Answered: Calculate the minimum power of the pump…

Calculate the minimum power of the pump which will send the jet of water over the wall shown in Figure B. Neglect losses. 75 cm 0 EL 60m 11:55m Ws punp 30m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Water is flowing at the rate of 300 L/sec from A to E as shown. Assum 0.025 for all pipes. Q2…

Q: 40 30 K 20 10 20 (Closed) 40 60 80 100 (Open) Percent valve setting (a) Determine the flowrate with…

Q: ELEV. = 25m B ELEV. = 15m C 2 L= 1829m D = 508mm 3 L= 1220m D = 406mm E 4 ELEV. = 10m ELEV. = 5m L=…

A: Given,

Q: Water at 25°c is being supplied to an irrigation ditch from an elevated storage reservoir. A 3 m 10…

Q: 4.50 Water stands in these tubes as shown when no rotation oc- curs. Derive a formula for the…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: 11. A tank 3.66m has its ends vertical, top and bottom horizontal, 1.82m high. The top and the…

A: Given: Required to find: the time necessary to lower the water surface to 1.22m

Q: Calculate magnitude, direction and location of the resultant force exerted by the water on this…

Q: ELEV. = 25m B ELEV. = 15m 2 L= 1829m L = 1220m D = 406mm D = 508mm E 4 ELEV. = 10m ELEV. F 5m L =…

Q: A raised water tank has a leak at the bottom which causes the water surfaces to drop from elevation…

Q: The opne-top and completely full cylindirical tank is rotated with a constant angulat velocity…

Q: 5. A rectangular channel to cause critical plan this section is Im, 4 m wide. narrowed to 2m width…

A: Given a rectangular channel 4m wide which is narrowed down to 2m wide so as to cause critical flow.…

Q: Homework: The tank is filled with water under pressure (19.62 kPa). The length of tank =2m. an empty…

A: P=19.62 kPaρgh=19.62×103 N/m21000×9.81×h=19.62×103 N/m2h=2mFH=Horizontal force on AB =ρgAh¯…

Q: How many liters per second of water must the pump shown supply when the flow needed in the 915-mm…

Q: 10.87 What power must be supplied by the pump to the flow if water (T = 20°C) is pumped through the…

A: Bernoulli's Equation: It states that the sum of potential energy, kinetic energy, and other…

Q: P. 7.48 - A water discharge of 8 m/s is to flow through this horizontal pipe, which is 1 m in…

A: Solution; Given that; d=1 m Q=8m3/s Elevation=40 m

Q: A nozzle at A discharges water with an initial velocity of 36 ft/s at an angle α with the…

A: When the body or the object moves along the straight line the speed or velocity of the object…

Q: Pressurized tank delivering a vertical jet. Compute the required air pressure above the water to…

A: Apply Bernoullis theorem P1γw+v122g+z1=P2γw+v222g+z2

Q: A pump is being used to transfer water from one tank to another. Each tank has air pressure above…

A: step 1-

Q: Draught produced by stack 30 meters high for maximum rate of discharge of hot gases through it at…

Q: A manometer with mercury (S-13.6) is connected to a pipe carrying water (S-1). If the manometer is…

A: Given data in question Water as fluid in pipe Manometric liquid is mercury Specific gravity of…

Q: Compute the discharge of water through a standard sharp edge orifice 25mm in diameter under heads of…

A: Discharge of water through standard sharp edge orifice is given by ; Q = A × V where ; A = Area V =…

Q: rainfall intensity of 150 mm/hr. if the slope of the horizontal storm drain is ½ in? -40 m- QI:…

A: Introduction: A storm is a natural occurrence characterized by heavy precipitation and high winds.…

Q: Q:- Find the forces exerted by water on a Im width of The surface of the dam shown in figure and the…

Q: water te water 1-35m Ty 2m mercury (s=13.6)

A: Finding out pressure difference between A and B.

Q: energy line is 2, calculate the value of slope of energy line if the length of back water curve is…

A: To find : Slope of energy line.

Q: A closed tank contains 20 m deep water. A hose is connected as shown such that the nozzle (diameter…

A: Given data, Air gauge pressure = 200 kPa Height of water = 20 m To find out the theoretical height…

Q: 4. A 200 mm line discharges water and hits 4.5 m below its original level. The point where water jet…

A: given that Cc =0.61 Cv =0.97 X =9.2m Y = 4.5m

Q: Consider the section of water distribution piping shown below. Ignoring minor losses, find the flow…

A: From the above figure the given values are as follows,EA=141mZA=60mA-B:-3000m@400mmC=120…

Q: The 200-mm-diameter galvanized iron pipe transports water from a reservoir at a temperature of 20°C.…

A: Given data in question Discharge Diameter Temperature Kinematic viscosity Friction factor…

Q: 10.90 What power must be supplied by the pump to the flow if water (T = 20°C) is pumped through the…

Q: A water discharge 8 m3/s is to flow through this horizontal pipe, which is 1 m in diameter. If the…

Q: 4. Based on the schematic view of the system provided below: a) find the pressure head, hp, that…

Q: Elev. 24.6 m PROBLEM 2 PIPE LENGTH DIAMETER Elev. 12.2 m 1 2,440 m 610 mm C 2 2,440 m 915 mm 3 1,220…

A: PIPE LENGTH(m) diameter(mm) 1 2440 610 2 2440 915 3 1220 406 4 1829 508

Q: Consider the section of water distribution piping shown below. Ignoring minor losses, find the total…

Q: Q4: The pump is adding 7500W fluid power to the flow (toward J) in fig.(2). Find the flow in each…

Q: Water is flowing at the rate of 300 L/sec from A to E as shown. Assume f = 0.025 for all pipes.…

Q: Q7) Water flows from a large reservoir to a smaller one through a 5-cm diameter smooth piping system…

A: The given data is shown below: Diameter=5cmDynamic viscosity=0.001307 Pas

Q: SITUATION Water is being discharged (Q - 280 lit/s) from a reservoir through a turbine as shown.…

Q: As water flows through the pipes, it rises within the piezometers at A and B to the heights hu - 1.5…

Q: inlet and the throat contains water. If the water is A 45 cm by 60 cm horizontal Venturi meter is…

A: We have formula For dischargeQ=A1A2A12-A222ghh=xγwγair-1

Q: (Ch4-1] What is the head loss and corresponding pressure drop (in units of bars) across a 30-…

A: As per guidelines we need to answer only first question so please repost rest questions separately.

Q: Two water tanks are connected to each other through a mercury manometer with inclined tubes. For a…

A: Given two water tanks,

Q: Q1/ liquid is pumped from a ground level reservoir to an overhead tank 90 90 For this system: -…

Q: Q5 (A): Find the time required to drain the water completely from tank shown in figure. -3m 2m Im…

A: The given tank containing water is as shown below. The water is present only in conical part of…

Q: A wooden circular board 1-m diameter is being submerged vertically in a liquid having SG-1.15. Its…

Q: calculate the specific energy of the channel if the bed slope of the channel is 1 in 1000. Given: C…

A: To find : Specific energy.

Q: compute the shaft diameter. What power can be transmitted by the shaft at 20

Q: Given: As = 3m2 C = 0.92 Ao = 0.01m2 Find: Determine the time for the depth of liquid in the tank to…

Q: The three-cistern system in the figure contains water. If L1- 2000 m, f 1 e.e13, D1- 1m; L2- 2300 m,…

A: To compute Q2 in m3/s

Q: 5-55. How do the magnitudes of the velocities of the three jets compare with each other for the…

A: step 1-

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

Calculate the minimum power of the pump which will
send the jet of water over the wall shown in Figure
Neglect losses.
B.
EL 76m
75 cm 0
EL 60 m
EL:5m
wS
45%
dund
30 m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Fox flowe rate 28 Lis Find pump Power EL. 60M L00 Mm. 150 Mm El. 30M
Elev. 110' Inv. 102.5 Elev. 127.6 623.5 -1000' 2000' B Inv. 85' Assuming the conduit in the figure is a 36" wrought iron pipe flowing full, and that the outlet is at point B: a) Calculate the head loss in the flow by the time it reaches point B. b) Calculate the velocity and flow at point B, in the pipe considering friction. c) Sketch the EGL and HGL of the conduit.
REFER TO FIGURE 01, DETERMINE THE INTERNAL FORCES ACTING ON THE FOLLOWING MEMBERS: (STATE COMPRESSION OR TENSION) FG FC GH CH
influenceline B A KIR D 3 L4 RA RB VO мо jby Equations
By comparing the result between Slope Deflection Equation and Modified Moment Distribution Method, determine end moment for all member and reaction at the support and then draw SFD and BMD for each beam.
For Slow nate 28 Lis Find pump Power Eし、60M L00 MM. ち0 mm El. 30MH
Q6. A length of aluminum wire is connected to a 10.00-V power supply, and a current of 0.4212 A is measured at 23.5°C. The wire is placed in a new environment of unknown temperature where the measured current is 0.3818 A. What is the unknown temperature? (ai=0.00429(C°)").
A full tank consists of a hemisphere of radius 4 meters surmounted by a circular cylinder of the same radius and of altitude 8 meters. Find the work done in pumping the water to an outlet at the top of the tank. a. (83456π/15)γw b. (2752π/3) γw c. (2752π/15) γw d. (83456π/3) γw
IV K/s classwork.pdf -> a A jet af wouter From a 25 mm dinmeter nozzle is directed vertieully upuards. Assumning that the jet remains circular and neglecting any less ef enargg that will be the dinmeAer at a point 4.5 m above the ne tzle, if the velecity with which the jet leaves the nozzle is 12 m/s? A jet ef water 4.5M nozale
moment distribution method 20kN /m 4m IC 3'
20. Water is issued vertically at the rate of 30 L/s through a 55 mm diameter nozzle. What is the the maximum height of water can reach.8.12 m9.32 m7.52 m10.15 m
Reservoir B in the figure receives 0.06 m³/s of flow. Determine the flow in line DC. Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m2/s Decimal Places required in the final answer: 3 El 100m A B 1500 m, 450 mm, f= 0.0225 El 82m 500 m, 250 mm f= 0.0178 D 750 m, 300 mm, f 0.0168