3. Active Analog Filter Topologies You already know from our class discussions that Circuit 1 is an active analog Low-Pass Filter For each of the remaining three circuits, state whether the cireuit will function as a low-pass or high-pass filter. Each of your answers must be accompanied by a brief explanation and justification incorporating the frequency dependent characteristics of the reactive circuit elements. That is you should look at the asymptotic impedance of the L and C if the input signal the frequency is very low or very high. Sketch the expected Bode plot for 20 log(Vo/Vs) as a function of log (f) labeling the corner frequencies. No equations are required! C C C C

A:

A: Consider all the given values.

A:

A: Step 1: Step 2: Step 3: Step 4:

A: To find: a) Frequencies b)we need to find the type of filter using the given difference equation. c)…

A:

A: The image shows an electronic circuit that includes an operational amplifier (op-amp), resistors R1…

A: According to the question we have to draw the circuit using standard resistance values.

A: Passive filters : It has combination of capacitors and inductors. It is tuned to resonate at a…

A:

A: R2=R4=2.6 k ohm critical frequency Fc=20 khzCR1=CB1=10 nF, RA1=RB1Critical frequency Fc=12πRA1 CcA1…

A: Refer to the circuit diagram, the voltage at the non-inverting terminal is determined using the…

A: a) For a BPF characteristic,and sampling frequency . we need to determine: b) we need to determine…

A: Here is the step-by-step explanation:​​The circuit in the image is a simple RC low-pass filter,…

A: We need to find cut off frequency for given filter .