3. A light rod AB of length 600 mm has a fixed hinge at A and a mass of 5 kg concentrated at B. A vertical spring is attached to point C a distance 400 mm from end A. The spring which extends 25 mm for a direct load of 5 kgf is so adjusted that the rod AB is horizontal in the rest position. Show that if AB is slightly displaced the rod oscillates in a simple harmonic manner with a periodic time of about 0.48 s.

3. A light rod AB of length 600 mm has a fixed hinge at A and a mass of 5 kg concentrated at B. A vertical spring is attached to point C a distance 400 mm from end A. The spring which extends 25 mm for a direct load of 5 kgf is so adjusted that the rod AB is horizontal in the rest position. Show that if AB is slightly displaced the rod oscillates in a simple harmonic manner with a periodic time of about 0.48 s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The homogeneous rod OA is supported at point 0, and a mass of 2m is attached at the bottom of the system as shown. For small oscillations and by use of ENERGY METHOD;
A body weighing 5kg is attached to a very light bar as depicted below. The set-up is free to rotate in the vertical plane about pin support O. The force applied at point C makes the bar oscillate(via small rotation) about the position of equilibrium illustrated below a. Derive the differential equation of motion for the steady state angular displacement (theta) of the bar
A body weighing 5kg is attached to a very light bar as depicted below. The set-up is free to rotate in the vertical plane about pin support O. The force applied at point C makes the bar oscillate(via small rotation) about the position of equilibrium illustrated below With the motion equation being θ.. +(3.9375)θ. + 33.74θ and the amplitude Θ beingn 0.1855 radians and the phase angle Φ = 66.02 degrees. Present the differential equation of motion to include the amplitude and the phase angle
a. Find the equation of motion of the system below using Lagrange's equation and find the natural frequency at the end. Assume that the rod is massless. L ти k₁ www k2 m
b) Draw the free-body diagram and derive the equation of motion using Newton's second law. Also, determine the natural frequency wn of the system. -Pulley, mass moment of inertia J,
Two identical circular cylinders of radius r and mass m each, are connected by a spring, as shown below. Derive the equations of motion using Lagrange's equations. Please indicate the lowest natural vibration frequency. (1 =mr?) k m
A three-blade wind turbine used for research is supported on a shaft so that it is free to rotate about O. One technique to determine the centroidal mass moment of inertia of an object is to place a known weight at a known distance from the axis of rotation and to measure the frequency of oscillations after releasing it from rest with a small initial angle. In this case, a weight of Wadd = 50 lb is attached to one of the blades at a distance R = 20 ft from the axis of rotation. Knowing that when the blade with the added weight is displaced slightly from the vertical axis, and the system is found to have a period of 7.6 s, determine the centroidal mass moment of inertia of the three-blade rotor.
16. A flywheel is suspended by resting the inside of the rim on a horizontal knife-edge so that the wheel can swing in a vertical plane. The flywheel has a nass of 350 kg. The knife-edge is parallel to and 360 mm from the axis of thoe wheel. The time for making one small OBcillation is 1-77 8 Assuming that the o.g. is in the axis of the wheel, find the radius of gyration about this axis. Also find the torque to increase the speed of the wheel at a uniform rato from 240 to 250 rev/min in s when the wheel is revolving about its axis. (U. Lond.) (Ans.: 387-2 mm; 73-25 N m)
A slender, uniform, metal rod with mass M is pivoted without friction about an axis through its midpoint and perpendicular to the rod. A horizontal spring with force constant k is attached to the lower end of the rod, with the other end of the spring attached to a rigid support. If the rod is displaced by a small angle 0 from the vertical and released, show that it moves in angular SHM and calculate the period. (Hint: Assume that the angle 0 is small enough for the approximations sin 0 z 0 and cos 0 z 1 to be valid. The motion is + w?0 = 0, and the period is then T = 21 ) simple harmonic if dt2 d²0 :)
4. A student followed strictly correct procedure in the lab during the experiment of moment of inertia. He measured the mass and diameter of plastic cylinder with value of m = 0.36 kg and D = 0.1 m. The period of system without plastic cylinder is To = 0.667 s. The period of system with plastic cylinder T₁ = 0.92 s. Find: The spring constant K of the system. If a metallic cylinder and a plastic cylinder have same diameter and same thickness, which one has larger moment of inertia? Explain.
A thin cylindrical rod of uniform mass m and length L is suspended from the ends by two massless springs with constants k1 and k2 (Distance L1 and L2 on either side of the center of mass of the rod). The motion of the center of mass is constrained to move up and down parallel to the vertical y-axis. It also experiences rotational oscillations around an axis perpendicular to the rod and passing through the center of mass (I is the moment of inertia with respect to said axis). be y1 and y2 the displacements of the two ends from their equilibrium positions, as shown in Fig. a) Find the motion's equation (consider k1=k2=k)
Prob. 5 For 2 points, sketch a 5 lb semi-circular disc, of radius 6 ins, that is held in equilibrium in a vertical plane by two linear springs with axial stiffnesses 80 lb/ft at the ends of its horizontal diameter. Determine the period of small vertical vibrations.