: generator has maximum power of 60 MW, 60 HZ, efficiency of 50% and load factor of 0.4 .

A: Maximum power = 60 MW. Load factor = 0.4.

Q: 5. Find the range of K (K > 0) when the system is stable. 2.220 (Do not include marginally stability…

A: For the given system the value of K needs to be calculated for which the system is stable and the…

Q: A basic inverter with unidirectional switches is connected to a resistive load. The peak supply…

A: step-1-> The peak transistor and load currents are both equal to the peak supply current, which…

Q: What are the advantages of active load with respect to passive load in transistors? Write down at…

A: What are the advantages of active load with respect to passive load in transistors?

Q: Assume worst case SNR of a 10 bit ADC is 57 dB. If the resolution is increased by 2 bits, the…

A: Assume worst case SNR of a 10 bit ADC is 57 dB. If the resolution is increased by 2 bits,

Q: 2- Given the following two-degrees of freedom translational mechanical system, use the "by…

A: The transfer function of the given mechanical translational system needs to be calculated by using…

Q: a. If the refractive indices of medium 1 and 2 are n₁ = 1.54 and n₂ = 1.50, respectively, find the…

A: The critical angle can be calculated using Snell's law and the formula for the critical angle:…

Q: With reference to the diagram, explain how the ultrasound probe can be used to both generate and…

A: Solution: Determine : here explain given diagram for each part.

Q: Use K-map to minimize the following SOP expression: Q1) A'B'C'D'E' + A'B'CD'E' + A'BCD'E' +…

A: For the given minterms the simplified Boolean expression needs to be obtained by using k-map.

Q: For the frequency divider circuit the D-flip-flop is a CD4013 Dual D-Type flip-flop V2 is a square…

A: According to the question, for the frequency divider circuit the D-flip-flop is a CD4013 Dual D-Type…

Q: If a solar system battery is rated at a nominal capacity of 220Ah, how many hours can it be expected…

A:

Q: G2 ပင်းကြီး H1 (င)

A: For this block diagram we need to find  a) Reduce the blocks to canonical form b) open loop transfer…

Q: For an earth station transmitter with an antenna output power of 100 dBW, a back-off loss of 5 dB, a…

A: It is given that:   Antenna output power,PT =100 dBWback-off loss=5dBBranching and feeder loss=10…

Q: ? By using Current Divider Rule (CDR) find i1 & i2 + 11 12

A: The circuit is given that:

Q: A 400 MVA synchronous machine has H₁ = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two…

A: It is given that: H1=4.6 MJMVA ,S1=400 MVAH2=3.0 MJMVA ,S2=1200 MVASbase=100 MVA

Q: Assume Figure 2 is an ideal operating amplifier circuit. Show that the leftmost operational works as…

A: The leftmost circuit working needs to be analyzed and needs to prove it as a subtractor circuit.

Q: As an electrical and electronic engineer, your manager has asked you to write a report for the…

A: We need to write report on electric safety for different applications.

Q: What is condition-based maintenance? Explain the following two methods of condition monitoring in…

A: Step-1-> Condition-based maintenance (CBM) is a maintenance strategy that focuses on monitoring…

Q: A three-phase, star-connected, 7460 KW, 6000V, 50 Hz synchronous motor has a power factor of 0.8,…

A: The  rated output power of the motor will be, Psh=7460 KW The supply voltage, V=6000 V The supply…

Q: What is the dynamic resistance (in Ohms) of a diode if its ID = 4.99 mA? No need for a solution.…

A: Diode current ID=4.99 mA. Thermal voltage VT=26 mV.

Q: Two 10-bit ADCs, one of successive approximation type and other of single slope integrating type,…

A:

Q: A 79.4 transmission line has an effective dielectric constant of 6.4 (permeability is 1). Find the…

A: Given Data:-- C is the desired capacitance (1.6 pF = 1.6 × 10(-12) F)- εr is the effective…

Q: QUESTION 9 The type of pressure switch shown is 41 Movement Pressure Bourdon tube Bellows Selector…

A: here we need to identify the type of pressure switch

Q: 10. Determine the power density on an earth station from a 5-W satellite source. That is 22,000 mi…

A: Power of satellite source is 5W. Distance between satellite source and earth station is 22,000…

Q: For the circuit shown find the impedance phase angle Z (in degrees) i = 0.02 sin(157t+40) V=2547.4…

A: here we have to find the impedance phase angle

Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…

A: Critical frequency is given  fc=12.5 MHz Angle of incidence is given as, ϕ=65°

Q: A 34.5 KV STATION HAS A SHORT CIRCUIT IMPEDANCE OF AT GIVEN POINT OF O.21 PU BASE ON 100MVA…

A:

Q: Question 3: - The difference equation is: - y(n) - 0.4y(n-1) + 0.29y(n-2) = x(n) +0.5x(n-1) a. Find…

A: Given Difference equation : y(n)-0.4y(n-1)+0.29y(n-2)=x(n)+0.5x(n-1) To determine: Output y(n) for…

Q: TT TT TT -oblem: For the signal x(t) = 16cos(20πt + + 6cos(30nt + + 4cos(40nt +3) 6 the power…

A: A multi-tone signal x(t).

Q: 90 V +1 10 Ω Μ t = 0 + let ν 1 F 4Η

A:

Q: + 10322 vo- 1-) find 2-) find 102 www 201 3A vlx 1022 5% Ix with using Thevenin method 1x with using…

A: The above question is based on Thevenin's theorem and source transformation in DC circuits. The…

Q: 4.11 For the block diagram shown in figure 4.32a: a. Reduce the blocks to canonical form b. Specify…

A: For the given block diagram, the block diagram should be reduced to canonical form, Need to specify…

Q: B)Express the signal shown in below Xcn) 12 . . . . -11 -6-5 -4 -3 2 3 8495

A: From the above diagram:-X[-6]=12X[-5]=8X[-4]=4X[-3]=0X[-2]=3X[-1]=3X[0]=3X[1]=3X[2]=3and for any…

Q: Q1: Considering adders circuit with Look-ahead carry adder design, give expression for last carry…

A: Given: Adder's circuit with look-ahead carry adder design,  To find: Expression of last carry C4 in…

Q: 3. Why is the resonant frequency of a resonator discrete?

A: This type of device exhibits resonant behavior. It can naturally oscillate with some greater…

Q: ring distributor

A:

Q: • What is the magnitude of the voltage across the 10 resistor |VR|? Do not include units in your…

A: For the given circuit the voltage across the resistor needs to be calculated and the answer should…

Q: 4,6 R₁ AM Rr m 2,374 B

A: Given Data: A DC resistive circuit with, Input Battery voltages, V1=4.6 V V2=2.3 V To Find: The…

Q: A causal signal is given as x[n]= (0.5)". Find the discrete time Fourier transform (DTFT) of signal…

A: The above question is based on the properties of DTFT. Here note that since it is mentioned that…

Q: A 08 4092 20 Q 7 60 52 100) V 120 (2

A: here we have to find voltage (V) from the given circuit when voltage sources are acting.

Q: Given this question for PMDC motor 1) Write the equations of motion for the DC motor in time domain…

A: It is asked to determine the equations of motion for the DC motor in time domain and s-domain.

Q: 2. An electric train runs between two substations A and B 10 km apart maintained at voltages 600V…

A: We need to find out the distance for given track for given voltage.

Q: Question: A communication satellite is transmitting a signal to a ground station on Earth. The…

A: Given data: Frequency (f) = 10 GHz = 10,000 MHz Transmit power (Pt) = 50 watts Distance (d) =…

Q: 2- Given the following two-degrees of freedom translational mechanical system, use the "by…

A: The transfer function of the given mechanical translational system needs to be calculated by using…

Q: (a) After the switch is first thrown to a (connecting the battery), what time interval elapses…

A: For the given RL circuit the value of time required to reach 220mA, Value of current at t-10s and…

Q: 3. Voltage-Divider Bias Configuration +20V 오 $250ka Is lloke Determine: ftc 700-2 Q V $12515452 IB,…

A:

Q: Final answer is already given in the given photo below so just kindly provide a COMPLETE and CLEAR…

A: Cs=9ss2+2s+9

Q: The phase angle of the current with respect to the voltage in the circuit shown in Figure 38 is A…

A: Given circuit diagram is,

Q: 1) f(x, y, z) =? Zx + zy 1x2 DEMUX 0 2x4 DECODER 0 1 2 3 f(x, y, z)

A: In this question We need to determine the output function f(x, y, z) as shown the circuit.

Q: A sine wave has a maximum value of 10 V. Its value at 450 is 450 V Q 14.14 VO 7.07 VO 4.5 VO

A: Maximum value of sin wave Am=10 V. Angle θ=450.

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.