If the reflection coefficient is 0.75, estimate the return loss for the device
Q: Variations in signal strength that may occur at the receiver over a period of time is called
A: Correct answer is FADING Fading is defined as the variations in signal strength at receiver end.
Q: Which of the following does not belong to the group? Solar radiation Fluorescent White…
A: Energy : Energy is inversely proportional to wavelength and wavelength is inversely proportional to…
Q: The radar in which both transmission and ception is done using the same antenna are called:
A: The solution is provided in the following section.
Q: The return loss of a device is found to be 30 dB. What will be the value of the voltage standing…
A: Given: The return loss of a device is RL=30 dB. The value of the voltage standing wave ratio (VSWR)…
Q: Calculate the length of a twisted pair cable, the dielectric constant is 2.6 and the measured time…
A:
Q: A 2.28-cm by 1.01-cm waveguide is filled with a dielectric material with er = 2.25. The…
A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…
Q: 6. The most effect that atmosphere can have on solar radiation is by B and C C) Transmission anr…
A: Choose the correct option The most effect that atmosphere can have on solar radiation is by...
Q: Radio interference can be reduced by employing DC transmission as it reduces the at ..... the…
A: In this question we will find how radio interference reduce in dc transmission..
Q: The wavelength of an electron exist in a stable orbit n3D1 is equal to
A:
Q: Q1/ What are the conditions for total internal reflection?
A: Given : Brief introduction: Total internal reflection is a property of a light. Whenever…
Q: Radio interference can be reduced by employing DC transmission as it reduces the at the conductor…
A: Radio interference of DC transmission lines will decrease with humidity and increase with…
Q: 1. Which of the component of IM is usually fabricated out of silicon steel?
A: As per the honour code I will answer only the first question. Kindly repost the other questions…
Q: Electromagnetic waves are
A: Transverse wave is a wave whose oscillations are perpendicular to the direction of the wave's…
Q: If I have a light source at 850nm, what type of detector (s) can work for me? If there is more than…
A: An optital detector turns light impulses into electrical signals that can be amplified and…
Q: An AM transmitter is rated 1 kW at 100 % modulation. What must be its rating at no modulation?
A: The solution can be achieved as follows.
Q: What is radio transmitter and what is used?
A: TRANSMITTER Transmitter is the device that send to information one place to another place. It…
Q: Please explain the waveforms, what are the reason why does the 3rd waveform is attenuated. 1st…
A: An electrical waveform is basically a visual representation of the variation of voltage or current…
Q: What is the purpose of the cladding layer in an optical fiber
A: An optical fiber consists of two layers: 1. Core 2. Cladding
Q: Determine NA and acceptance angle in air for silica optical fiber given the cladding refractive…
A: Numerical aperature NA=n12-n22where n1=Refrative indx of core n2=Refrative index of…
Q: The distance difference between propagated rays in an optical fiber cable should be a. Integer…
A: In this we will see the distance difference in optical fiber cable...
Q: What is the difference between majority charge carrier and minority charge carrier?
A: Semiconductors have two types of charge carriers - electrons and holes. Electrons are negatively…
Q: Explain the meaning of standing wave; show how the reflection coefficient can be measured in…
A: Standing waves are produced in the transmission line during the interference of the incident and the…
Q: Loss tangent is a standard measure of lossiness in a dielectric which is typically used to classify…
A:
Q: If reflection coefficient for voltage be 0.6, the voltage standing wave ratio (VSWR) is?
A: Given, Reflection coefficient, ρ=0.6
Q: Q2: What is the difference between continues and characteristics x-ray spectrum?
A: The differences between the continuous x-ray spectrum and the characteristics x-ray spectrum are…
Q: What is the typical value of refractive index for an ethyl alcohol?
A: The correct option along with the explanation is provided in the following section.
Q: a. What is meant by transmittive cell type in LCD construction
A: According to guidelines we need to solve only the first question. According to the question, we need…
Q: Design a single PRF for speed detection radar to detect the both the speeds that is below 40, and…
A: According to the question we have Design a single PRF for speed detection radar to detect both the…
Q: How does the refractive index differ with applied electromagnetic radiation?
A: REFRACTIVE INDEX; The refractive index shows how much the path of light got bent or refracted when…
Q: Draw the energy band structure of a conductor and a semiconductor material.
A:
Q: 1. Explain the Beam radiation and diffusive radiation with necessary diagram.
A: Beam radiation is the solar radiation received from the Sun without having been scattered by the…
Q: power of 750 W. How much power is added to the signal when the transmitter is 100 percent
A:
Q: Explain in detail the reflection and standing wave phenomenon on a transmission line.
A: If the impedance of transmission line i.e. characteristic impedance doesn't matches with the load…
Q: What is the difference between the original Smith chart and the immittance chart? What are the…
A: The difference between the original smith chart and the immittance chart is explained in the table…
Q: Explain the Beam radiation and diffusive radiation with necessary diagram.
A: Beam radiation is the solar radiation received from the Sun without having been scattered by the…
Q: The cathode current increased by 4 times and the voltage between cathode and anode decreased by 4…
A:
Q: What are the important mechanisms that are responsible for scattering losses in optical fibre
A: What is an Optical Fiber? Optical fiber is the technology associated with data transmission using…
Q: Explain the Beam radiation and diffusive radiation with necessary diagram.
A: Beam radiation is the solar radiation received from the Sun without having been scattered by the…
Q: Approximately, what is the percent shimmer for the following signal? 0.25 0.32 0.18 0.34 0.25
A: Answer - Shimmer% can be calculated as follows
Q: The reflection coefficient for a device is found to be 0.75. What will be the corresponding return…
A: The return loss (RL) of a device can be computed from the reflection coefficient using the following…
Q: Give different benefits and risks of electromagnetic radiation.
A: Electromagnetic radiation's advantages and disadvantages are given below: 1. Cosmic beams,…
Q: Q2) What is the ratio of the maximum radiation intensity to the average * ?radiation intensity…
A: 2) The ratio of the maximum radiation intensity to the average radiation intensity is known as the…
Q: Which of the following is not used for communications? Select the correct response: A. X-rays B.…
A: In this we will write which way is not used for communication...
Q: The segment length for fiber optic cable
A: In this question we will write segment length for fibre optic cable ...
Q: What would be the depth of penetration for copper at 2 MHz frequency with o = 5.8 x 107? %3D
A:
Q: Reluctance of an air gap if gap length is 1 mm and the apparent air gap cross-sectional area is 0.05…
A: Given values are - Air gap lengthL=1mm=1×10-3mCross sectional areaA=0.05m2
Q: B) Calculate the reflection coefficient of the cavity reflectors for semiconductor laser with 500µm…
A: For the given values of threshold gain and attenuation gain we need to calculate reflection…
Q: Which measurement should be used to locate problems in non-operational fiber? A. OSA B. OTDR C. ORL…
A: Answer: OTDR Explanation: A. OSA It is not a valid option. This method is used to measure the…
Q: For an electromagnetic system, what will be the return loss if the reflection coefficient is 0.5?
A:
If the reflection coefficient is 0.75, estimate the return loss for the device
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- The reflection coefficient for a device is found to be 0.75. What will be the corresponding return loss of the device?A voltage reflection coefficient is measured as 0.75 , and the correspondingload voltage is 1 V. Determine (a) the incident voltage component at the load , (b) the reflected voltage component at the load , and (c) the current reflection coefficientis the simplest way of producing a source of lower EME from a source of higher EMF.
- The cathode of a device is generally marked, it is indicative of:a. The positive terminal of the device b. The negative terminal of the device c. The type component d. None of the aboveThe wave power per length is 1407 W/m, the device-width of the wave energy system is 7.5 m, the capture width ratio is 0.4, the rated power is 12772 W. Determine the percentage degree of utilization. 29.74 28.09 33.05 O 36.35For C.B. configuration BJT, if VEE=4V, and RE-1.2k, the IE is 4.3 mA О 3.33 mA 0000 Zero ○ 2.75 mA