13 10+is 25 For the circuit shown below, Take Van = 100 Vrms and the transmission line impedance is 2 ohms per phase. The real power lost in phase B of the transmission line is.W. (take Van as your reference) * O511 O 147 376 723 58 O 129 O O O OO

13 10+is 25 For the circuit shown below, Take Van = 100 Vrms and the transmission line impedance is 2 ohms per phase. The real power lost in phase B of the transmission line is.W. (take Van as your reference) * O511 O 147 376 723 58 O 129 O O O OO

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A short transmission line is represented by an impedance of 0.01 + jo.04. What is the voltage…

A: Given data, A short transmission line has Z=0.01+j0.04 ΩI=1.93∠-8° puVs=1∠0° pu

Q: In the power system the magnitude of the sending end and receiving end voltages are kept at 1pu.…

A: Steps: Find total load demand and total power injected at bus bar Find angle using active power P…

Q: Problem 3.5: From a 3-phase, 480 V generator switchboard, a feeder takes 3-phase power to two…

A: A feeder takes 3 phase power at the other end through cables and transformer Combined series…

Q: For the power system its one line diagram is shown below: 1-Draw the reactance diagram for power…

Q: What is the voltage drop in kV on the transmission line?

Q: 5. A substation receives 4,500 kW power at 0.9 p.f. lag. at 10 kV from a generating station over a…

Q: Two 30 22 parallel transmission lines supply a motor and a static load as shown in the figure.…

Q: A transformer is rated 1000 MVA kV/345 kV with Z-70.10 pu. If the system base MVA is 500, the…

A: (4) Given that Zpu old=j.10 MVAb old=1000KVb old=13.8KVMVAb new=500 Assume that the new base voltage…

Q: The figure below shows the one-line diagram of a three-phase power system. By selecting a common…

A: In this question we need to draw a per unit impedance diagram of the given system.

Q: A 50-Hz, 250-V single-phase power line has the following loads placed across it in parallel : 4 kW…

A: The solution is given below

Q: The single-line diagram of a subtransmision system is presented in the figure below. At point B a…

A: Three phase fault is the symmetrical fault and it is the most severe fault.

Q: The RL (Resistive and Inductive) Load in the Load Side Section of the Distribution Line Simulator is…

A: This question is based on the load connection in the distribution line simulator. RL load in the…

Q: The generator fault current in Ampere is:

A: Given that, Base Voltage (Vb)=13.8kV, Base MVA (Sb)=100 MVA, reactance of line (Z)=20 Ω, Three phase…

Q: In the following network, the voltage magnitudes at all buses are equal to 1 p.u., the voltag phase…

A: Given- Voltage magnitudes at all buses = 1 p.u. Voltage phase angles are small, Line resistance are…

Q: A single phase transmission line is delivering 500 kVA load at 2 kV. Its resistance is 0-2 2 and…

A: The solution can be achieved as follows.

Q: and

Q: A 2000 KVA, 6600/400V , STAR/Delta was performed with short circuit and Open circuit test with the…

A: A star-delta is a mathematical representation of a complex electrical circuit and can be solved by…

Q: The one-line diagram of a three-phase power system is shown in the above figure. The line impedances…

A: Bus admittance matrix calculated using line impedance as Ydiagonal=sum of all admittance connected…

Q: a transmission line has an impedance of 4 12 Ohms/phase, Find the per-unit impedance of this line on…

Q: Consider the three-phase system given in Figure Q1. The parameters of the system are: Generator…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A-phase to ground fault

A: Types of open circuit fault- 1) Symmetrical fault- Three phase line to ground fault Three phase…

Q: A three-phase transmission line has parameters Xc-6 k 2, R-3.25 2 and X₁-25 0, and delivers 300 MW…

A: The system parameter of the 3ϕ systems is given as Capacitive reactanceXC=6kΩ/ph,Y=1-jXC=j6k,Now the…

Q: E (A A 100 KVsurge travels on an overhead line of surge impedance 400 The line is commected to a…

A: Note: We are authorized to answer one question at a time since you have not mentioned which question…

Q: A R-pole, 6o Hz, 480RV, Y-conected, 3-phase gererator has vynchronsus reactance of 1.ohm and…

Q: A single phase, 60Hz, 200-km medium nominal-T transmission line supplies a load of 700 MW at 0.95…

Q: A load of 125 MW at a power factor of 0.7 lagging can be delivered by a 3-phase transmission line.…

Q: For the 3-phase system shown below, the source line voltage is 460 V, 60 Hz, 1). Phase "a" voltage,…

A: In the question, A three phase system given as shown in the figure find the each phase voltage and…

Q: The circuit shown is a negative impedance converter. Determine the impedance looking in: z= VI/II…

A: The non-inverting input (+) is at 0V (grounded), so the inverting input (-) is also at virtual…

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

A: Given:Nominal frequency=60 Hz;Area 1: R1=0.02 pu and D1=1 pu on a base of 1200 MVA;Area 2: R2=0.03…

Q: DetermiNe z-Bus For the Network eee clee joz 12) joils 1, 13) Ś l:2 jisgら

A: The impedance circuit of the network is The Admittance circuit can be drawn by calculating…

Q: The bases of the system are 66 kV and 20 MVA, the transformers will be treated as impedances in…

Q: Take a look at the attached screenshot. Then, write down in words you guess as to what would happen…

A: According to the question, we need to discuss the given image as shown below,Note: In the given…

Q: Note: It is expected from student to develop impedance matrices ofthree phase power system. Develop…

A: Given: Pwer sytem network Z-bus can be build by the 4 types of modification:Type-1: New to…

Q: 5. A single phase, 60Hz, 200-km medium nominal-n transmission line supplies a load of 700 MW at 0.95…

A: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits. As per…

Q: In load bus, the real and reactive power are specified. Select one: True False

A: The solution can be achieved as follows.

Q: Which of the following combinations comprise the Transmission Line Impedance? O A. Conductance and…

A: Consider the diagram for the equivalent circuit model for the characteristic impedance of the…

Q: Take a look at the attached screenshot. Then, write down in words you guess as to what would happen…

A: According to the question, we need to discuss the given image as shown below, Note: In the given…

Q: A single phase line has a resistance of 52ohm per conductor and an inductance of 25 mH per…

Q: 3 Phase Losses in the transmission line Per phase resistance of the transmission line

Q: Two single-phase transformers whose phase electrical equivalent circuits are given below are…

Q: Power Transmission and Distribution Discuss the advantages and disadvantages of single-phase and…

Q: (b) Figure Q5(b) shows a 3.5 km long single phase distributor supplied two loads. The loads…

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

Q: 44020⁰ 4402120° n a 440Z-120° Ib 6-j8 Ω 6-j8Q2 N (6-j8 Ω Ic 1. Calculate the line currents for…

A: In this question, we need to determine the line currents, line to neutral voltage and various…

Q: H.W 6: Eor the systom shown, determeine the fault level and 3-phase fault at the short ecrcint…

A: Reactances of generators and transformers are 10% Pv Now diagram can be drawn as below :

Q: Problem 3.5: From a 3-phase, 480 V generator switchboard, a feeder takes 3-phase power to two…

Concept explainers

DC Generator

An electromechanical machine which converts input mechanical energy to respective output electric energy is called a generator.

Question

13
10+js
25
For the circuit shown below, Take Van = 100 Vrms and the transmission line impedance is 2
ohms per phase. The real power lost in phase B of the transmission line is.W. (take Van as
your reference) *
O511
147
376
723
58
O 129
O O O OO

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A lightning surge with a peak value of 3600kV strikes a transmission line at point A. Find the maximum value of the voltage surge that will be experienced by an equipment connected to point C. 3600kr Z, = 5002 Z, -1002 Zc 6000 %3D
Homework: Given the circuit below, calculate ix and the power dissipated by the 102 resistor using superposition: 7.2 12 2 ww IS V 10 02 40 2 4 A Answer: -1.32 A ,17.43 watts
A high-voltage direct-current generating station delivers power to a city. The generator output voltage is Vo = 400 kV, the city is represented by resistance RL = 1749 ohms, and each wire of the transmission line round-trip between the station and city is represented by resistance RTL = 159 ohms. What percentage of total power supplied by the generating station is consumed by the transmission line? Vo RTL M RTL M RL (city)
consider the following diagram of impedances in per unit of a common base a) get the YBUS admittance array and the ZBuz impedance array 213-j2 pu zt2-j0.15 zg2-j1.85 791-j0.9 211-0.1 1 212-j0.5pu 223-j0.5pu Va 1 p.u. Jv1-1p.u. 22-10 pu
In a single phase equivalent circuit, the current in the a-phase conductor line is simply the voltage generated in the a-phase winding of the generator divided by the total impedance in the a-phase of the circuit. Select one: O True O False
asap please
Referring to the circuit shown in Figure 1 below, solve the following problems: - i) Calculate the total impedance, ZT. ii) Determine the total current, Ir supplied by the generator iii) Determine the value of current at load impedance, I1, I2 and I3. iv) Calculate total real power, PT and reactive power, Qr supplied by the generator. v) Draw a power triangle of this circuit vi) Calculate the power factor of this circuit.
A load impedance, Zo = 10 + j 3 ohm, is connected to a source with line resistance equal to 3 ohm, as shown in the figure. Determine the apparent power supplied by the generator. The apparent power supplied by the generator is _____ VA.
For the system as shown in the following figure, convert the components to same base voltage and apparent power, by choosing 100 kVA as the base kVA and 2000 V as the base voltage for the generators. Redraw the single line diagram with the new per unit values. 15 KVA 2000 V Z=j0.3 pu 25 KVA 2000 V Z=j0.15 pu G1 G2 35 KVA 2000/8000 V Z=j0.2 pu Z=30+j100 Z=60+j120 pu O pu leee 35 KVA 8000/2000 V Z=j0.3 pu 35 kVA 2000/8000 V Z=j0.25 pu G3 10 KVA 2000V Z=j0.35 pu M 30 KVA 2000 V
Overhead lines.
In the figure, bus 1 is the reference bus, V1 = 1.06 p.u and the angle is 0.. A load with active power= 100 MW and reactive power = 50 Mvar is connected to bus 2. The line impedance is z12 = 0.12 + j0.16 p.u on a base of 100 MVA. Start with an initial estimate of |V2|0) = 1.0 p.u and 820) = 0•. Find |V2| () (one iteration). 100 MW 212 = 0.12 + j0.16 ++ 50 Mvar Vị = 1.0/0° О а. |V2| (1) = 0.4 p.u. Ob. |V2| (1) = 0.5 p.u. Oc. |V2| (1) = 0.7 p.u. d. (1) = 0.8 p.u. е. |V2| (1) = 0.6 p.u.
Q1. For the system shown in Figure Q1, draw an impedance diagram in per unit, by choosing 100 kVA to be the base kVA and 2400 V as the base voltage for the generators. 10 KVA 2400 V G₁ Z=j0.2pu 20 KVA 2400 V Z=j0.2pu G₂ T₁ Transmission Line Z= (50+j200) 40 KVA 2400/9600 V Z=j0.1pu Fig Q1 T₂ 80 KVA 10/5 kV Z=j0.1pu M 25 KVA 4 kV