A 100 ohm transmission line powered by a 1 GHz source and terminated with a load impedance of ZL = 60 + j50 ohms will be matched with an open-circuit series side. What should be the length, in cm, of the serial lateral line calculated using the Smith diagram?

A 100 ohm transmission line powered by a 1 GHz source and terminated with a load impedance of ZL = 60 + j50 ohms will be matched with an open-circuit series side. What should be the length, in cm, of the serial lateral line calculated using the Smith diagram?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.18P

See similar textbooks

Related questions

Q: A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL. According…

Q: Q1) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Given that Load impedance =80+j10 ohms Characteristic impedance=50 ohm frequency =550MHz

Q: A 100 ohm transmission line powered by a 1 GHz source and terminated with a load impedance of ZL =…

Q: The 50 ohm half wavelength lossless transmission line is terminated with a 60 ohm load impedance. If…

Q: )A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The…

A: here, the given line is the distortionless transmission line so, the condition of the distortionless…

Q: (5) Transmission-line analysis: A lossless transmission line of characteristic impedance Zo = 100 2,…

A: Given:Z0=100ΩVp=2×108m/slength, l=34 cmZL=30-j40Ωf=1 GHzλ=Vpfλ=2×108109λ=20 cmlength,l=1.7λ

Q: A transmission line with a characteristic impedance Zo = 50 Q requires an impedance matching network…

A: A transmission line is a network of conductors that sends electrical impulses from one location to…

Q: An 80 N transmission line operating at 12 MHz is terminated by a load Z1. At 22 m from the load, the…

A: 5. A lossless line is characterized as a transmission line that has no line obstruction and no…

Q: Use the analytical method, design a lossless L-section network to match a load impedance of 30+j150…

A: Given data, The load impedance of 30+j50Ω The value of Rs is 50Ω The value of the frequency is…

Q: A lossless transmission line of electrical length € = 0.32 is terminated with a complex load…

A: Given Data: electrical length l = 0.3 labda ZL = 20 - j 30 ohm Zo = 75 ohm

Q: ) Given a transmission line with a characteristic impedance of Za = 50 Ohms, determine the…

Q: A transmission line with a characteristic impedance Z, = 50 Q requires an impedance matching network…

Q: Q2: (Using Smith chart): Design lossless L-section matching circuits to match the load impedance of…

Q: A transmission line section and shows an input impedance of 36 2 and 64 respectively, when short…

A: Given, A transmission line section has, Input impedance when short circuited, Zsc=36 Ω. Output…

Q: O A transmission line operating at f = 1 GHz has Z0 = 100 N , a = 0.05 N„/m, ß = 1.5 rad/m. Find the…

A: Given Data: f = 1 GHz Zo = 100 ohm alpha = 0.05 Np/m beta = 1.5 rad/s

Q: A single-phase antenna transmission line with a length of 40 km and the load supplying with a…

A: Given data, The value of the length of the line is 40 km, The supply voltage with load is 200kV, The…

Q: The input impedance of a 31-cm-long lossless transmission line of unknown characteristic impedance…

Q: 10. A slotted line is used to measure VSWR of the load at 2 GHz by double minima method. If the…

A: Given f = 2GHz d2-d1 = 0.5 cm

Q: Generate an 80 MHz signal. A signal source is connected to an unknown impedance, z1, by a lossless…

Q: In a mismatched transmission line with intrinsic impedance of Z, and with a load of impedance of Z,…

A: A quarter-wave transformer is a basic impedance transformer used in impedance matching to reduce…

Q: Tt=3.14 For a Transmission line, L=6,4 nH/m, R=2,9 0/m, C=1,2 µF/m and G=8,5 S/m (f = 1 GHz). For…

A: According to the question we have to find the value of ZR.

Q: A 1 m long RG-58U type coaxial transmission line to be used at 2 GHz is terminated with a load…

A: We need to find out the input impedance.

Q: The lossless network given below is excited with a microwave source having frequency f=4,8 GHz.…

Q: Since the 35 ohm transmission line used at 2 GHz is terminated with a load impedance of 30.8(1 - j)…

Q: Since S = 2.5 in the 50 ohm transmission line used at 1.5 GHz and the distance to the minimum…

Q: At an operating frequency of 300 MHz, it is desired to use a section of a lossless 50 N transmission…

A: Transmission line

Q: A 5.2cm long, lossless 100Ω transmission line was terminated with a load of ?? = 30 + 50Ω. With the…

A: The load reflection coefficient is: So, the magnitude of the reflection coefficient is: 0.617 And,…

Q: Q1) Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming a…

A: Given: Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming…

Q: A 60-ohm distortionless transmission line has a capacitance of 0.15nF/m. The attenuation of the line…

A: Given data Z0=60 ΩC=0.15 nF/mα=1.15×10-3 Np/m i) Expression of characteristic impedance Z0=LC…

Q: 2.38 The input impedance of a 31 cm long lossless transmission line of unknown characteristic…

A: Given, l = 31 cm = 0.31 mf = 1 MHz = 106 HzL = 0.064 μH = 0.064 × 10-6 HC = 40 pF = 40 × 10-12 F…

Q: One end of an air lossless transmission line having the characteristic impedance of 75 Q and length…

A: Power generation, transmission, and distribution systems constitute a power system. The power…

Q: Q4) Use the analytical method, design a lossless L-section network to match a load impedance of…

A: Load impedance ZL=150+j30 Ωcharacterstic impedanceZ0=50 ΩFrequency f=500 MHz

Q: A distortionless transmission line with a characteristic impedence of 50 N, and the attenuation…

Q: Problem #5) An 80cm long, lossy transmission line has the following characteristics: Z = 752, Y =…

A: An 80 cm long, lossy transmission line has the following characteristics: Zo=75 Ω, γ=0.10+j2.876 The…

Q: A 30-m-long lossless transmission line with Z, = 50 N operating at 2 MHz is terminated with a load…

Q: The lossless network given below is excited with a microwave source having frequency f=3,2 GHz. For…

A: wave property of transmission Line: VsIs=coshγlZosinhγl1ZosinhγlcoshγlVrIr Where, Vs=Sending end…

Q: The lossless network given below is excited with a microwave source having frequency f=7,1 GHz. For…

A: Characteristics impedance of the given lossless network is determined as shown below

Q: A sinusoidal signal of 1 W average power is transmitted down 10 m of coaxial cable. of 0.1 mW is…

Q: A 602 lossless transmission line is terminated with an antenna of impedance of (27 + j30) Q. Use the…

Q: Q3: Derive an expression that defines the propagation constant y starting from the basic…

Q: A distortionless transmission line has a resistance per unit length of 0.5 ohm/m. If the…

A: For a transmission line, the following line parameters are present: Since the given transmission…

Q: For a medium transmission line, VRNL is equal to Vs. Select one: O True O False

A: sending end voltage will be same as no load receiving end only when capacitance effect is absent .…

Q: Given the Personal Communications Service (PCS) extension to the Hata Model with a measured…

Q: A 50-ohm lossless transmission line is terminated by a 100-ohm resistive load and is operated at 100…

Q: Since the 35 ohm transmission line used at 2 GHz is terminated with a load impedance of 30.8(1 - j)…

Q: For a Transmission line, draw the equivalent model & derive voltage and current expression. A…

A: Given: R= 0.1 ohm per meter G=0.02 mho per meter L=0.01 micro Henry per meter C= 100 pico Farad per…

Q: A 75 Q lossless transmission line is to be matched with a 100-j802 load using Single stub. Calculate…

A: Given :Z0=75 ΩZL=100-j80 ΩZL=128.06∠38.66° f=30 MHz

Q: What are (a) the values of the intercept points in the load line and (b) the slope of the load line…

Q: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

A: The lossless network given below is excited with a microwave source having frequency f=9,6 GHz. For…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 105MHz, 90 v peak signal is incident on a 50-ohm transmission line. The line is 125m long and is terminated in 300-ohm load. What is the SWR for this situation? Find the reflection coefficient.
Transmission line with a load Zl = 100 + i80 ohm with characteristic impedance of Z0 = 5 ohm is designed. The transmission line operates at 100 MHz, where is matched with a shunt single- stub tuner. a)Calculate the stub positions. b)Calculate the stub length where open circuit stub is used. c) Calculate the stub length where short circuit stub is used.
Which Transmission Line Parameter is neglected or ignored in most classifications of Transmission Line Equivalent Circuits? A. The Line Inductance B. The Line Resistance C. The Shunt Conductance D. The Shunt Capacitance
A lossless transmission line has a capacitance per unit length of 90 uF/m (microFarad/meter) and an inductance per unit length of 1 nH/m. The load impedance ZI is purely resistive. Both the load impedance and the generator impedance are 50 ohms. Source voltage amplitude is unknown at this point. Find the characteristic impedance and the propagation velocity for this transmission line!
b) A 6052 characteristic impedance transmission line is fed by a DC source of 100V with an internal resistance of 4002. The line is 200m long and has a dielectric constant of 2.25. The load impedance is 12002. Calculate: i. The load reflection coefficient. ii. The source reflection coefficient. iii. What is the voltage at the source terminals just before AND just after 2us?
g) Why the Capacitance effect is neglected in Short Transmission Line. h) Distinguish between Lumped or Distributed elements in a Transmission Line.
3 A 3-phase, 50 Hz transmission line 100 km long, Load current i 5A at 0-9 p.f.lagging and at 110 kV. The resistance and reactance of the line per phase per km are 0-2 Q and 0-42 respectively, while capacitance admittance is 2-5 * × 10- 6 siemen/km/phase. then magnitude of V1 is
4.) A 3-p, 50 Hz, 30-km transmission line supplies a load of 5 MW at p.f. 0.7 lagging to the receiving end where the voltage is maintained constant at 11 kV. The line resistance and inductance are 0.02 Q and 0.84 mH per phase per km, respectively. A capacitor is connected across the load to raise the p.f. to 0.9 lagging. Calculate: (a) the value of the capacitance per phase and (b) the voltage regulation.
"In medium transmission line modeling, which of the parameter is considered to be lumped?" Resistance Inductance Capacitance All options are correct
A 3 –phase 50 HZ transmission line have conductors of sections 90 mm2 and effective diameter of 1cm and are placed at the vertices of an equilateral triangle of side 1metre. The line is 20 km long and delivers a load of 10MW at 33kV and p.f 0.8. Neglect capacitance and assume temperature of 20 oC. Determine the efficiency and the regulation of the line
Ideally, a dc load line is a straight line drawn on collector characteristic curves between which of the following? Please select one: a. Q Point and shear b. Q Point and saturation c. V_CE (interrupt) and I_C (sat) d. I_b = 0 and I_B = I_C/ß_DC
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is