A 1550-nm single-mode digital fiber optic link needs to operate at 622 Mb/s over 80 km without amplifiers. A single-mode InGaAsP laser launches an average optical power of 13 dBm into the fiber. The fiber has a loss of 0.35 dB/km, and there is a splice with a loss of 0.1 dB every kilometer. The coupling loss at the receiver is 0.5 dB, and the receiver uses an InGaAs APD with a sensitivity of -39 dBm. Excess-noise penalties are predicted to be 1.5 dB. Set up an optical power budget for this link and find the system margin. What is the system margin at 2.5 Gb/s with an APD sensitivity of –31 dBm?

A 1550-nm single-mode digital fiber optic link needs to operate at 622 Mb/s over 80 km without amplifiers. A single-mode InGaAsP laser launches an average optical power of 13 dBm into the fiber. The fiber has a loss of 0.35 dB/km, and there is a splice with a loss of 0.1 dB every kilometer. The coupling loss at the receiver is 0.5 dB, and the receiver uses an InGaAs APD with a sensitivity of -39 dBm. Excess-noise penalties are predicted to be 1.5 dB. Set up an optical power budget for this link and find the system margin. What is the system margin at 2.5 Gb/s with an APD sensitivity of –31 dBm?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In GSM900, the uplink frequencies from 89OMHZ to 915MHZ are divided into 125 channel with 200KHZ each using O CDMA O FDMA O TDMA O WDM
What are the important mechanisms that are responsible for scattering losses in optical fibre
In a BJT, the value of IC=188mA and IB=0.054mA. Solve for IE in mA.
Ifa material is having a band gap of 1.42eV, then this material will produce a photon output at the wavelength of A 0.774 μm B с 0.2μm 0.873 μm D 0.72μm
Ifa material is having a band gap of 1.42eV, then this material will produce a photon output at the wavelength of A 0.774 μm B с 0.2μm 0.873 μm D 0.72μm
Number of output pins in IC74153. Options A-1 B-2 C-3 D-4
An sis filled plaucar fine wia += 3mm Rás conducting S/m-Calenlate R,L at 00 MHz. W= 30cm,d = 1,2 cm. plates with = 7X10
Estimate the VSWR if the reflection coefficient is 0.5
In normal-phase TLC, a compound with a Rf value of 0.7 is _______ polar than a compound with a Rf value of 0.4 a. More b. Less
Q2) What is the ratio of the maximum radiation intensity to the average * ?radiation intensity Directivity gain O Aperture gain O Power gain O Transmission gain O
If the reflection coefficient is 0.75, estimate the return loss for the device
Solve for the (a) total resistance and (b) total current of a 40 V ac voltage, with 100 Hz frequency, connected to resistors shown in the figure. Calculate for the (c) period, (d) wavelength, (e) VM, (f) IM, (g) VP-P, (h) IP-P, (i) VAVE, and (j) IAVE