Reservoir A has an elevation of 100 m. A pipe is connected from Reservoir A to Reservoir B. It has a length of 1000 m. and diameter of 600 mm. A pump is installed near Reservoir A and has a rating of 500 hp. If C = 110, rate flow is 550 L/s, 1. Determine the headloss in meters in the pipe. (ANSWER: 7.107)

Q: Problem 7: The two pumps in problem 6 are now arranged in parallel. The static head is 40 ft. The…

A: Given that the two pumps are connected in parallel. The static head is 40ft. Hs = 40ft Diameter, D =…

Q: Determine the flow in L/s into or out of each reservoir in the pipe system shown; use n=0.011 for…

A:

Q: pipe containing pump and turbine has enlargement and contraction in diameter, consider all losses…

A: Apply Bernoullis theorem PAγw+vA22g+zA+HP=PBγw+vB22g+zB+HT+HLHP= head due to pumpHT=Head due to…

Q: EL.90m Goonm-p EL. 30M 1200m A

A:

Q: 3. A 500 mm diameter pipe conducts water from reservoir A at elev. 70m to a pressure turbine, which…

A:

Q: ind the elevation of water at reservoir C. Provide FBD and choose the right answer below

A:

Q: 5. A pump draws water from reservoir A and lifts it to reservoir B. The loss of head from A to 1 is…

A:

Q: 2 and 3 from three reservoirs A,B and C, respectively, meet at a junction whose elvation is 366 m.…

A: Given:- elevation=366m Water levels at reservoir A and B are elevations =825 m and 716 m   pipe 1:-…

Q: There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that in B.…

A: f = 0.02 Apply Bernoulli's equation between reservoirs A and B,

Q: Water is pumped from the pumping station at the Mundaring weir in Perth over the Darling Ranges to a…

A: It is given that: ∆Pρ+∆v22g+g∆z=0∆z=h2-h1=116-0=116mg=9.8 m/s2r1=0.5mr2=1mQ1=2×105Lmin=2×105×10-3…

Q: Two reservoirs A and B have elevations of 250m and 100m respectively. It is connected by a pipe…

A: given question is like given  Q= 159litre/sec L=100m C=120 head loss is…

Q: A conical tank is full of water. It has a diameter of 10 cm. Find the work done in N.m in pumping…

A: Diameter of conical tank=10 cm Depth=20 cm Work done =?

Q: Q.46 A Nozzle of diameter 20 mm is fitted to a pipe of diameter 10 min find the force exerted on the…

A:

Q: A cylindrical tank 1 m diameter and 3 meter high contains 1m of water, 1.2 m of oil (SG=0.8) and air…

A: An orifice provide in a tank at the depth of 30 cm in water and above which oil is filled up to the…

Q: find the elevation of water at reservoir C.

A:

Q: A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which…

A: Pump efficiency is generally the ratio of water power output from the pump to the shaft power input…

Q: From a reservoir A whose surface elevation is 225 m, water is pumped through 1200 m. of 300 mmø…

A: Given data Diameter of pipe(d) = 300mm = 0.3m Length of pipe between 1 and 3 = 600m Length of pipe…

Q: T530 m-150 me. C » 130 C ;=120 I830 m-300 mm, C, » 130 250 mm__ El. 0.0 1220 m-250 mm C C; = 120

A: The given information is  The pressure head at A is 3.05 m  The pressure head at B is 89.9m The…

Q: A pump draws water from reservoir A and lifts to reservoir B. Points 1 and 2 are points just before…

A: Given, Discharge, say Q = 15 L/s = 0.015 m3/s [1 m3 = 1000 L] Diameter of pipe at 1, D1 = 150 mm =…

Q: Water at 20°C ( ρ= 999.7 kg/m3 and μ=9.7720 x10-4 kg/m · s) is flowing steadily in a hexagonal cross…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: Water flows from Reservoir A (Elev 125 m.) to a turbine (Elev 67 m.) then discharges into tailtrace…

A:

Q: A pump draws water from reservoir A and lifts it to reservoir B as shown in Figure below. The loss…

A: Output power through the pump will be calculated by applying the energy equation between point A and…

Q: ELEV. = 65m A ELEV. 32m L- 1500m 2 - 1400m D- 750mm Q= 1.2 m3/s D= 600mm ELEV. - ?? L= 1800m D=…

A:

Q: 2. A 40 cm diameter pipe 600 m long carries 260 liters per second of water from reservoir A,…

A: Length of the main pipe=600 m Diameter of the main pipe(do)=40 cm Discharging pipes diameter=500 m…

Q: find the elevation of water at reservoir C.

A: Given: Pipe 1 L= 3000 m diameter = 200 mm = 0.2m f= 0.018 Pipe 2 L= 1200 m diameter = 300 mm = 0.3m…

Q: Problem 6: If the velocity of water is 8.5 m/s and the pressure is 135KPA on the discharge side of a…

A: Step : 1 Head of Pump :- It is the height of pump due to which pumping can occur against gravity.…

Q: With the chamber-pipe system in the figure, the ideal fluid (water) taken from the infinitely sized…

A: Given:- The chamber-pipe system is given  The fixed diameter of BCDEF pipe = 40 cm  The elevation of…

Q: A 500 mm diameter pipe carries water at L/s. A pump in the pipe is used to move the water from point…

A: d (diameter of pipe) = 500mm = 0.5m Q (discharge) = 500L/s = 0.5m3/s

Q: Two reservoirs whose surface levels differ by 30m are connected by a 600mm diameter and 3000m long.…

A: Given datadiameter of pipe=D=600mmLength of pipe=3000mheight of ridge summit=9mlet the depth of the…

Q: 3.2. For a CI gravity main (Fig. 3.2), calculate flow in a pipe of length 300 m and size 0.2 m. The…

A: Given:- The length of the pipe (L) = 300 m  The diameter of the CI pipe (D) = 0.2 m  The elevation…

Q: Water flows from reservoir A to a turbine and then discharges into tailrace B, as shown in the…

A: To Determine The horsepower being generated by the turbine.

Q: Water is pumped from the reservoir with a surface elevation of 200 m across the valley to another…

A: Given that...

Q: he power input of the pump is 10 kW and the friction head loss between A and B is 1.25 n. If the…

A: DA=0.5m DB=0.25m ZA=0m ZB=2m

Q: If water is pumped from reservoir 1 to reservoir 2 through a 20 cm pipe with a length L1=70 m, and…

A: The expression for velocity in pipe is given as V=QA Substitute the value in above expression V=0.15…

Q: 7. For the Pitot Tube below, determine the height that the fluid rises, L, in the column if water is…

A: Velocity of flow through pitot tube is given and it has been asked to determine height of fluid…

Q: Water is pumped from reservoir A through 1850 m pipeline 600 mm across a valley to a second…

A: Given, Total Pipe length (L) = 1850 m  Diameter (D) = 600 mm or 0.6 m   Friction factor (f) = 0.02

Q: A pump draws water (SG=0.998) from reservoir A and transport it to reservoir B, with the static…

A: Given: A pump draws water (SG=0.998) from reservoir A and transport it to reservoir B, with the…

Q: 5. Oil (S=0.92) is transported through the system as shown below. If the pressure head difference…

A: Given :

Q: A reservoir is fitted with a pump discharging into the open air at point B. The pressure at section…

A:

Q: Consider the figure below. The pump supplies water from reservoir A to reservoir B through the 500mm…

A: Options given for subpart a and b are not correct. If we take hf1 = 80 then the answers are…

Q: A centrifugal water pump with a suction pipe is shown in Figure 3.5 Pump output is Q-0.03m'/s, the…

A: Apply Bernoullis theorem…

Q: A venturi meter with a 10.16 cm throat installed in a 15.24 cm pipe which is inclined upward with an…

A:

Q: A cylindrical tank is placed with its axis and is provided with a circular orifice of 4 cm di-…

A:

Q: Consider the figure below. The pump supplies water from reservoir A to reservoir B through the 500mm…

A: The answers given for subpart (a) and (b) are not correct.

Q: P3: A preliminary design of a reservoir is shown in Figure. Draw the flow-net. Calculate the flow…

A: Flow net is a grid obtained by drawing flow and equipotential lines. It represents the steady-state…

Q: ... Elevation 90m 150mm diameter 100mm diameter Elevation 10m P A pump draws water from reservoir A…

A:

Q: A cylindrical tank of water is 2.0 m in diameter and 3.5 m tall. There is a 1.0 cm diameter hole at…

A: *Multiple Sub- parts*   As per our company guidelines we are supposed to answer ?️only first 3️⃣…

Q: Consider the figure shown below. If the flow rate of water from the tank is 0.03 m/s, the pressure…

A: Case - 1 V2 = Q/A2 = 0.03/(3.14x0.082) = 1.492m/s Case - 2 V2 = (Q/2)/A2 = 0.015/(3.14x0.082) =…

Q: 3. A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in…

A:

Q: A 90% efficient pump lifts water from a lower reservoir a shown in the figure. The head loss in the…

A:

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.