5. An open feedwater heater that operates at a pressure of 1000 kPa. Feedwater at 50°C and 1000 kPa is to be heated with superheated steam at 200°C and 1000 kPa. The mixture leaves the heater as saturated liquid at the feedwater pressure. Determine the ratio of the mass flow rates of the feedwater and the superheated vapour for this case.

5. An open feedwater heater that operates at a pressure of 1000 kPa. Feedwater at 50°C and 1000 kPa is to be heated with superheated steam at 200°C and 1000 kPa. The mixture leaves the heater as saturated liquid at the feedwater pressure. Determine the ratio of the mass flow rates of the feedwater and the superheated vapour for this case.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam is delivered to turbine at 5.4 MPa and 600 degree C. Before condensation at 31 degree C, steam is extracted for feed water heating at 0.6 MPa. The turbine exhaust is 60 degree C. the required values of some state point properties are tabulated below. 6. Determine the enthalpy of bled steam entering the open feed water heater.
1. A refrigeration system using R-22 has a capacity of 320 kW of refrigeration. The evaporating temperature is -10°C and the condensing temperature is 40°C. Calculate the fraction of vapor in the mixture before the evaporator. Properties of R-22: At -10°C; hg = 401.60 kJ/kg, hf = 188.43 kJ/kg At 40°C; hf 249.69 kJ/kg
A reheat cycle with two stages of reheating is executed with steam expanding initially from 25 MPa and 600 °C. The two reheater pressures are 4 MPa and 1 MPa, and the steam leaves each reheater at 600 °C. Condensation occurs at 40°C. What is hi in kJ/kg?
All the nearby buildings' heating is provided by saturated steam generated at a nearby steam plant using natural gas boilers. On March 13th, 2019 (cycle weather bomb), the area experienced a cold front with outdoor air temperature equal to 39°F at 9 am. After heating all buildings in the area, water returns to the boiler as saturated liquid at 222°F. Water is then preheated and pressurized to 222°F and 180 psig (state before entering the boiler). Water leaves the boiler as saturated vapor at 322°F. For this date/time steam mass flow rate was 21,900 lbm/hr.Boiler combustion produces combustion gases at 3,000°F at 20psia, which leaves the boiler at 400°F 19.5psia. Determine: The pressure of the steam leaving the boiler and the oiler heat capacity (heat needed to produce steam at the given flowrate and temperature, MMBtu/h) Mass air flow rate (lbm/h) and he exergy destroyed (MMBtu/h) in the boiler Second law efficiency in the boiler Assumptions: Steady operating conditions exist and…
How many kJ of heat is required to produce 32 kg of steam 88% dry at 3000 kPa from feedwater at 90C?
Air at 20 ° C and 50% RH is channeled into the heating coil so that the temperature of the dry ball is 70 ° C. Then it is used for drying by passing it to a pile of granular pet food. The air exiting the pile has a dry ball temperature of 50 ° C. This air is then reheated to 80 ° C and flown to the other pile of pet food. The air coming out of the second dryer is in a saturated state. Draw the processes that occur from ambient air to saturated air from dryer 2 on a psychrometric diagram. Determine the amount of water removed in the first and second dryers per kg of dry air.a. first dryer (kg water / kg air).b. second dryer = (kg water / kg air)
air at 30 ℃ and RH 40% flowed to the heating coil so that the dry bulb temperature was 80 ℃. then air is used to dry it by passing it into a pile of granulated pet food. The air coming out of the pile has a dry ball temperature of 60 ℃. This air is then reheated to 80 ℃ and flown into the pile of other pet food. the air coming out of the second dryer is in a saturated state. Describe the processes that occur from ambient air to saturated air from desiccant 2 in a psychometric diagram. determine the amount of water discharged in the first and second dryers per kg of dry air. a. first dryer ... (kg water / kg air) b. second dryer ... (kg water / kg air)
Steam is expanded in the high pressure turbine from 4000kPa, 360°C to 1000kPa with an isentropic efficiency of 80%. The steam is then reheated isobarically to 360°C after which it passes through the low pressure turbine expanding down to 4kPa with an isentropic efficiency of 75%. If the condensate has a temperature of 24°C, calculate: (a). the condition of the steam entering the reheater (b). the condition of the steam entering the condenser (c). the total power output for a mass flow-rate of 10tonnes of steam per hour (d). the specific steam consumption in kg steam/kWh (e). the Rankine efficiency of the plant including the feed pump work
2. A 1.4-m rigid tank initially contains refrigerant-134a at 20°C. At this state, 80 percent of the mass is in the vapor phase. The tank is connected by a valve to a supply line where refrigerant at 1.2 MPa and 100°C flows steadily. Now the valve is opened slightly, and the refrigerant is allowed to enter the tank. When the pressure in the tank reaches 800 kPa. the entire refrigerant in the tank exists in the vapor phase only. At this point the valve is closed. Determine (a) the final temperature in the tank, (b) the mass of refrigerant that has entered the tank, and (c) the heat transfer between the system and the surroundings.
A 2 kg/sec of steam is delivered to the turbine at 5 MPa and 600 degree celsius. Before condensation at 30 degree celsius, steam is extracted for feed water heating in the Closed feedwater heater with drain pump forward at 0.65 MPa. Determine the following: (a) mass flowrate of extracted steam in kg/sec, (b) Heat added in kJ/min (c) Heat rejected in kJ/min, (d) Ideal turbine work, (e) Pump work in KW, and (f) thermale efficiency
In the condenser of the power plant, Ammonia is isobarically condensed to saturated liquid state with 615.2kPa and x = 0.9, the mass flow rate is 4 t/h. The heat rejected from the condensing ammonia is added to heat water, which is heated from 277K to 281K. What is the mass flow rate of water in t/h. Also sketch the T-s and P-v diagrams.
Rice at 35% moisture is to be dried to produce 500 lb/hr with 5% moisture. The air at 85 C and 30% RH is a mixture of outside air at 77 F and recirculated air coming from the drier is reheated to 113 C before entering the dryer and leaves at 100 C and 60 % RH. The steam that is used to reheat the air enters and leaves the reheater saturated at 75 psi. Determine: (a) the amount of feed in lb/hr. (b) the amount of air in lb/hr. (c) the amount of steam needed to reheat the air in lb/hr.