QUESTION 9 The type of pressure switch shown is 41 Movement Pressure Bourdon tube Bellows Selector Diaphragm
Q: 1. Calculate the power dissipated by the voltmeter and by resistor R when (a) R=3002 and (b) R=3M2.…
A: The sensitivity of the voltmeter, S=12 KΩ/V The full-scale deflection of the voltmeter, fsd=200 V…
Q: iFor the Circuit Below: 3Ω V2 = 4Ω V₁ Τ I₁ 1₂` 3Ω ΤΩ ΤΩ IF (I=10/90°)and (I,=5/30°) Find the Nodal…
A: In this question We need to determine the node voltage as shown the circuit. We are solving this…
Q: In order to reduce the loading effect in a transistor,we include Coupling Capacitor Re Rs Byepass…
A: In order to reduce the loading effect in a transistor,we include:-
Q: Question: A communication satellite is transmitting a signal to a ground station on Earth. The…
A: here we have to find the received power and SNR at the receiver.Given information is Frequency f=10…
Q: Find I1 and I2.
A: For the given magnetically coupled circuit the value of unknown current I1 and I2 needs to be…
Q: wave for T-L Connected to th Bo Example 5 Find the impedance and standing Load ZR as a) ZR 23 Zo__b)…
A: Step-1-> a) ZR=3Zo when ZR = 3Zo, the impedance seen at the load is 3 times the characteristic…
Q: A delta-connected, balanced three-phase load consisting of three impedances of 25 ohms 30 degrees is…
A:
Q: 9 9 C(s) > = (²-) ( ₁² + ² 5 + 9) = s(s+ 7.854)(s + 1.146) system poles = [−7.854, −1.146] c(t) = 1…
A: C(s)=(1/S)(9/s2+9s+9) C(s)=9/S(S2+9S+9) C(s)=9/S(S+7.854)(S+1.146) System poles, S=0 , S=-7.854 ,…
Q: A series motor runs at 700 rev/min when the voltage is 300 V and the current is 20 A. The armature…
A: Initial speed of motor N1=700 rpm. Initial terminal voltage V1=300 V. Armature current Ia=20 A.…
Q: Consider the first order RC circuit shown in Figure 1. With v.(1) being a symmetrical square-wave…
A: The electrical circuit is given as The waveform of the supply voltage is given as We need to…
Q: Problem 4 Controllability and Observability Consider the following continuous-time state space…
A: For the given state space model of the system, the system is whether controllable and observable…
Q: Question2: Given the sequence h(k) 2, 1, 0 for k = 0, 1, 2 for k = 3,4 elsewhere, where k is the…
A: here we have to draw the sequence of hk,h-k,h-k+2,h-k-3.
Q: nodal Analysis prob 3 find V, at mode n1, V₂ at node n₂
A: For the given circuit the value of node voltage V1 and V2 needs to be calculated by using the nodal…
Q: Question 2. Equivalent circuit parameters of a three-phase, 2P=6-pole 50 Hz, 2400 V, 950 rpm stator…
A: Pole, P=6 frequency, f=50 Hz Rotor speed= Nr=950 rpm Supply line voltage, Vl=2400 V Synchronous…
Q: For V1=10, and R1=220 the series diode configuration of the figure shown below, determine Vp, R. and…
A:
Q: Using a d.c. voltmeter and a.c. voltmeter to measure the output filter of a power supply, the obtain…
A: Output voltage measured by using DC voltmeter VO-dc=25 V. Output voltage measured by using AC…
Q: Given the circuit below. Using 20kVbase and Sbase=100MVA in the generator circuit, compute and draw…
A:
Q: Find the RMS value of V)-100 sin(377t+76) V
A: The voltage value is, Vt=100SIn377t+76 V
Q: Calculate gain in each of the circuit below.
A: For the given circuit the value of gain needs to be calculated.
Q: The following figure shows the cross-section structure of a 4/2 pole variable reluctance motor with…
A: Solution: Given Data: D=13 cm g=0.254 mm R=3.8 cm α=60(degree) β=45(degree) N=100 turns…
Q: value of currents
A:
Q: The switch in the circuit shown has been in position a for a long time. At t= 0, the switch is moved…
A: For the given circuit the value of current flowing through the inductor needs to be calculated for…
Q: √n²+2 Q1: let the sequence x(n)= 1 + 2n 0 3≤n≤4 -1≤n≤0 other wise 1-y₁(n)= 2x(2n+2)_2-y₂(n)=…
A:
Q: A separately excited 300 V DC shunt motor under no load runs at 900 rpm drawing an armature current…
A: 300 V DC shunt motor under no load- Speed N1=900 rpm, Armature current Ia1 =2 A, Armature…
Q: For the frequency divider circuit the D-flip-flop is a CD4013 Dual D-Type flip-flop V2 is a square…
A: According to the question, for the frequency divider circuit the D-flip-flop is a CD4013 Dual D-Type…
Q: A 2 pole, 50 Hz, 13.8 kV, 10 MVA, start connected synchronous generator achieves the rated…
A:
Q: Q6: Find the counting sequence for the following modified Ring/Johnson counter if initial…
A: Given: A logic circuit diagram of a modified Ring/Johnson counter, To find: Counting sequence if…
Q: motor vehicle a/c system using r-12 have flared threaded service ports. service fitting on systems…
A: Step-1-> motor vehicle a/c system using r-12 have flared threaded service ports. service fitting…
Q: 2kIx 14 zk 2x Nodal Analysis Probz Vz IX → 1) АМА T 0.5k find V₁, V₂ (node 1 & mode 2) Io, Ix
A:
Q: Find the phase angle between i₁ = -4sin(377t +25°) and 1₂ = 5cos(377† -40°). Does i, lead or lag i2?…
A: Given: Current equations, i1=-4 sin377t+25°,i2=5 cos377t-40°, To find: Does i1 lead or lag i2?
Q: A 460 V, 50 kW, 50 Hz, three-phase synchronous motor has a synchronous reactance of Xs = 4.15 Ω and…
A: VL = 460 Vf = 50HzP = 50 KwXs = 4.15 ΩLaf = 83 mHPin = 40 Kw
Q: Question: A communication satellite is transmitting a signal to a ground station on Earth. The…
A: Transmitter Power Pt = 50 watts, Satellite Antenna Gain Gt = 30 dB, Ground Station Antenna Gain Gr =…
Q: Which resistor would the smallest current flowing? E Hillli Ο 25 Ohm O 75 Ohm 100 Ohm Ο Ο 10 Ohm…
A:
Q: p-n junction diode at 25 temperature degree with reverse saturation current of 10-⁹ A
A: Temperature reverse saturation current and diode current is given as, T=250CI0=10-9AID=1A
Q: Electromagnetics: A magnetic ring has a mean radius of 6 cm, a cross sectional area of 5 cm² and an…
A:
Q: The power output from steam turbine shown below is 500 kW when the steam flow rate is 1.4 kg/s. The…
A: m=1.4 kg/sW=500 kwh1=3033 kj/kgh2=2653 kj/kg
Q: Find power dissipated across R1 in mW V₁=8,8Volts, and R₁ =5,4k V1 Si Ge R1
A: V1=8.8 V, R1=5.4 kΩ. Given circuit diagram is,
Q: Use K-map to minimize the following SOP expression: Q1) A'B'C'D'E' + A'B'CD'E' + A'BCD'E' +…
A: For the given minterms the simplified Boolean expression needs to be obtained by using k-map.
Q: iiFor the Circuit Below: V₁ 13 = 3Ω ΖΩ γγγγγ E₁ 4Ω I I V₂ 3Ω ΤΩ ΤΩ Μ ΖΩ > 3Ω 4Ω V3 son IF…
A: In this question We need to determine the loop currents as shown the circuit. We are solving this…
Q: A causal signal is given as x[n]= (0.5)". Find the discrete time Fourier transform (DTFT) of signal…
A: The above question is based on the properties of DTFT. Here note that since it is mentioned that…
Q: The admittance for an inductor L is: elect one: O a. (SL) 2-¹ b. 1/(SL) H C. (SL) H d. 1/(SL) 2-¹
A:
Q: Implement the following Boolean function using a (1) multiplexer, (2) then using a decoder and…
A: Need to implement the given boolean function using the multiplexer and decoder along with OR gate.
Q: A basic inverter with unidirectional switches is connected to a resistive load. The peak supply…
A: step-1-> The peak transistor and load currents are both equal to the peak supply current, which…
Q: Explain how the wind turbine works
A: Wind Turbine:- The contemporary equivalent of a windmill is a wind turbine. Simply said, they…
Q: Initially uncharged four capacitors are connected as shown in the Figure. Here, V₁ = 38,4 V, V₁ =…
A: Va = 38.4 VVb = 17.2 VC1 = 14 μFC2 = 35 μFC3 = 28 μF C4 = 7 μF
Q: 1. Given a ferrite material that we shall specify to be operating in a linear mode with B = 0.05 T,…
A:
Q: The resistivity of a uniformly doped n-type silicon sample is 0.50 - mc. If the electron mobility…
A: ρ=0.5 ,μn=1250 cm2/V-sec,q=1.6×10-19 Coulomb. The donor impurity concentration is required?
Q: Find the equivalent resistance between A and B?
A: Circuit diagram is given as,
Q: Figure below shows one-line diagram of a simple three bus power system with generation at bus 1. Bus…
A: V1= 1 pu V20 = 1+ j 0 V30 = 1+ j 0 Power at bus 2 are P2 =250 MW Q 2 =110 MVAR Power at bus 3 are…
Q: 6.32 The four capacitors in the circuit in Fig. P6.32 are con- nected across the terminals of a…
A: “Since you have posted a question with multiple sub parts,we will provide the solution only to the…
Trending now
This is a popular solution!
Step by step
Solved in 3 steps
- Fill in the blanks: Given the model for position control system, find the value for K1 and K2 so that the peak time is equal to 0.5 s and the %OS is equal to 3%. K1= 93.2070 K2= 0.129 I 446 23What is the voltage across the plates of capacitor #1 (C1)? Select one: a. 6.36 volts b. 2.71 volts c. 5.65 volts d. 7.32 voltsDesign a clamper to perform the function indicated
- Question 15 Resistors are examples of Select one: O a. O b. O c. O d. O e. ..electronics device. pyroelectric optical piezoelectric passive activeIn an energy meter, creep speed is the speed of the aluminium disc's at O a. Full load condition O b. Over load condition O c. Half load condition O d. None of the above1. What happened if the DC voltage in the clamping circuit is replaced by an a.c source?
- B- compare ( in 5 point only) between a dArsonval move Electrodynamometer. a dArsonval movement Electrodynamometer 1 2 3 4 5A snubber protection circuit has snubber time constant (5msec), voltage source (5kV), discharge current of Thyristor (2µA), frequency (50HZ) and resistive load 50. Find the rate of voltage changing with the time and snubber circuit power losses?Explain the operation of a full subtractor with necessary diagrams. What is the differencebetween half and full subtractor?
- A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?8. The standard measurement data table of a thermocouple is developed when the thermocouple's reference temperature is at (a) non-zero degree in Celsius (b) zero degree in Fahrenheit (c) zero degree in CelsiusSubject Electronics need answers