10.Draw the logic symbal for a NOT gate and create its truth table.
Q: 1) Implement a full adder with two 4 x 1 multiplexers. 2) Draw the logic diagram of a 2-to-4-line…
A: The solution of the following questions are
Q: 2- A certain application requires that a four-bit binary number be decoder use 74154 decoders to…
A: All the 16 outputs are connected through a resistor and then an LED to serve as a 16 LED controller.…
Q: 3.(a) Make a truth table for this given logic gate, as shown in the figure. Show the steps. What is…
A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Which of the following logic valve is known as shuttle valve? O a. NOR gate O b. OR gate O C. AND…
A: i have explained in detail
Q: You construct a gate level program using the provided circuit schematic. How many different logic…
A: The given circuit diagram is shown below,
Q: Draw the implementation of decoding of binary state 5, and binary state 3 for a 3- bit synchronous…
A: Flip flop is a latch with additional control input (clock or enable ). A flip flop is used to store…
Q: A B 2
A: The given data is as follows:-
Q: Question 5 With reference to 8086 Microprocessors Pin Assignment: 1) State the three groups of…
A:
Q: The 8085-instruction set does not include a Clear Carry instruction. Which single-byte logical…
A: The 8085-instruction set does not include a Clear Carry instruction but it has set carry and…
Q: Assume that the exclusive-OR gate has a contamination delay of 10 ns and that the AND or OR gates…
A:
Q: llustrate how external hardware interrupt on INTR pin of 8086/88 is tackled?
A: INTR is a type of maskable interrupt(means we can control or mask whenever any interrupt is…
Q: Explain how to find the physical address in a segment from the logical address for 8086…
A: The physical address plays a vital role to enable the data bus . it is also called as real address…
Q: 1. What is the difference between synchronous binary counter and asynchronous binary counter?
A: Note:Dear student here you have posted multiple question in sigle request.We will solve first…
Q: 10. What type of data (serial or parallel) is enabled by a low mode control input? Parallel Data…
A: by observing the above circuit ,it can be seen that the and gate to which the parrallel data input…
Q: Please circle whether following statements are True or false. (a) In Moore machines, more logic…
A: In this question we need to check the given statement is true or false
Q: The 8085-instruction set does not include a Clear Carry instruction. Which single- byte logical…
A: I'm this question we will write instruction of clear Carry flag...
Q: 4. What veltage do you espect to see at a floating TTL gate output?
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: Discuss the pin diagram of any logic gate? Explain how the NAND gate can be used to derive the other…
A:
Q: A 4 bit binary count have terminal count of?
A:
Q: Explain the function of Multiplexer and, Draw the 2 x 1 multiplexer logic circuit diagram and…
A:
Q: Draw the logic diagram for OR gate using NOR gates.
A: OR gate Let A and B are the two inputs of the OR gate and output Y = A + B
Q: 4. For the NOR gate function shown below A Da B. Do a) Write the switching expression for the…
A:
Q: (a) Design a ripple (Asynchronous) counter that counts from 5 to 13 using JK flip flops and any…
A:
Q: Design and Implement a 4-bits Asynchronous counter which counts odd numbers only. Show all the…
A: To design a 4-bits asynchronous counter which count odd number only. Means the sequence will be 1→ 3…
Q: (e) Draw the LOGIC diagram of a SR Latch using NOR gates and write the truth table
A: In this question we need to draw logic diagram of SR latch using NOR gates and write it's truth…
Q: What is the 8085 Assembly Language Instruction That do the follwing The contents of a memory…
A: LHLD. The LHLD instruction copies the contents of a specified memory location pointed out by a…
Q: What is the one-bit half adder's purpose? What is the total number of inputs and outputs? What logic…
A:
Q: Perform the functions given below with the decoder given below and a suitable logic gate. F1(A,B,…
A:
Q: What will be the truth table of 2 input NAND gate?
A: NAND gate comes in category of universal gate. It is basically the negation of AND gate.
Q: Q.9 Draw the logic diagram and timing diagram for the 3-stage synchronous binary counter. Verify…
A: A counter is a sequential circuit whose state represents the number of clock pulses fed to the…
Q: 26. Draw the logic diagram for a modulus-18 Juhnson counter. Show the timing diagram and write the…
A: A Johnson counter will produce a modulus of withnumber of stages or the flip-flops in the counter.…
Q: 3- Use 74150s and any other logic necessary to multiplex 32 date lines on to a single date-output…
A: Step1 In this question, we have to design 32*1 Mux using 16*1 Mux (74150) and logic gates. To design…
Q: Q5. (a) Convert the following logic gate circuit into a Boolean expression, writing Boolean…
A: NOT GATE:- A⇒A¯ AND GATE:- A, B⇒A.B NAND GATE…
Q: Design 3 systems that represent minterm 30 for a 5-input system: 1.-using logic gates, with a…
A: According to the question, we need to design 3 systems that represent minterm 30 for a 5-input…
Q: Fill-in the blank boxes with the correct LOGIC GATE/ Full/Half Adder
A: The given circuit is a 4-bit subtractor, whenever we perform subtraction, the subtrahend should be…
Q: Design a 3-bit Gray code counter. Counter have to be run, reversely.
A: The solution is given below
Q: Q5. (a) Convert the following logic gate circuit into a Boolean expression, writing Boolean…
A:
Q: Please write equations for both the pull up and pull down of the complex gate. Note: these are not…
A: The equations are
Q: (2) Draw the symbol and write the property of NAND and EX-OR logic gates
A: Given:- NAND Gate EX-OR Gate
Q: is there a way for the output voltage of a comparator to be the same as its supply voltage? im…
A:
Q: Q4/ design synch. Counter using T flip flop and any extra logic cct's needed to count the sequence…
A:
Q: Consider a family of logic gates that operate under the static discipline with the following voltage…
A: We need to find out voltage for different conditions .
Q: why the XOR gate output corresponds to the sum bit, while the AND gate output corresponds to the…
A: In this question we will discuss why I some bit are XOR gate and carry AND gate.
Q: Draw the logic diagram of 2 * 4 line decoder using a. NOR Gates only b. NAND Gates only Indicate…
A: To Draw the logic diagram of 2 * 4 line decoder usinga. NOR Gates onlyb. NAND Gates onlyIndicate…
Q: 5.3 A clock signal as a continuous sequence of pulses is applied to a logic gate and is to be…
A: Given a clock signal (clk) of continuous pulses is applied to logic gate i.e I am taking this clock…
Q: or the multiplexer circuit shown in Figure below. is performed by these multiplexers?
A:
Step by step
Solved in 3 steps with 2 images
- A d. B Figure 1 3. Referring to the logic circuit in Figure 1, determine: a. The simplified Boolean expression. b. The output waveform. C H c. Due to fabrication errors, lines d and f were shorted to the supply voltage. What happens to the output of the circuit? d. Your hardware resources are limited to 2-input NOR gate only. Draw the gate schematic of the simplified Boolean expression in 3(a).d) Draw the schematics of 4-bit synchronous and asynchronous MOD-8 counters and comment on their pros and cons. e) Calculate the noise margin for a logic gate with the following logic levels: VIL = 1.1 V, VIH = 3.2 V, VOL = 0.6 V, VOH = 4.0 V.Explain the function of Multiplexer and, Draw the 2 x 1 multiplexer logic circuit diagram and function table. How many selection inputs are required for a 4096 x 1 Multiplexer?
- Electrical Engineering Design a three input NOR layout so that rise time and fall time become equal when input logic switches from (111) to (000) and again to (111)? 10The logic circuit: (From minimum SOP) Number of gates used in the circuit: 2-Input AND gate.. 2-Input OR gate. NOT gate Number of idle gates in the chip: 2-Input AND gate 2-Input OR gate... NOT gute The logic circuit: (From minimum POS) gates gates gates gates gutes Number of gates used in the circuit: 2-Input AND gate 2-Input OR gate... NOT gate Number of idle gates in the chip: 2-Input AND gate... 2-Input OR gate, NOT gate, IC name: IC name: IC name: gates IC name: gates IC name: gates IC name: gates gates gateschoose the correct answer If a two-input logic gate produces a output of logic HIGH, only if both inputs are different, then the logic gate is? a. IC 7400 b. IC 7486 c. IC 7408 d. IC 7432
- 4- Design the logic circuit of 4-to16 decoder using basic logic gates. Find its truth table and logic diagram. 5- What is the purpose of encoder circuit? 6- What is the purpose of decoder logic circuits?Consider a family of logic gates that operate under the static discipline with the following voltage thresholds: VI=1.5V, VOL=0.5V, VIH=3.5V, and VOH=4.4V. a. What is the lowest voltage that can be output by an inverter for a logical 1 output? Explain. b. What is the highest voltage that must be interpreted by a receiver as logical 0? Explain. c. What is the lowest voltage that must be interpreted by a receiver as logical 1? Explain.Consider a family of logic gates that operate under the static discipline with the following voltage thresholds: VI=1.5V, VOL=0.5V, VIH=3.5V, and VOH=4.4V. a. What is the lowest voltage that can be output by an inverter for a logical 1 output? b. What is the highest voltage that must be interpreted by a receiver as logical 0? c. What is the lowest voltage that must be interpreted by a receiver as logical 1?
- The numbers from 0-9 and a no characters is the Basic 1 digit seven segment display * .can show False True In a (CA) method of 7 segments, the anodes of all the LED segments are * "connected to the logic "O False True Some times may run out of pins on your Arduino board and need to not extend it * .with shift registers True False2. It is the power available from power supplies that is consumed by the logic gate. 4. Identify the input pins of quad 2-input XOR gate IC.Draw a 14 ic chip wiring diagram with labeled switches(A, B, C) of a 3 input of this logic diagram.