3- Use 74150s and any other logic necessary to multiplex 32 date lines on to a single date-output line ?
Q: 1) Implement a full adder with two 4 x 1 multiplexers. 2) Draw the logic diagram of a 2-to-4-line…
A: The solution of the following questions are
Q: Can you call a DECODER as a DEMUX? If yes, in which case that could be. Design a DEMUX using simple…
A: The major distinction between a demultiplexer and a decoder is that the former is a combinational…
Q: 2- A certain application requires that a four-bit binary number be decoder use 74154 decoders to…
A: All the 16 outputs are connected through a resistor and then an LED to serve as a 16 LED controller.…
Q: 1. Convert the following unsigned binary number to base-10 representation. (10100010)2 = ? 2.…
A:
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A: consider the given question;
Q: convert the BCD of (84)16 into 7-bit left to right odd parity hamming code????
A: BCD of (84)16 is 1000 0100 Now we have to convert both the BCD in hamming code. Firstly we will…
Q: 5. Simplify using Boolean rules and laws and implement the same and NOR Logic AB'+ A(B + C)' + B(B +…
A:
Q: QII Determine the modulus of the logic circuit (counter) shown in figure below and write its…
A:
Q: Sketch the RS-232 waveform that results from transmitting the binary value 10100011 over a…
A: Logic Waveform RS-232 the shown waveform pertains to the RS-232 port's Broadcast and Receipt lines.…
Q: 2- Construct a full-Adder logic circuit by using NAND gates only. 3- Construct a full- Subtractor…
A: The solution of the following questions are
Q: 1. What is the difference between synchronous binary counter and asynchronous binary counter? 2.…
A: 1. On the basis of applied clock speed, counters are of two types: Synchronous Counter Asynchronous…
Q: Implement 1-to-8line demultiplexer with active low enable input using logic gates
A: Demultiplexer:- It is a combinational circuit that is the inverse of the multiplexer. It performs…
Q: Course: Logic Circuit Design Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders…
A:
Q: Implement using full adder 3 × 8 complementary output decoder (decoder -74138 IC) and appropriate…
A: Explanation: The truth table for Full adder is A B C Sum Carry Decimal place 0 0 0 0 0 0 0 0…
Q: If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010, What…
A: Given 010101102 is the given binary number.
Q: 1- Implement ( without simplification) F= (A+B).(C+A.D) using NAND gates only. 2. Desion a logic…
A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.
Q: How many states will there be in a 4-bit ripple counter?
A: In an n-bit counter, the total number of states = 2n.
Q: . Determine the number of 2 INPUT NAND gates and ICS required for implementit function using NAND…
A: In a combinational circuit, the output only depends on the value of input as regards the previous…
Q: 1. Design 5 lines to 32 lines Decoder using IC# 74138. You can use other logic gates/IC, if…
A: 5×32 decoder
Q: a) Draw the SR latch using NAND gates and write the truth table. b) Convert the decimal NUMBER…
A:
Q: Implement the following Boolean function by using 4x1 multiplexer. ����(?, ?, ?, ?) =…
A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.
Q: 10.Draw the logic symbal for a NOT gate and create its truth table.
A:
Q: Q3/ A. Design 4-Bit Asynchronous counter the sequence for the 4-bit binary counter from 0000 through…
A:
Q: 5) An 8-bit register contains 10010110. What is the corresponding value (in decimal) if it…
A:
Q: Convert the given BCD number into decimal BCD 1010101001 Decimal b) Convert the given binary number…
A: 10102 = this will produce an error as it is decimal 1010 and not a valid BCD number BCD valid for…
Q: Perform the functions given below with the decoder given below and a suitable logic gate. F1(A,B,…
A:
Q: 2.) What is the decimal equivalent output of the register shown in the figure below N +5V LSB NAND…
A: Given is a D Flip Flop or Delay Flip Flop with nand gate. The output of delay flip flop is same as…
Q: 7406 7408 7432 7406 7408 Figure 5.1
A:
Q: (Logic Gates: * 7404LS (NOT) * 7408LS (AND) * 7432LS (OR) * 7400LS (NAND) * 7402LS (NOR) * 7486LS…
A:
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A:
Q: Figure 3 Figure 1 21 21 DE Figure 4 Figure 2 21 Figure 5 JSE THE TRUTH TABLE TO JUSTIFY THE LOGIC…
A: Given With the help of truth table for all the given figures we calculated the output equation…
Q: Determine the truth table of the digital circuit shown in the figure below and explain its…
A: A bipolar junction transistor (BJT) is a current-controlled switch. The current between the…
Q: What will be the truth table of 2 input NAND gate?
A: NAND gate comes in category of universal gate. It is basically the negation of AND gate.
Q: Convert decimal number 54.3125 to fixed point binary notation. How many bits are needed? Suppose…
A:
Q: How many address pins are required for a 256T x4 DRAM chip not counting RAS and CAS?
A:
Q: ألست أنت muslyy22@gmail.com؟ تبديل الحساب طلبتنا الاحبة. . .النموذج يحتوي سؤالین يتم الاجابة عليها…
A:
Q: Represent the BCD number 11101010 in Decimal, then convert the Decimal to Binary, and lastly convert…
A: The given BCD number 11101010 is represented in decimal is,…
Q: Convert (11011) gray code to binary number?
A:
Q: 3. Convert the following fixed point unsigned binary fractional number to base-10 representation.…
A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The…
Q: Write the truth table of 3 to 8 line decoder and derive the Boolean expression and finally draw the…
A:
Q: Q5/ construct serial counter using PRE/CLR input flip flop that count in the following sequence…
A:
Q: a-Con for the following circuit and idlentify that canste replace the circuit? single logic gate. A.
A:
Q: Draw the logic diagram of 2 * 4 line decoder using a. NOR Gates only b. NAND Gates only Indicate…
A: To Draw the logic diagram of 2 * 4 line decoder usinga. NOR Gates onlyb. NAND Gates onlyIndicate…
Q: What will happen if the function v(w+x+y)z would be implemented using NOR gates? none of these given…
A: given here a multiple choice question and asked to find the solution for it with explaination.
Q: Discussion: 1. What are the advantages of PCM system over other types of modulation systems? 2. What…
A: As per Bartleby guidelines we are allowed to solve only one question, please ask rest again.
Q: The following serial data stream is to be generated using a J – K positive edge – triggered Flip –…
A:
Q: (b) Draw a block diagram of 3 bit synchronous binary counter.
A: 3-bit binary synchronous counter design :
Step by step
Solved in 2 steps with 1 images
- 3. Draw the block diagram of an 8255 PPI chip and describe its different programming modes. Configure 8255 as follows: port A as output, B as input, and all the bits in port C as output. Determine the content of the Control Register and program the 8255 to get data from port B and send it to both port A and port C. (Assume the standard port addresses of 8255)Problem #4: Consider the Programmable Array Logic PAL module below '1' A B C D F₁ F2 F3 1. Determine the corresponding product term per row PRODUCT TERMS 000000What does a binary digital signal consist of?
- Q.19 Draw logic diagram for 4 to 1 line multiplexer. Q.20 Draw logic diagram for 1 to 4 line de-multiflexer.4) Draw a logic diagram of a divide-by-14 counter using IC 7493 and 2-input AND gate.2) Convert Hexa-decimal to Octal a. 7E6A(16)=?(8) b. C350(16)=?(8) c. 9E36.7A(16)=?(8) d. EADD.EBEF(16)-?(8)
- Q2) A) Based on the count sequence and decoding operations of 74LS90S ICs shown in Figure below. Q2) B) Use the SAR ADC to convert the analog voltage of (7.28 V) to 8-bit binary. If (VREF = 10V), determine the final %3D binary answer and the percent error. 01011101, 0.1974588% 11011101, 0.1974588% 01011111, 0.1974588% 01111101, 0.1974588%What is a transmission gate? Draw its circuit circuit diagram. How does it operate? What is the need for a transmission gate? What is it disadvantage?What is interface. What is program block and module block.
- 1. Implement 8-to-1 multiplexer with active low enable input using Logic Gates.QUES1.) Write instructions to perform the following operations: (8051)(i) Move the content of Accumulator to register 7(R7).(ii) Move the contents of RAM memory location 55H to Port 1(iii) Receive content from ROM Memory location 200H into Accumulator.(iv) Clear bit 7 of the Accumulator. [NOTE: ANSWER OF ALL 4 PARTS IS NEEDED.]An ADC has a 0 to 14.5-volt input with a(n) 13-bit output. What would the binary value 00..0111 represent (in mV to two decimal places)?