3. Sketch the straight-line approximations of the frequency responses for the RC low-pass filter on Graph 1 (see later). Figure 3 shows and RL low-pass filter.

Need help steps would be helpful please and thank you!

a simple Circuit with R =50 ohm and L = 200mH would be a) high or low pass filter? and b) with f0 = ?

Table 1: Filter information A filter is required to attenuate all signal frequencies above 24 kHz by a minimum of 27 dB. Select R2 = 16 kO. From Table 1, what type of filter is this? From Table 1, what order is this filter? From Table 1, what is the signal attenuation at f = 24 Hz? (dB): From Table 1, what is the fall-off rate? (dB/octave): From Table 1, what is the signal attenuation at f = 0.5 x 24 kHz? (dB): From Table 1, what is the signal attenuation at f = 0.25 x 24 kHz? (dB): From Table 1, what is the cut-off frequency? (kHz): From Table 1, determine C1 (nF): What is the E24 standard value of C1 as determined in the preceding question? (nF): From Table 1, what is the value of C2? (pF): What is the E24 standard value of C2 as determined in the preceding question? (pF): From Table 1, determine R1 (kilo ohms): What is the E24 standard value of R1 as determined in the preceding question? (kilo ohms): From Table 1, determine R3 (kilo ohms): What is the E24 standard value of R3 as…

What is the distinction in voltage attain of a lowpass filter if the enter frequency is doubled?    What is the distinction in voltage attain of a lowpass filter if the enter frequency is expanded ten times?    How do you assemble a band give up RC filter? Simulate a circuit and generate a desk to show your claim.

A low pass filter is designed to have dB/decade. The cut off frequency is 200 Hz, and the maximum gain of the filter is 23 dB. Determine the ff: a roll off factor of 40 a. Power in dB at the cut off frequency. b. Power in dB at 4000 Hz. c. Frequency that has a power of -20 db.

3. Active Analog Filter Topologies You already know from our class discussions that Circuit 1 is an active analog Low-Pass Filter For each of the remaining three circuits, state whether the circuit will function as a low-pass or high-pass filter. Each of your answers must be accompanied by a brief explanation and justification incorporating the frequency dependent characteristics of the reactive circuit elements. That is you should look at the asymptotic impedance of the L and C if the input signal the frequency is very low or very high. Sketch the expected Bode plot for 20 log(Vo/Vs) as a function of log (f) labeling the corner frequencies. No equations are required! R2 R2 R2 R2 R1 R1 R1 Vs Vs o W- Vs Vs Vo Vo Vo Vo Circuit 1 Citcuit 2 Circuit 3 Circuit 4

Answer the following wuth illustration and solutions. 1.) A second-order band pass filter is to be constructed using RC components that will only allow a range of frequencies to pass above 500Hz and below 1.5kHz. Assuming that both the resistor have values of 1kohms, calculate the values of the two capacitors required. Find also the center frequency of the two frequencies. This is the example/guide that might help.

Please show complete solution and necessary figures. Thank You!