3. A ternary blend of gasoline (90% octane no), alcohol (75% ethanol, 25% methanol) anc benzole (75% benzene, 15% toluene and 10% xylene) is burned completely in 35% excess O2. Analysis of the blend shows 70% gasoline, 15% benzole and 15% alcohol. Calculate the

Q: Partial and total vapor pressures for methanol (Component B) and water (Component C) solution at…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…

Q: Formaldehyde is produced by catalytic oxidation of methanol by the following reaction: CH3OH + 1/2…

A:

Q: Practice # 1 Find the specific volume, WBT, moisture content and specific enthalpy of air at 35 °C…

A: Hello Subscriber! There are multiple questions posted.. As per our policy, we have solved the first…

Q: 1- Propylene oxide (C;HgO) is produced by reacting propylene (C3H6) with oxygen and hydrogen. A side…

A: Given that, The mole flow rate of air nair,in = 35 molh The mole flow rate of propylene nC3H6,in = 4…

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A:

Q: Methane is burned completely with 25% excess air. Compute the number of moles of nitrogen in the…

A: Methane +air → Products Excess air=25% Find Number of moles of nitrogen in the products

Q: Stack gas containing 10% CO, 12% H₂, 18% CO2, 45% N₂, and 15% H₂O has a pressure of 120KPa.…

A: Composition of a stack gas is given.

Q: 7. The roasting of pyrites analyzing 85% FeS, and 15% gangue utilizes 40% excess air (FeS2 to SO2…

A: To find a. complete analysis of the burner gas b. weight of 15% oleum formed

Q: A flue gas from a certain furnace burning a fuel of negligible nitrogen content is found by analysis…

A:

Q: Given the following figure. Calculate the phase composition amount (alpha and beta) at i) 150 degree…

A: We need to determine the phase composition amount (alpha and beta) at 150 degree Celsius for 40 % Sn…

Q: 2) A gas with a composition of %20 CO(g), %30 CO2(g) and %50 N2(g), is burnt with dry air…

A: Given, Air present = 0.1mol This contains 1 part of O2 and 3.76 parts of N2. So, O2 present=…

Q: 52) In the Cu - Ag phase diagram shown below Composition (at% Ag)

A:

Q: Problem 3. Glass comprises Na:O 7.65%, MgO 10.57%, ZnO 7.25%, Al2O3 1.19%, B2O3 7.43%, and SİO2…

A: The mole percent of the compounds present in the glass is to be calculated.

Q: How much air is needed (in m', at 25.0 °C, 1.00 atm) to completely burn 10.0 moles of propane…

A: Step:1    Introduction   Following  values are given in the question-   Moles  of  C3H8=10 mo…

Q: 6. Coal tar fuels are liquid fuels obtained by blending coal tar distillation products such as…

A:

Q: Cite the phases that are present, the phase compositions, and the relative amount for the given…

A: Phase diagram of metal alloy is given.

Q: A mixture containing 33% n-hexane, 37% n-heptane and 30% n-octane by mole is fed to a flash…

A:

Q: Calculate the difference between ΔU and ΔH for the burning of one mole of hexadecane (C16H34) at…

A:

Q: A lead ore, galena, consisting mainly of lead (II) sulfide, is the principal source of lead. To…

A:

Q: 19. COMBUSTION- LIQUID FUELS. The formula of a saturated hydrocarbon in a hydrocarbon-N2 mixture was…

A: Given that, Fuel - Saturated hydrocarbon + N2 mixture %excess air = 30% Orsat analysis of combustion…

Q: An alkaline solution of sodium carbonate made up of 0.594% NaOH, 14.88% Na2CO3 and 84.53% water is…

A: Write the reactions as follows: CaO + H2O = Ca(OH)2        .......(1) Na2CO3 + Ca(OH)2 → 2NaOH +…

Q: The following data were obtained for the extent of adsorption S, of acetone on charcoal from an…

A:

Q: A gas mixture containing 90 mol% C2H6 and the balance CH4 are burned with 9% excess air. Assuming…

A: Given A gas mixture containing 90 mol% C2H6  and the balance CH4  is burned with 9% excess air.…

Q: A gas mixture containing 25% mol CO2 and 75% NH3 is being scrubbed byan acid solution to remove the…

A: Given data: Composition of gas mixture entering the tower is, CO2= 25 mol % NH3= 75 mol %…

Q: A mixture of propane (C3H8) and butane (C4H10) is burnt with pure oxygen gas in excess in a furnace.…

A: Givencombustion of propane and butane with pure oxygen in excessmolar  composition of stack gas ,…

Q: A mixture contains 10.0 mol% ethyl alcohol (C HO), 75.0 mol% ethyl acetate (C HO), and 15.0 mol% of…

A:

Q: Pyrite Fines containing 85% FeS2, and 15% gangue are charged to a burner. An analysis of the cinder…

A: Given that, The mass composition of Pyrite fines FeS2: 85% Gangue: 15% The mass composition of…

Q: 6. A high grade semi-anthracite coal has a complete analysis of 85.86% C, 4.44% H, 2.7% O, 1.2N, 5%…

A:

Q: Assuming the gases are ideal, calculate the amount of work done, in joules, for the conversion of…

A: Given data: Temperature = 75 0C Gas constant = 9.314 J/mol.K Number of moles of Ni = 1 mol

Q: The composition of Liquefied Petroleum Gas(LPG) is 0.5% ethane, 0.1% acetylene, 16.4% propane, 2.1%…

A: Given that Composition of Liquefied petroleum gas Mole fraction of ethane = 0.005 Mole fraction of…

Q: 1. 2.0 1.9- 1.8- 1.7 We have a mixture of Nitrogen (10%) and butane. The temperature is T=171 °C and…

A: Note: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: A chemist attempts to prepare some very pure crystals of borax by dissolving 100g of Na2B407 in 200…

A: Borax is a common naturally available mineral that has various medicinal properties such as…

Q: Calculate the maximum temperature (Tmax) that wilIl be obtained if 1 mole of acetylene (C2H2) is…

A: If b*103=n, then b = n*10-3 The reaction of combustion of acetylene is given by: 2C2H2 + 5O2…

Q: calculate the molar and mass composition of the gas on a wet basis, as well as the molar mass of the…

A:

Q: A pure saturated hydrocarbon is burnt with excess air. Orsat analysis of the stack gas shows 7.9%,…

A: Orsat analysis of the stack gas is 7.9% -CO2, 1.18% -CO, 0.24% -H2, 5.25% -O2, 85.43% -N2 Pressure…

Q: Example (2): - Nicotine (C) in a water (A) solution 1% is to be extracted with kerosene B at 20°C,…

A:

Q: C) A compound of iron and oxygen is analyzed and found to contain 69.94% iron and 30.06% oxygen.…

A: Iron (Fe) = 69.94 % Oxygen (O) = 30.06 % Atomic weight of oxygen (O) = 16 Atomic weight of iron (Fe)…

Q: Consider 500mL of a benzene-hexane mixture at 50°C containing 30% of the more volatile. a)…

A: A mixture of benzene and hexane is given. Temperature of the mixture = 50 0C Volume of the mixture =…

Q: Calculate the weight percentage of phenol and draw the relationship with it. The weight percentage…

A:

Q: Calculate the composition of the coal on a dry ash free basis which has the following  composition…

A: Given Composition of coal on weight basis S  4% N2  2% O2  5% Ash  10% H2O  2% C/H=10…

Q: 5.9. Extraction of uranyl nitrate. A 20 wt% solution of uranyl nitrate (UN) in water is to be…

A: Dear student, we answer three parts in a question, so we are providing answers to the first three…

Hazard Analysis and Design in Chemical Engineering

Hazard is the intrinsic property of a material or process which harms the people, buildings, or environment. Health, safety, hazard, risk assessment, loss prevention, and environmental consideration play an important role while designing a chemical processing plant. Hazard is often confused with risk. Risk measures the magnitude of loss and injury of likelihood incidents or the consequence and frequency of incidents.