17- The (CS:IP) of the ISR of NMI are stored in the IVT, starting at address: a. 00000H b. 00002H c. 00004H d. 00008H e. 00020H f. 00040H g. 00080H h. FFFFFH i. DS:DX 18-Using two 74LS138 decoders, two memory banks can be connected to 8086MP, each bank contains a maximum of ....... memory devices. a. 1 b. 2 c. 3 . d. 4 e. 6 f. 8 g. 10 h. 12 i. 16 j. 20

Q: 4-bit data block with eight parity bits, as stated in Section 5.5. Determine the cost-to-performance…

A: A single error correcting, double error detecting (SEC/DED) hamming code is provided, stating that…

Q: Write an ALP to transfer block of data word by word (5 words) from source memory to destination…

A: A low-level programming language designed specifically for a specific computer architecture or…

Q: ou have 48-bit Logical Address Space if offset size is 8KB, show how four level sheme can be…

A: Multilevel paging:To avoid the overhead of bringing large size page table into memory the multilevel…

Q: What addresses in the output portion of the datapath are mapped to the DSR and DDR respectively?…

A: Solution is:

Q: 3.On the PDP-8, only memory on the current page or on page zero can be addressed directly in a…

A: The PDP-8 (Programmed Data Processor) :- PDP-8 (Programmed Data Processor) was a 12-bit…

Q: 12. What is the content value for instruction address 803? * PC 804 AC 804 АС 1CC6 PC D4CA IR 5913…

A: Program counter PC stores the address of next instruction. Given address of current instruction is…

Q: Suppose the program counter (PC) is set to 0x20000000. (a) What range of addresses can be reached…

A: Below is the complete solution with explanation in detail for the given question about the set of…

Q: necessary pins: One Bus Cycle T +T, T CLK- Address- Valid Address ss/Data- Address Data written to…

A:

Q: in short words defind the followings and explaining their function: 1. Direction flag 2. Exceution…

A: As per guidelines I can answer only first three subparts. Thank You. 1) Direction Flag

Q: 2. write 8086 program to copy content of Ax=299fh, BI=87h into memory location A222AH in Es segment…

A: Data copy/ Transfer Instruction 1) MOV- Move Transfers data from 1 register/memory to another…

Q: For 80286 processor which has a 24 bit address bus, maximum amount of addresses for single operation…

A: Solution)  D) 16 M

Q: 16 data lines and a 1- 8086Mp has memory of size: o pins, 14 Byte 2- In 8086Mp, the number of…

A: According to the Bartleby guideline, we are supposed to answer only first 3 fill in the blank…

Q: By immediate Addressing Mode. .4 MOV CX, 12AD1H ADD AX, 11AFH MOV AL, 112FFH true O false

A: In immediate addressing mode the requirement is that the operand should be a part of the instruction…

Q: 4- IVT is a table that contains the addising of the ISR of each interrupt. The size of this table is…

A: According to the information given:- We have to fill the appropriate answer in the blank field on…

Q: Answer the following true or false. a) A microcontroller is a computer in one chip . b) The most…

A: According to answering policy i can answer only first 3 parts. For remaining parts please submit…

Q: If short JMP instruction reside in memory location 02001 what is the value of IP? And which any…

A: Given: The short JMP instruction reside in memory location 02001. The objective is to find the value…

Q: result = (val3 + val4) - (vall - val2) - (30*4)/55 Assume that result, vall, val2, val3 and val4 are…

A: Here is the assembly code:   mov result, val3 add result, val4 mov val1, 134 mov val2, 139 mov val3,…

Q: The Intel80486 has on-chip, unified cache. It contains 8Kbytes and has a four way set associative…

A: To understand the details of the address format for the Intel 80486's on-chip unified cache, let's…

Q: Suppose the EU execute the 4 instruction which is Jump into the second instruction,

A: ANSWER:

Q: Question2: Write an ALP that load the content of BX reg (1A1AH) to memory location That addressed by…

A: Algorithm –   Load the first number from memory location 2050 to accumualtor.  Move the content of…

Q: 5- Instruction queue in 8086 is a -- first in first out buffer allows next instruction to be fetched…

A: As per our guidelines we are supposed to answer only one question. Kindly repost the remaining…

Q: Q1 Write a sequence of instruction to poll switch at 17 of 74F244 that is connected to port 0. ALE…

A: In actual applications, it is occasionally essential to repeatedly read the value at an input line…

Q: Suppose the system is about to transfer the value inside register "A" to register "X", then, the…

A: Answer to the above question is in step2.

Q: Below is a program block written in ARM Assembly. After running the program r0 = ?.

A: Given is a program block written in ARM Assembly. After running the program r0 -

Q: write a piece of assembly code that can count the number of occurrence of character (A) in 250byte…

A: A low-level programming language called assembly language enables programmers to create instructions…

Q: Suppose that CS=6900H an instruction JMP [76F3CH] occurs which is located at 5E333H, what will be…

A:

Q: which address lines are generating the selection line A1 A0?  A. None  B. Selection lines A1 A0…

A: Assembly level language is a low-level programming language, that's used to communicate directly…

Q: Given a 16 bit virtual address space and a 10 bit low-order offset how many bytes is each page.

A:

Q: Q2. Compute the physical address for the specified operand in each of the folowing instructions.…

A: NOTE Below is the answer for the given question. Hope you understand it well. If you have any…

Q: The current server memory modules (DIMMs) employ SEC/DED ECC to protect each 64-bit data block with…

A: Data provided: Modern server memory modules (DIMMs) use single error correcting, double error…

Q: Explain the interfacing operation of 8259A with 8086

A: The interrupt request signal INT from the 8259 is connected to the INTR input of the 8086 and INTA…

Q: 1. In a non-paged address translation, if the base register contains 0x52000000 and the limit…

A: For non-paged memory, all the framework needs to do is guarantee that an actual page outline is…

Q: If Sl=0100H, CS=020AH, SS=080A, IP=1BCDH, the address of the next instruction: 0000 O 03D6Dh None of…

A: Address of next instruction:- In 8086 the address but is 20-bit in length. But registers 16-bit in…

Q: Which memory address in Interrupt Vector Table (IVT) stores the higher byte of the segment part for…

A: Its ISR deal with is saved at region 4 x 4 = 00010H withinside the IVT. INT five to INT 31, those…