8- If air content and degree of saturation are represented as ae and S respectuvery,then the relationship between them isA) a, =B) a, = 1-sC)S = 1+ a.D) S = ae9- In wet soil mass, air occupies one-seventh of its volume and water occupies one-eighth of its volume the void ratio of soil isA) 0.25The relationship between Ysat , Ggand e isB) 0.36C) 0.43D) I10-A) Ysat1+eB) Ysat(G-e)yw1teC) Ysat(Gy+e)yw1+e(Gte)D) YsatThe relationship between ysat Ya. Y and S isA) y = Ya SlYsat - YalB) y =1te11-S[Yrat-YalC) y = Ya + S[Ysut -YalD) y = Ya - S[Ysat - Yal

We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Answered: 8- If air content and degree of…

8- If air content and degree of saturation are represented as ac and S respectivery then the relationship between them is A) a, = B) ae = 1-S C) S 1+a D) S = ae

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: QUESTION 12 Ordinary air temperatures given e.g. by weather forecasts refer to "dry-bulb"…

A: Some statements related to material properties.

Q: X-component of velocity in two dimensional incompressible flow is given by u = 2y² + 6xy. If the…

A: Given data- X-component of velocity in 2-D incompressible flow- u=2y2+6xy, Y-component of velocity v…

Q: water goes through the water cycle again and again, the amount of water on Eart A- Increases. C-…

A: 1. C stays the same 2. A Decreases with higher altitudes 3. D Rainfall 4. C Evaporation,…

Q: By constructing flownets for the section shown in Figure, plot a curve explained the relation…

A: A flow net is generally a graphical representation of two-dimensional and also the steady-state…

Q: pt 1 Submit y=fax) Ms, Mix 2. (25 pts) A particle is launched from point A with an initial angle of…

Q: From the given figure which of the following is/are correct? a. DFAB = DFCB b. FEMAB = FEMBA c. DFBA…

A: For given figure

Q: g of compression, pressure is 98 KPaa and temperature = 30 deg C, volume is 0.046 cu. At the…

Q: 1. In undisturbed air stream, where the pressure is 14.7 psi and density is 101325Pa, where the…

Q: Stress analysis Task Question / Calculate the critical design loads applied to the Stirling Engine…

A: Please find the answer in the below attachments

Q: From the given figure which of the following is/are correct? a. DFAB = DFCB b. FEMAB = FEMBA c. DFBA…

Q: Oil (sg=0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

Q: 5. A slab of concrete used in highway construction is set in place when the ambient temperature is…

A: The given data is: Ambient temperature=20 °C Length of slab, L=20.478 m Maximum temperature=55 °C…

Q: Oil (sg=0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

Q: After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of…

A: Depth upto which SAE oil is filled in a glass to make it float on water = d , Specific Gravity og…

Q: The standard value of atmospheric pressure at sea level is: Patm (sea level) = 1.000 atm = 101.3 kPa…

A: Given:Required:Denver's atmospheric pressure in atm

Q: 18. If the soil is dry, DPC for ground floor consists of the layer of: A. O Metal B. O Coarse Sand…

A: A damp-proof course (DPC) is a barrier installed in a structure to prevent moisture from rising by…

Q: The volume of atmosphere moisture is 12900 km3 and the flow rate of precipitation is 577000 km³/yr.…

Q: Oil (sg=0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

Q: Derive the relation for adiabatic compressibility for ideal gas.

A: Here is the proof for adiabatic compressibility for ideal gas

Q: The standard value of atmospheric pressure at sea level is: Patm (sea level) = 1.000 atm = 101.3 kPa…

Q: Calculate the total heat loss from a house measures L×w in plan. The height of walls is H. The house…

A: Floor area=Roof area=L×B=13×26=338 m2Volume of building =A×h=338×4.33=1463.54 m3Total external wall…

Q: A 50-m steel has an error of 0.04 m at 20°C with a pull of 50 N. A rectangular lot is measured using…

A: The sign of correction is opposite to that of error. Calculate the correct length and correct width.…

Q: At 25°C air temperature, the saturation vapor pressure at some temperature of water (no specified…

Q: Oil (sg-0.87) flows from A to E as shown. The head loss is assumed to be as follows: A to B = 0.45…

A: Given data: B to D diameter = 18in D to E diameter = 8in

Q: of particulate matter left in soluthon during a filtering pro p(n)=400(2)-0.4n, where nis then ps.…

A: This question is related to Filtration from Environment Engineering from Civil Engineering. In this…

Q: Which of the following equations is the Hazen-Williams equation for calculating energy loss due to…

Q: all expressed as CaCO3. Determine the chemical dosages required to soften this water as much as…

Q: Define adiabatic saturation temperature.

A: Adiabatic saturation temperature:

Q: If the viscosity of a certain liquid of water is 24,054 poise and its specific weight is 16,537.31…

A: Given data in question Dynamic viscosity Specific weight To find out Kinematic viscosity

Q: FORMULA: The formula for calculating the water content for Plastic limits is as follows: W1 – W2…

Q: Determine the thermal resistance R′ and the R-value for the glass window ofThe thermal resistance R′…

A: Given data: Glass. H=1 m B= 1.8 m L= 8 mm=0.008 m

Q: mine the friction factor for water flowing at a rate of 1 cfs in a cast iron pipe 2 inches in ter at…

A: The problem is based on calculation of Reynolds number and reading of Moody chart corresponding to…

Q: An air conditioner cools humid air at temperature t₁ = 25°C and relative humidity 1 = 70% to…

A: To solve this problem, we can use the psychrometric chart, which shows the properties of moist air,…

Q: Solve the heat equation ut=cuxx on the domaion 0≤x≤2, t>0 subject to u(x,0)=x(x−2),…

A: The objective of the question is to solve the heat equation ut = cuxx on the given domain and…

Q: Part 4: Water Treatment 1. • Boiling is a physical process that can remove total hardness [] • In…

A: 1. FALSE Boiling water only removes the temporary hardness present in the water and not the…

Q: F i n d t h e r e s u l t a n t o f t h e f o r c e s y s t e m s h o w n . P=281…

Q: 12" Gage B Oil SG=0.92 Water 8" Gage A H Hg SG=13.6

Q: Solve step by step

A: To calculate the gas formation volume factor (Bwg) at 2360 psig and 204°F, we'll need to follow…

Q: H h 100 mm diam t. S.g. = 1.20 1

A: Using Bernoulli equation

Q: If a soap bubble has to sustain an absolute pressure of 101.35 kPa with its diameter being 25 mm…

Q: The distance of the flag pole to the campus grounds was recorded as 440.37 m. A 50-m steel tape, of…

A: Given data in question Length measured = 440.37 m Measured pull 57 N Standardization pull 41 N…

Q: Calculate the values of: Mw = Ms 1. Bulk (O.D.) Specific Gravity =. (Mc+Mss-Mws) Mss 2. Bulk (SSD)…

A: Bulk SG=MSMC+MSS-Mws SG=MSSMC+MSS-MwsApparent SG=MSMC+MS-Mws% abs=Mss-MSMS×100

Concept explainers

Evaporation

This topic is majorly taught in various undergraduate and postgraduate degree courses of:

Question

8- If air content and degree of saturation are represented as ae and S respectuvery,
then the relationship between them is
A) a, =
B) a, = 1-s
C)S = 1+ a.
D) S = ae
9- In wet soil mass, air occupies one-seventh of its volume and water occupies one-
eighth of its volume the void ratio of soil is
A) 0.25
The relationship between Ysat , Ggand e is
B) 0.36
C) 0.43
D) I
10-
A) Ysat
1+e
B) Ysat
(G-e)yw
1te
C) Ysat
(Gy+e)yw
1+e
(Gte)
D) Ysat
The relationship between ysat Ya. Y and S is
A) y = Ya SlYsat - Yal
B) y =
1te
11-
S[Yrat-Yal
C) y = Ya + S[Ysut -Yal
D) y = Ya - S[Ysat - Yal

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

11-7. A water contains 200 mg/L Ca, 75 mg/L Mg, 180 mg/L HCO3, and 150 mg/L CO₂- all expressed as CaCO3. Determine the chemical dosages required to soften this water as much as possible without removing magnesium. What will the final hardness be? 1-8. If the water of P7 is to be softened to a final hardness of 85 mg/L as CaCO, and is not to contain more than 25 mg/L. Mg as CaCO3, find the required chemical dosages. 1-9. Design a cation-exchange process which will produce a water meeting the criteria of PT-8. Assuming the salt must be provided in an excess of 100 percent, how much salt would be used per year in a plant with a capacity of 5000 m³/day? Solve 11-8 & 11-7 The manufacturer recom-
Mcq
Does the function, =Ur cose+cose represent possible irrotational flow? r
70 m^3 of air flows in an intake airway towards a working section. Before entering the working section 10 m^3/s is drawn off and passed through a filter leaving with a dust concentration of 120p/ml. 50 m^3 is passed through a bulk air cooler leaving with a dust concentration of 100 p/ml. After the remixing of the air streams and before the air enters the working section,the dust count of the mixture is 130p/ml. Calculate the dust concentration of the original 70 m^3/s.
Answer the attached question.
The flow of the fluid (laminar or turbulent) depends on: Viscosity, pipe diameter, and velocity True O False O
Fluid mechnics subject A block of wood with uniform horizontal section float in water with 25 cm projecting above the surface. The sameblock when placed in a body of oil (sp. Gr = 0.80) floats with 20 cm projecting above the oil surface.1. Determine the height of the block of wood.
Q#4: Provide three applications of each in light of soil stability. Hydraulic conductivity Liquid limit Plasticity index Moisture content Permeability SIR, PLS GIVE ME PROPER AND CORRECT ANSWER WITH FULL DETAILS. THANKS
3. 6.0" wide wooden fence posts are embedded in a concrete driveway a distance 12.125" apart. There is a 1/16" gap between the post and the concrete (see diagram). The posts are installed when the temperature is 12°C. Determine if the gap will close when the temperature increases to 32°C and if not how big the gap will be at that temperature. The thermal expansion coefficients of wood and concrete are awood =32 x 105 °C and aconcrete =13 x 106 °C. 1 inch3D2.54 cm. 6.0" 12.0" 0.0625"
tiutly futimerged Vertical Plane) Hy drostatic Thrust: Ah キo pgBo td-}) throreticat Dep th of Pressuve: h.HF Trial HI Trial HZ Trial # 3 か0 mg a10 mg l10 mg B 14 cm 1.4 cm I1.4 cm %3D 11.5 cm こし 11.5 cm し 15.5 cm 12.u em D ラ 9.8 cm 22. 8 em 22.8 cm un 8.22 143 cm d= Il.5 cm d 8.0 cm 9.& cm hs 4.5 cm 3.6 cm %3D