50 v 41 y Write a matrix equation that determines the loop currents shown to the right. 20 20 $20 40 30 ww 40 3a $20 $40 31'v 26v Complete the matrix equation. 50 12 - 31 13 26 41 14 15

Q: と。 O/ A balance 2-phose Y-Comecled \aad has z to 4-usa on Find phose Curents and live cnnnts.

A: Given data, Phase impedance is given, Zph=10∠-450 VCA is the voltage between line C and A therefore…

Q: True or False More than one surface texture symbol may be applied to the same surface.

A: The question is asking whether it is possible to apply more than one surface texture symbol to the…

Q: Chances of fault occurrence are rare in underground cables.

A: True

Q: formula for admittance and draw the current triangle and admittance triangle for parallel RL…

A: formula for admittance and draw the current triangle and admittance triangle for parallel RL circuit

Q: I. TRUE OR FALSE: Write TRUE if the statement is correct; and if false, write NO and underline the…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.…

Q: AMoving to another question will save this response. uestion 8 Which of the following is the phase…

A: In this question we need to choose a correct option.

Q: the voltage across R2 is _______ i2.

A:

Q: Insulation detorioration of transformer winding due to high temprature is an incepient fault O True…

A: Insulation deterioration of transformer winding due to high temperature is an incipient fault  Is it…

Q: What is wrong with the switch wiring? O Jacket is not removed far enough O Nothing O Terminations…

A: In a wiring, usually a phase wire of the supply is connected to one of the terminals of the device…

Q: Answer the following question related to a series/parallel combinational circuit configured as…

A: The Solution for the given is, V=24 VR1=4.5 kΩR2=30 kΩR3=10 kΩ Resistances R2 and R3 are in…

Q: If all the sequence voltages at the fault point in a power system are equal, then the fault is a…

A: When all the sequence voltages at the fault point in a power system are equal, then the fault is a…

Q: what is meaning of contamination of condensate water and reasons and how to solve this fault, 2-…

A:

Q: Load sets are connected in series or in parallel but fuse must be always connected in a)series…

A: ANSWER:- OPTION.A

Q: In case of permanent fault, for the coordination of protective devices the following data is…

A: all of the above .

Q: positive, negative, and zero sequence reactances of 0.25 pu, 0.15 pu, and 0.05 pu, respectively. The…

A: The expression for single line to ground fault current is given as:

Q: Please answer. Thank you! Discuss the fault analysis in series-parallel circuits.

A: Fault analysis in a series paralleled circuits is an important aspect of electrical engineering and…

Q: . 54.5% ,10ohms / 27.3% 20ohms / 18.2%

A:

Q: In which type of fault diagnosis the fault can be identified by visual inspections of any loose…

A: In this question we are going to study about the different techniques of finding the faults in a…

Q: 3-phase fault is the severe fault among all other faults True False

A: Choose the correct option Is it true or false The given Statment "3 phase fault is severe fault…

Q: The sequence components of the fault Izero = -j1pu. The type of fault in the system is current are…

A: The sequence components of the fault current are, Ia1=j2 puIa2=-j0.5 puIa0=-j1.5 pu

Q: 5. Will the lamp become bright or dim or stay the same when we move the brush to the right? Why Will…

A:

Q: In which of the following faults symmetrical component method is not required O a. Line to line…

A:

Q: e- For a fault current of 6000A and a CT 300:5, resistance of 0.2 N. It is connected to a relay with…

A: Fault current, 6000if=3005⇒if=100A

Q: A LLL fault occurs at terminals of a 33 kV, 3 phase 50 Hz circuit breaker. The maximum value of…

A: Given- A LLL fault- 33 kV, 3 phase-50 Hz circuit breaker, To Find- The maximum value of the…

Q: 3) Reduce the block diagram of the system using Mason's Rule. Rist Els) 100 - ●Cl)

A:

Q: In case of permanent fault, for the coordination of protective devices the following data is…

A: For the above question. TCC All of these Feeder circuit diagram Location of protective device.…

Q: Question 5

A: There are three types of buses-  Load bus Slack bus / swing bus Generator bus 1. Load bus- A bus…

Q: Choose the correct one for Underground Cable: O a. Initial Cost is More O b. Faults are more O C.…

A: In this question we need to choose a correct option

Q: Using GG  for positive counters and RR  for negative counters, perform the addition problem with…

A: Given, GG  for positive counters and RR  for negative counters. Perform using counters: -4 ++ 7

Q: Mechanical connections

A: Mechanical connections Connection of two or more elements by means of any mechanical fasteners such…

Q: The distribution feeder is mainly protected from the lighting, by using the process of shielding…

A: A lightning arrester is a device that protects the insulation and conductors of an electric power…

Q: Choose the correct Answer: In TIA 568-A RJ-45 wiring standard, the colors of pin number 5 and 6 are:…

A: A T-568-A RJ wiring standard is shown below,

Q: The time available to turn-off thyristor in load-commutated chopper is 3-2E2Cf, 4-C, 5- None of…

A: The above question is based on load commutated chopper.

Q: In a power system 2 % of the total occurred fault is symmetrical fault. This will be most severe due…

A: Solution The symmetrical fault is most severe in high voltage and high current.

Q: Generators are often run in parallel because it Keeps stability of supply Gives facility of repair…

A:

Q: Q) In Wheatstone bridge method, the bridge is said to be balanced when the current through the…

A: In this question we will write about wheatstone bridge...

Q: - For the following circuit: a) Find the total number of stuck-at-0 and stuck-at-1 faults. Show your…

A: The answer as given below: