120 kV Fig. 1 nam wzn Z= 6 + 189 110 kV Balanced 3-phase load a. W ZL ZL bem ² m b. ZL co w LOAD: 120 kVA 0.6 pf lagging my 1. For Figure 1: The 34 source on the left delivers power to a 30 load via conductors with an impedance of (6+j8) per line. The magnitude of the line-to-line voltages at the source side and at the load side are 120 and 110 kV, respectively. If the power factor of the load is 0.90 lagging, determine (a) the currents (magnitude and angle) and voltages (magnitude and angle) of the 36 load. (Hint: Voltage at the source side and the load side have given magnitude but different angles. Assume the load is Y-connected and use its Van as the reference.)

120 kV Fig. 1 nam wzn Z= 6 + 189 110 kV Balanced 3-phase load a. W ZL ZL bem ² m b. ZL co w LOAD: 120 kVA 0.6 pf lagging my 1. For Figure 1: The 34 source on the left delivers power to a 30 load via conductors with an impedance of (6+j8) per line. The magnitude of the line-to-line voltages at the source side and at the load side are 120 and 110 kV, respectively. If the power factor of the load is 0.90 lagging, determine (a) the currents (magnitude and angle) and voltages (magnitude and angle) of the 36 load. (Hint: Voltage at the source side and the load side have given magnitude but different angles. Assume the load is Y-connected and use its Van as the reference.)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
QUESTION 1 Two magnetically-connected circuits have the following characteristics: . A series-opposing connection of coils (dot convention). The primary side is connected to a voltage source that has a magnitude of 230 V and a phase angle of 45 degrees. . The primary-side inductive reactance is jXL1 - j8 Ohm. . The secondary side is connected to a resistive load of 10 Ohm. . The secondary side inductive reactance is jXL1 =j5 Ohm. . The mutual inductive reactance is jM=j1 Ohm. The magnitude of the voltage across the resistive load is:
The section bus-bars A and B are linked by a bus-bar reactor rated at 6000 kVA with 12% reactance. On bus-bar-A, there are two generators each of 10 MVA with 8% reactance and on bus-bar-B, two generators each of 6000 kVA with 10% reactance. Find the steady MVA fed into a dead short circuit all phases on B with bus-bar reactor in the circuit.
A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R = 10 ohms, L = 20mH and frequency of 1000rad / s, the current measured is 2.2361A at 89.44 leading power factor. A) Determine the initial capacitance. B) However, a fault occurs on the capacitor branch making its capacitance 20% lower and a resistance of 5 ohms is detected. If this faulty circuit is rerun but at a frequency of 500 rad / s, determine the new current that will flow through the circuit.
What is the main direct cause of reactive power in AC system?A. Resistance of transmission linesB. Inductance and capacitance in the loadsC. Ideal transformer connected in the systemD. Power produced by generator
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
128, An equipment has an impedance 0.9 p.u. to a base of 20 MVA, 33 kV. To the base of 50 MVA, 11 kV, the p.u. impedance will be (a) 4.7 (c) 0.9 (b) 20.25 (d) 6.75
Consider a 3-phase, 50 HZ, 11 KV distribution system. Each of conductors is suspended by an insulator string having two identical porcelain insulators. The self-capacitance of the insulator is 5 times the shunt capacitance between link and ground. Find the voltages across two insulators.
write all possible KCL and KVL equations. simplify all and in ascending order, with contsant at the right side of the equation.
A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The two machines operate in parallel in a power station. What is the equivalent. H constant for the two, relative to a 100 MVA base?
5.5 kW, 1450 rpm. L-type equivalent circuit and parameters for a continuous sinusoidal phase of a star connected 3-phase ASM with line voltage 220 V and frequency 50 Hz are given as follows, ignoring core (iron) losses: R1=0.21 Ohm, R2=-0.18 Ohm, X1=X2-0.66 Ohm and Xm = 9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly? Answer options group 8.0815 2.6455 4.3763 7.1534 1.2558 6.3414 5.2280 3.7473