The 53-kg cylinder is suspended from a clamping collar at C which can be positioned at any horizontal position x between the fixed supports at A and B. The cable is 8 m in length. Determine and plot the tensions in cable segments AC and BC as a function of x over the interval 0 ≤ x ≤ 7. Do your plot on a separate piece of paper. Then answer the questions to check your results. A 7 m C 53 kg B

The 53-kg cylinder is suspended from a clamping collar at C which can be positioned at any horizontal position x between the fixed supports at A and B. The cable is 8 m in length. Determine and plot the tensions in cable segments AC and BC as a function of x over the interval 0 ≤ x ≤ 7. Do your plot on a separate piece of paper. Then answer the questions to check your results. A 7 m C 53 kg B

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter10: Virtual Work And Potential Energy

Section: Chapter Questions

Problem 10.10P

See similar textbooks

Similar questions

Tatiana Popova/She te rstock.com As seen in the photo, a frame is hung on a wall with the center of the hanging cable on the hook. The angle at the hook is 980 and the frame weighs 6 pounds. Determine the tension in each side of the hanging cable. (Round your answer to three decimal places.) Ibs Express the tension as a vector in component form. (Round your coefficients to three decimal places.) T - (smaller i component) T2 = (larger i component)
As shown in the image below, the 87-lb crate is supported by three ropes as shown. The coefficients in the coordinates are a=4.7, b=3.8, and c-7.1. Determine the tension force in cable OC, in lb.
Two blocks are connected by a (massless) string that passes over a (massless, frictionless) pulley as shown. Assume the interface between block A and the horizontal tabletop to be frictionless. pulley If mA = 6.3 kg and mg = 8.8 kg, what is the tension in the string? Express your answer in N, to at least one digit after the decimal point.
9) As shown by this image, the 89-lb crate is supported by three ropes as shown. The coefficients in the coordinates are a=4.1, b=3.6, and c=7.3. Determine the tension force in cable OA, in lb. 10) As shown by this image, the 87-lb crate is supported by three ropes as shown. The coefficients in the coordinates are a=4.7, b=3.8, and c=7.1. Determine the tension force in cable OC, in lb.
The uniform 18kg Bar OA is held in the position shown by a smooth pin at 0, and the cable AB which is in tension as shown. DA 1.5 m 60° 1.2 m What are the components of the Weight Vector (W), which is used to represent the weight of the bar OA W =Wi – Wyj (Answer in Newtons) Wy Choose... Choose... Next page us page
Two forces P=100 N and Q=125 N applied to the point A. Replace this force by an equivalent force using (a) graphical method (b) using algabric method. 30° A Q
Q7b Cables AC and BC are attached to points A and B respectively as shown. These two cables are then tied together at point C to support a 1960 N load. Determine the tension in cable BC. Give your answer in newtons (N) and round to the nearest newton. 750 750 C A 1960 N Answer:
A oil rig tower is held in equilibrium by three ropes. The tension in cable AD is tightened until it reaches 4700 N. Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value d₁ 5 m d₂ 11 m 13.5 m 27.5 m 5m 65 m D d3 d4 d5 de a. Determine the magnitude of the force/tension in cord AB, TAB. b. Determine the magnitude of the force/tension in cord AC, TAC. c. Determine the magnitude of the force developed along the tower, FAE. → i. Hint: FAE = (0 +03+ FAEK) N. Round your final answers to 3 significant digits/figures. The magnitude of the force/tension in cord TAB is N The magnitude of the force/tension in cord TAC is N The magnitude of the force developed along the tower FAE is N
An eye bolt is used to attach 3 cables to a steel plate. The tension in the three cables create F1=200 lbf, F2=250 lbf, and F3=100 Ibf with 0 = 30 degrees and p=44 degrees. If the eye bolt is in equilibrium, what is the y-component of the sum of other forces on the bolt (force from the nut and plate on the bolt) ? If you add up %3D the three force vectors, the sum other force you are looking for will just be in the opposite direction to put the eye bolt in equilibrium. The y-direction is positive going up. For example, if you find the sum of forces 1, 2, and 3 are 100 Ibf going up, then the other forces in the y-direction must be pointing to the down (-100 lbf) to put the eye bolt in equilibrium. Eye bolt steel plate Nut & Washer esc DOO D00 F4 F3 AA %24 F10
7. The homogeneous 100-kg sign is suspended from three wires. Find the tension in each wire. A 2 m B. 1.5 m
Be careful, you have only one question, for this problem. The pulling force is P = 545N. The direction of the rope B is defined by the angle 0-35deg. The position of the point D is (1.3,-2.3.3.1) Xo D Zo Y X P What is the tension Tc in N? Give your answer as an integer. o B -y
A puck weighs 9 lb and rests on the center of the frictionless surface of the ramp supported in equilibrium by ropes AC and BC. Determine the normal force the ramp exerts on the puck as well as the tension in each of the two ropes. X g a b A Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value 44.0 in 48.4 in 24.2 in 50.8 in 50.6 in 12.1 in 71.3 in C d Z e f 9 B