Answered: A lossless 75Q transmission line is…

A lossless 75Q transmission line is terminated by a load impedance of 90+j750. Using the Smith chart, find (a) Load reflection coefficient, (b) VSWR, (c) Return loss and Insertion loss,

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.15MCQ

See similar textbooks

Related questions

Q: A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL. According…

Q: Q1) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Given that Load impedance =80+j10 ohms Characteristic impedance=50 ohm frequency =550MHz

Q: In a laboratory, we found that the static wavelength ratio was 2.0 as a result of an experiment…

A: Given :Z0 of T.L =50 ohm Standing wave ratio (s)=2.0The distance between succesive voltage minimum…

Q: three-phase, 60 Hz transmission line has an inductance of 1.378 mH per Km per phase and a…

A: In this question , we will find phase constant , surge impedance and wavelength of lossless line...…

Q: three phase, 60 Hz transmission line has an inductance of 1.08 mH per Km per phase and a capacitance…

A: In this question we will find phase constant , surge impedance for lossless line...

Q: At an operating frequency of 300 MHz, a lossless 50-2 air-spaced transmission line 2.5 m in length…

A: Thank you for posting the question at Bartleby according to our guidelines we solve one question at…

Q: [3] which produces a voltage reflection coefficient Fx = 0.52 angle -320 at a point X on the line…

A: A transmission line with no line resistance and no dielectric loss is known as a lossless line. This…

Q: (5) Transmission-line analysis: A lossless transmission line of characteristic impedance Zo = 100 2,…

A: Given:Z0=100ΩVp=2×108m/slength, l=34 cmZL=30-j40Ωf=1 GHzλ=Vpfλ=2×108109λ=20 cmlength,l=1.7λ

Q: A 50-N lossless line is terminated in Z, = 40 – j30 N. Determine the following: (a) the reflection…

A: A 50Ω lossless line is terminated in Z1=40-j30Ω. Now, to determine the reflection coefficient at the…

Q: A lossless transmission line of electrical length € = 0.32 is terminated with a complex load…

A: Given Data: electrical length l = 0.3 labda ZL = 20 - j 30 ohm Zo = 75 ohm

Q: 10. A lossless coaxial cable terminates cuit load. What is the transmission line voltage expressed…

A: Coaxial Cable- They are special type of cables which have a conductor in the middle and protected by…

Q: A load with an impedance of 424.3045° N is connected to a 100 N lossless line. Using the Smith Chart…

Q: A single-phase antenna transmission line with a length of 40 km and the load supplying with a…

A: Given data, The value of the length of the line is 40 km, The supply voltage with load is 200kV, The…

Q: A lossless 34-S transmission line is terminated in a load with ZL= (66+ j26) N. Use the Smith chart…

Q: lossless transmission line of length 1= = 502, is terminated in a load impedance gnal wavelength on…

Q: Two identical pulses each of magnitude 12 V and width 2 us are incident at i = 0 on a lossless…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: The lossless network given below is excited with a microwave source having frequency f={frq_q1} GHz.…

A: Reflection coefficient

Q: The lossless network given below is excited with a microwave source having frequency f=4,8 GHz.…

Q: The capacitance per unit length and the characteristic impedance of a lossless Transmission line are…

A: It is given that, the capacitance per unit length and the characteristic impedance of a lossless…

Q: A 70 cm long lossless transmission line with characteristics impedance of 50 Ω operating at 5Mhz is…

A: l=70 cm Lossless transmission line Z0=50Ω f=5 Mhz ZL=(65+j80) ΩV=0.8…

Q: A lossless coaxial cable with L = 0.5 uH/ft and C = 100 pF/ft is terminated by a 100-ohm resistive…

A: Given that, L = 0.5 uH/ft C = 100 pF/ft ZL= 100-ohm impedance of cable is defined as…

Q: At an operating frequency of 300 MHz, it is desired to use a section of a lossless 50 N transmission…

A: Transmission line

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: A 5.2cm long, lossless 100Ω transmission line was terminated with a load of ?? = 30 + 50Ω. With the…

A: The load reflection coefficient is: So, the magnitude of the reflection coefficient is: 0.617 And,…

Q: A load with an impedance of 424.30245° N is connected to a 100 N lossless line. Using the Smith…

A: The load impedance is given as, ZL=424.30∠45° ΩAnd The lossline impedance is,Zo=100 Ω

Q: Q1) Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming a…

A: Given: Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming…

Q: A lossless 500 transmission line was terminated with a load of = 17.7 + j11.80. The length of the…

A: we need to calculate the reflection coefficient at the entrance.

Q: A lossless air-filled transmission line with Z0 = 50Ω is terminated in a load with ZL = (150 - j100)…

A: Lossless air-filled transmission line with Zo=50Ω is terminated withZL=150-j100Ω.Reflection…

Q: The standing-wave ratio on a lossless 3002 transmission line terminated in an unknown load impedance…

Q: One end of an air lossless transmission line having the characteristic impedance of 75 Q and length…

A: Power generation, transmission, and distribution systems constitute a power system. The power…

Q: A 100 ohm transmission line powered by a 1 GHz source and terminated with a load impedance of ZL =…

Q: Antenna with impedance 40 +j30 2 is to be matched to a 100 Q lossless line with a shorted stub.…

A: Antenna with impedance 40+j30Ω is to be matched to a 100 Ω lossless line with a shorted…

Q: Problem #5) An 80cm long, lossy transmission line has the following characteristics: Z = 752, Y =…

A: An 80 cm long, lossy transmission line has the following characteristics: Zo=75 Ω, γ=0.10+j2.876 The…

Q: -ohm resistive load and is operated at 100 MHz. At an electrical length of 0.4 wavelengths, what is…

Q: A 90 N lossless line is 0.6A long, If S = 1.9 and 6, = -68°, use the Smith chart to find the load…

Q: A 300ᘯ transmission line is 0.8 m long and terminated with a short circuit. The line is operating in…

A: A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit.The line is operating in…

Q: A 602 lossless transmission line is terminated with an antenna of impedance of (27 + j30) Q. Use the…

Q: A lossless transmission line with characteristic impedance of Z0 = 1000 and length I = 52cm was…

A: Given data:

Q: 6. The standing-wave ratio on a lossless 300-2 transmission line terminated in an unknown ZL is S=…

Q: QUESTION.2. A lossless air transmission line with Z, = 50 N is connected to a complex load composed…

Q: An extra high voltage transmission line of length 300 km can be approximate by a lossless line…

A: Given, An extra high voltage transmission line of length= 300 km Propagation constant, β= 0.00127…

Q: The following lossless network is powered by a f=9,7 GHz microwave source. A matching circuit is…

A: Given, f = 9.7 GHz ZL = 34 L = 270,77835273601

Q: The line parameters of a lossless transmission line are L = 0.25 µH/m and C= 100 pF/m. If the…

Q: A 75N lossless transmission line is terminated with a load impedance equals to 105-j1502. The length…

A: consider the question;

Q: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

A: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

Q: The distance from the load to the source moving on a lossless transmission line is 2.5 revolutions…

A: The transmission lines are used for power transmission from one place to another. The power system…

Question

A lossless 75Q transmission line is terminated by a load impedance of
90 +j750. Using the Smith chart, find
(a) Load reflection coefficient,
(b) VSWR,
(c) Return loss and Insertion loss,
(d) Distance of first maxima and minima from the load.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5 Answers :

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
5-A lossless T.L. has Zo = 100 Q and is loaded by ZL. The VSWR = 2. The first two voltage minima are located at z= -10 and -35 Cm from the load where z = 0. Determine ZL.
g) Why the Capacitance effect is neglected in Short Transmission Line. h) Distinguish between Lumped or Distributed elements in a Transmission Line.
4- The charactersitic and load impedances of a lossless transmission Line are to and Z₁ = // Z₁. 1 a- Determine the voltage reflection coefficient at the load. Determine the voltage at the load, determine the power Consumed by the load. b. what is the power reflection coefficient defined by the ration power reflected incident power
Simplified or ideal equivalent circuit representation of transmission line at RF consists of: a. R and C b. R, L, C and G c. Rand G d. Land C Characteristic impedance at RF frequencies is purely: a. conductive b. resistive c. inductive d. capacitive Radiation loss of a transmission line: a. independent of frequency b. increases with frequency c. decreases with frequency d. increases at some frequency range and then decreases with frequency
A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an inductance per unit length of 1 nH/m. The load impedance ZI is purely resistive. Both the load impedance and the generator impedance are 50 ohms. Source voltage amplitude is unknown at this point. Find the characteristic impedance and the propagation velocity for this transmission line!
1. On a lossless 500 coaxial transmission line with a shorted load: a. a voltage minimum will occur at the load. b. a current maximum will occur at the load. c. a voltage maximum will occur A/4 back from the load. d. the voltage and current are in phase. e. the voltage and current are 90° out of phase. f. the standing wave moves toward the source. 2. Sketch the TDR trace which would be observed by connecting a 100 ft. length of RG-8/U Type coax to a TDR and terminating the coax in a resistance of 100 ohms. Calculate and illustrate (show all parameter names and numeric values) the relative voltages of the incident and reflected waves and the 1 and 2-way time delays as illustrated in the file "For the final exam" emailed to you earlier this week. RG-8/U Type coax has the following specifications: Zo = 50 Ohm, VF 66%. 3. Determine Zin of a lossless 50 transmission line X/4 long having a ZL = 50 Q.
1. On a lossless 500 coaxial transmission line with a shorted load: a. a voltage minimum will occur at the load. b. a current maximum will occur at the load. c. a voltage maximum will occur A/4 back from the load. d. the voltage and current are in phase. e. the voltage and current are 90⁰ out of phase. f. the standing wave moves toward the source.
Transmission line with a load Zl = 100 + i80 ohm with characteristic impedance of Z0 = 5 ohm is designed. The transmission line operates at 100 MHz, where is matched with a shunt single- stub tuner. a)Calculate the stub positions. b)Calculate the stub length where open circuit stub is used. c) Calculate the stub length where short circuit stub is used.
For 860 MHz carrier frequency and for the geometry and graph shown in figures Q3A and Q3B, determine: A) the loss due to knife-edge diffraction, and
6. The short circuit load is connected to a transmission line. When the transmission line length is between lumped element. However, when zero and a quarter wavelength, the circuit will behave like the transmission line length is between a quarter wavelength and a half wavelength, the circuit will lumped element. behave like
Derive an expression for sag in a transmission line of equal height poles