10. A radar has the following specification: PD = Detection Probability PF = False Alarm Probability PAV = Average Transmitter Power D = Aperture Diameter o = Target Cross Section Cross Section Statistics a = Atmospheric Attenuation 0.9 10-6 100 W 20 cm 10 m² Swerling 2 0

Q: Set up the differential equations with f(t) as input and y1(t) and y2(t) as outputs in the circuit…

A: In this question, we need to determine the differential equations with f(t) as input and y1(t) and…

Q: 2/ For the circuit as shown in Fig. 2, if the power supplied from the voltage sources are equal and…

A: In this question, we need to determine the value of E and currents I1 , I2  and I3 as shown in the…

Q: H.W.(4): Calculate the voltage that must be applied across the soldering iron in Figure shown below…

A: in the given questions we need to calculate the supply voltage to the soldering iron.

Q: You have been asked to design a bridge rectifier for a power supply. A step- down transformer has…

A: A bridge rectifier is a kind of full-wave rectifier circuit that uses four diodes placed in a bridge…

Q: The maximum transferred average power to a load without restrictions calculated in terms of the RMS…

A:

Q: The given Boolean expression X = A.B.C.D+ A. BCD + ABCD + ABCD + ABCD + ABCD + ABCD + ABCD + ABCD +…

A:

Q: 1) 11) The maximum allowed increase in power angle during the fault that would ensure generator…

A: Given dataInitial rotor angle (steady state), .Rotors' angular acceleration at the time of the…

Q: x(t) = 7cos (20t + 픔), 2

A:

Q: 1. Using the Dccricuit trainer connect the crcuit in fig.d) take E = lov, R₁ = 100-2 R₂ =1K-2 and Rz…

A: We are given a circuit in which three resistors are connected in series along with a 10V battery.To…

Q: Draw a state diagram for digital system which is represented by the following dynamic equations x(k+…

A:

Q: Determine the value of I, in the circuit shown in (Figure 1).

A: Given:A circuit, with, we need to determine:the value of current Ix.

Q: Show that the LRC circuit given below can be described by the differential equation L d²i + R di + 1…

A:

Q: 4. Use KVL and KCL to determine the currents I₁, I2, I3, and 14:

A: In the given circuit the value of the unknown currents needs to be calculated by using the KVL and…

Q: b) Use the superposition principle to Calculate the voltage v in the following Circuit. lav ww 512 +…

A: In this question, we need to determine the voltage V using the superposition theorem. There are…

Q: 2) A system is given d²y(t) dt² +6 dy(t) dt + 8y(t) = 2x(t) a) Find the impulse response of the…

A:

Q: The input-output relations of an LTI system is given as follows: y[n] -0.5y[n 1] +0.25y[n-2] =x[n]…

A:

Q: Please help will upvote sure

A: The objective of the question is to understand the load duration curve, find the maximum demand on…

Q: Question 2 2. In linear and circular polarization, consider monochromatic plane waves with frequency…

A: The objective of the question is to construct linearly and circularly polarized wave solutions for…

Q: The figure shows the vector field and the divergence of the vector field. What color describes the…

A: In the given questions we need to identify the source of vector field.

Q: Consider a buck converter with the controlled switch as MOSFET and the uncontrolled switch as diode,…

A: Given data:Required information:

Q: The Energy of the signal 10 e-stu(t) in the frequency band [0] Hz is

A: To find the energy of the signal in the frequency band Hz, we can use Parseval's theorem, which…

Q: A Narrow Band Frequency Modulated signal, with =10 kHz, ₁=100 MHz, 4f₁ = 5kHz is applied to a…

A: The given datas arefm1=10 kHz,fc1=100 MHz,.For frequency multiplier to convert a signal from…

Q: Find the inverse z transform of the given signals. 1-2-1 1-z-1 4 a) X(z)=1 , |z| > NIT 2

A: For the given z transform X(z) it is asked to find the inverse z transform

Q: K A negative unity-feedback control system has the forward path transfer function given as G (s) =…

A:

Q: 3.26 Find the volumes described by the following: *(a) 2 ≤ r ≤ 5; π/2 ≤ 0 ≤ π; 0 ≤z ≤2 (b) 0≤ R≤ 5;…

A: Given Data:b.A spherical coordinate system of,To Find:The volume of the system.The outline sketch.

Q: The circuit shown below operates at 50 Hz frequency. (consider RMS). The Complex power absorbed by…

A: Given circuit, Reactive power of capacitor is 10 VARit is asked to find the complex power is…

Q: 1) Determine the output voltage (vo) of the circuit shown below. 10Ω j4Ω ]5 Ω Η M 100290 v [• j3 Ω…

A:

Q: Find the transfer function Hp(s) (for the first order system)of the circuit shown in Figure  and…

A: In the given questions we need to calculate the transfer function, Gain and time constant.

Q: You are given the following AC circuit. A U₁ 2 B R₁ = 1002 R₂ = 100 1 L = 4 mH wwww U₁ R₂ = 150 The…

A:

Q: Calculate the wavelength of signals with frequencies of 1.5 khz, 18Mhz, and 22 ghz in miles, feet,…

A: The objective of this question is to calculate the wavelength of signals with given frequencies in…

Q: Draw the time waveforms at the output of a D-type flip-flop for a given D-signal and clock signal.…

A: For the given input waveform and clock signal, the expected output waveform for D flipflop and the T…

Q: Derive an expression for vo/vs for the circuit shown below. Rs ww Ust {√₂ gm Vz Yo RL Vo

A:

Q: of tion A load consumes 44 kW at 0.82 pf lagging from a 220.0° V rms, 60-Hz line. A capacitors of…

A: The active power consumed by the load, The power factor, The supply frequency, The supply voltage,…

Q: Q1.2 Ď (10.0 m) 25.0° C (12.0 m) 53.0° B (15.0 m) 30.0° X A (8.00 m) Consider the vectors shown.…

A: Vector is a mathematical quantity that has both magnitude and direction. In contrast to scalar…

Q: (b) The input power to a device is 10,000 W at a voltage of 1000 V. The output power is 500 W and…

A:

Q: A salient pole alternator has X = 1.4 pu and X = 1 pu and Ra = 0 pu. If the q alternator develops…

A: Given data:Required information:

Q: 2.) Aşağıdaki devrede Vo 1 bulunuz? (Find Vo in the circuit below) 5V(+ 2 ΚΩ ww 6 ΚΩ 8 ΚΩ 2 ΚΩ 1 ΚΩ…

A: In the given circuit, we are required to determine: output voltage V0.

Q: You may use the empirical formula for ideal fill factor: ffo = voc-In (voc+0.72) VOC+1 qV oc where…

A: The nameplate rating is shown below.Ambient Temperature C.Solar Irradiance W/m².

Q: Determine the value of voltage measured across E₂, given: E₁87 V, E₁ = 11 V, E = 30 V, and R₂ = 326…

A: In this question, we need to determine the voltage E2 as shown in circuit. We solve this problem…

Q: Small-Signal Modeling of the Diode Use the concepts of small-signal modeling to determine and plot…

A:

Q: Using superposition or Thévenin's Theorem determine the current through R3 11 17mA ↑ 1.4ΚΩ E1 14V +…

A: Given: A circuit, we need to determine:The current through R3 using superposition theorem or…

Q: An antenna radiates in free space has a magnetic field intensity of 12sine H cos(2m x 10"tBr) am…

A:

Q: A signal with spectrum is sampled by an impulse train with the frequency of 2Hz in time domain, Now…

A: We are given a signal with spectrum  which is sampled with the frequency  in time domainNow, we need…

Q: b) For the following network verify reciprocity theorem across the indicated terminal (a-b). 5290 ΑΙ…

A: Given:a circuit, we need to verify the reciprocity theorem across the terminals a-b.

Q: Q1) I. A 100 kVA, three-phase ideal transformer has 4950 turns on the primary and 180 turns on the…

A: For the given three-phase transformer configuration the power loss, secondary emf, maximum flux in…

Q: hirp is a signal of the form x(t) = A sin(2πϕ(t)) where A is the amplitude and the…

A: We are given a chirp signal of the form: x(t) = A sin(2)where A is the amplitude and the function…

Q: the tota power dissipat two resistors of the circuit. 1A (↑ 500Ω A 31.25 W B 7.82 W 100V + I 5ΩΣVR…

A: Power the rate at which work is done or energy is transferred or converted. It is measured in watts…

Q: Consider the following system Ö+ a sin0 = u, = where a > 0 is a constant. Convert this system to the…

A: A first-order, non-linear system is described by the following differential…

Q: Q1A If the signal 4 cos (2r10³t) is used to modulate 13 cos (27 10°t) carrier, (a) find the…

A: The objective of the question is to find the transmission efficiency, total and USB powers of an AM…

Q: I1 U1 R₁ R₂ R₂ I Ra Rs Rs

A:

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.