A 46-mH inductive coil has a resistance of 10 ohms. How much current will it draw if connected across a 100-V 60-Hz source? 11.66-j9 3-j5 3-j4 5 cis -60

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of SF6 Circuit Breaker. Plea...

A: It is asked to draw the diagram and to explain the construction, operation, advantages and disadvant...

Q: Rea (2) -R (3) 을 (4) 극R (1) (5) R (6) R (7) R (8) R (9) R (10) 9R RI

A: Brief description : Resistor is an electrical element which is used to limit the amount of flow of c...

Q: 12. A power signal x(t) with no signal power outside the frequency range - fe/100 < f < fe/100 is mu...

A:

Q: Problem 24: Use mesh analysis, find the currents flow through each voltage source. R1 R3 Rs 3Ω 10 V ...

A:

Q: The cost of a single phase overhead feeder is OMR 7 a per km ( a is area of cross section in sq mm) ...

A: It is given that: For 1m of length and 1mm2 cross-section area of conductor,Resistance=162Ωcost of s...

Q: 3. Determine: Branch currents and power in each resistor Kirchhoff's Laws

A: Apply KVL in loop 1-20+5i1+3i1-i2+5=08i1-3i2=15 ...... (1)Apply KVL in loop 24i2-5+2i2-i3-5-5+3i2-i1...

Q: What is a long tail pair in amplifier?

A: The differential amplifier is commonly used with a two-transistor circuit known as long-tail pair, i...

Q: Problem 8. You are given a MOSCap consisting of a W metal electrode, SiO2 as an oxide, and p-type Si...

A:

Q: 2. For the circuit shown in Fig. (6), if the value of R1=1KQ, with tolerance=±5%, and R2= 2.2KQ, wit...

A: “Since the first question looks incomplete, we will solve the second question for you. "  

Q: A resistor and an inductor a

A:

Q: . Suppose you have an NMOS transistor with a threshold voltage of 1 V.  You apply 3 V to the gate, g...

A:

Q: Jury' method.

A:

Q: Consider the loop transfer function L(s)= G.(s)G(s) = Consider the phase margin is -80°. Determine t...

A: Given the loop transfer function, Ls=GcsGs=Ks+8s2 Phase margin = -80°

Q: A control system is given as in Figure Q1. Calculate the steady state error if the input is: a) Unit...

A:

Q: 8. A coil has a resistance of 24 Ω at 50°C and 32 Ω at 120°C. Find the resistance at 0°C and the tem...

A: Given that, At t=50°C,Resistance, R=24ΩAt t= 120°C,Resistance, R=32Ω

Q: Situation: An SUV is parked along the side of a roadway, while a van is traveling adjacent to the SU...

A: For SUV -The initial velocity is zero.The acceleration is a and total time taken is T.For van - The ...

Q: j162 j40 2g j40 2 24 2 DO V/30 キーji2 j4 2 =-0 -j10 2= j9 2 10Ω 32 82 ee

A:

Q: 4. For the NOR gate function shown below A Da B. Do a) Write the switching expression for the output...

A:

Q: 7. Prove using Boolean algebra that the circuit drawn in figure (2-6-b) is an XOR gate. F2 U2c U2d U...

A: Brief description :  Universal gates are  1.NAND gates  2.NOR gates  Basic gates are as follows 1.OR...

Q: The following data were obtained from a short-circuit test performed upon a 50 kVA, 2300/115 V, 60 H...

A:

Q: 2. Determine the admittance Y for the circuit in Fig. 1.30.

A:

Q: 4. The Silicon semiconductor (doped with 3 donor atoms per 6x10° si atoms) is subjected to a 300 deg...

A:

Q: Problem 1 What elevation or height of a column of mercury will cause a pressure of 667.08 kPag?

A: Given, Gauge pressure (Pg) = 667.08kPag i.e kilo Pascal gauge  

Q: What is your understanding about capacitors and inductors at steady state.

A:

Q: *11. Find Vs for the network of Fig. 7.84. 20 V 2.2 k2 Ipss = 4.5 mA Vps Vp =-5 V I ss = 6 mA Vp = -...

A:

Q: If admittance Y = 0.06 – j0.08 siemens, the conductance G equals

A:

Q: Convert to integral form. Use either Gauss or Stokes theorem V × F = x

A:

Q: The subtransient reactance of a generator is typically much larger than the steady-state reactance. ...

A: 1 ) generally the subtrasient  response of a generator is larger than the steady state reactance. So...

Q: 3. At a certain temperature, the velocity of electrons in an intrinsic silicon material is 120m/s. T...

A:

Q: The following data were obtained when a 25 kVA, 2300/460 V, 50 Hz transformer was subjected to open-...

A:

Q: A coil of resistance of 15 ohms and inductance 0.05 H is connected in parallel with a non-inductive ...

A:

Q: Solve for all currents values though and voltage across each resistor

A:

Q: What is the equivalent resistance across the voltage source Vs in the circuit? Please explain thank ...

A:

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of Vacuum Circuit Breaker. P...

A: It is asked to to draw the diagram and explain the construction, operation, advantages and disadvant...

Q: 2. A 3-phase delta connected alternator supplies a wye connected load, each phase of which has a res...

A:

Q: This code sorts the decimal places of a number consisting of ones, tens and hundreds, for example, w...

A: The code for sorting of decimal places of a number consisting of one's, tens and hundreds: X= hundre...

Q: H.W. For the circuit shown below, calculate the value ofRL which absorbs maximum power and then calc...

A:

Q: What are the expected readings of the following in the figure below? (R640 0, Av7.00 V) R. AV 10.0 0...

A:

Q: A coil of 50 ohm resistance and of 150 mH inductance is connected in parallel with a 50 micro-farad ...

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines o...

Q: 2. What is the process of converting a signal from a given rate to a different rate? a) Sampling b) ...

A:

Q: What type of fault is two phase to ground fault in power system.(Symmetrical or Unsymmetrical). Disc...

A: Two phase to ground fault is also known as double line to ground fault this fault is unsymmetrical i...

Q: Five resistors are connected in parallel. Compute for the (a) total resistance, (b) current flowing ...

A: Given, Five resistors are connected in parallel R1=10 Ω;R2=20 Ω;R3=30 Ω;R4=40 Ω;R5=50 Ω; V= 220 V  

Q: Two 1-phase transformers A and B rated at 250 kVA each are operated in parallel on both sides. Perce...

A:

Q: Set up and solve this circuit problem, with V1 = 45 volts, V2 = 126 volts. I = amperes I2 = amperes ...

A: Given, V1=45 VV2=126 V  

Q: 1. What is the difference between Miswire and short in the cabling?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source, eithe...

Q: Explain Transducer classification adding EXAMPLE to each category. Note: Please do not handwritten.

A: Classification of Transducers The Transducers Can be classified based On a) The principle of Transdu...

Q: A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical po...

A:

Q: OR gate with a small circle on the output gives the symbol of a O a. EX-NOR O b. NOT O c. EX-OR O d....

A: output of OR gate is equal to sum of the inputs  Let input be X and Y then output of OR gate is X+Y ...

Q: A load of 1250 KW is connected at the receiving end of a 3 phase transmission line 70 km long. The p...

A:

Q: Find the overall gain or attenuation of the cascaded circuits in decibels (dB) if the individual cir...

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.