An Introduction to Thermal Physics
1st Edition
ISBN: 9780201380279
Author: Daniel V. Schroeder
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Question
Chapter A.1, Problem 6P
To determine
To Calculate: The wavelength of the electron beam and corresponding voltage that is used to accelerate the electrons.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
In the experiment shown in Figure A.3, the effective slit spacing was 6 μm and the distance from the "slits" to the detection screen was 16 cm. The spacing between the center of one bright line and the next (before magnification) was typically 100 nm. From these parameters, determine the wavelength of the electron beam. What voltage was used to accelerate the electrons?
Coherence Length. Show that light of narrow spectral width has a coherence length l.
12/AX, where AX is the linewidth in wavelength units. Show that for light of broad uniform
spectrum extending between the wavelengths Amin and Amax = 2Amin, the coherence length
le = Amax.
We are looking to have a brief overview of transmission
electron microscope (TEM).
a.
What is the function of the electron gun in TEM?
b. !
What is the major signal in TEM?
What should be the thickness of sample measured by TEM?
-] What kind of information is provided by TEM?
]What is the minimum resolution reported for TEM?
s] What is the main difference between electron microscopy
C.
d.
e.
f.!
and probe microscopy?
Chapter A Solutions
An Introduction to Thermal Physics
Knowledge Booster
Similar questions
- 6.10. A certain material having atomic radius of 1.5 Å can exhibit either an FCC or BCC structure in the thin film state. A thin film of this material showed diffraction peaks at 20 = 52.85° and 125.50° un- der the 0-20 scan performed using an X-ray beam at 1.54 Å. What are the structure and out-of-plane orientation of this film?arrow_forwardIf a missile emits 5×106 W of power in the 2.65 - 2.80 μm band, estimate the energy collected by a detector at a range of 6.0 Earth-radii away from the target. Assume the detector has a light gathering area of 0.8 m2 and an integration time of 0.1 sec. Take the radius of the Earth to be 6371 km. Use scientific notation for your answer (e.g. 1.2×10-34 = 1.2E-34). The energy collected by the detector in 0.1 second is how many Joules?arrow_forwardThe figure below shows a graph of intensity as a function of angle for X-ray diffraction in a given crystal.X-ray diffraction in a given crystal. The beam consists of two wavelengths, and the spacing between thereflection planes is 0.94 nm. What are these wavelengths?arrow_forward
- Determine the maximum wavelength of thephoton that hydrogen in the excited stateni = 6 can absorb. The energy of the groundstate of hydrogen is −13.6 eV, the speed oflight is 2.99792 × 10^8 m/s and Planck’s constant is 6.62607 × 10^−34 J · s.Answer in units of nm. What would be the next smaller wavelengththat would work?Answer in units of nm.arrow_forwardAssume that the incident x-ray beam in the figure below is not monochromatic but contains wavelengths in a band from 95.0pm to 139pm. Will diffracted beams, associated with planes shown, occur? If so, what wavelengths are diffracted? Assume d=275pm. (where pm-picometer = 10-¹² meters). Incident beam direction 42.2° darrow_forwardThe minimum amount of energy required to energize a particle from its ground state to first excited state is 1*10^4 eV. One photon source P1 corresponding to X ray wavelength 1nm and another photon source p2 corresponding to visible light wavelength 500 nm are available. As a physicist, which one of these photons would you choose for energizing the atom?Draw a neat diagram to show the procedure and show your calculations in detail.arrow_forward
- The width of the central bright fringe in a diffraction pattern on a screen is identical when either electrons or optical light pass through a single slit. The distance between the screen and the slit is the same in each case and is large compared to the slit width. If the wavelength of the optical light is 552 nm, how fast are the electrons moving?Give your answer in units of m/s, accurate to 2 decimal placesarrow_forwardCalculate the wavelength (in nm) for a photon with a frequency of 3.70e+15 Hz.?arrow_forwardA single beam of electrons shines on a single slit of width 3.3nm. A diffraction pattern (of electrons!) is formed on a screen that is 2.1m away from the slit. The distance between the central bright spot and the first minimum is 2.1cm.What is the speed (m/s) of the electrons?Make use of the small angle approximation.arrow_forward
- The half value layer (HVL) of a material is defined as the thickness of the material needed to reduce the intensity of the incident x-ray beam to half its value. Assume that the x-ray beam is monochromatic, no scattering occurs and that material A (as shown in Figure 1) is. homogeneous and has a linear attenuation coefficient (u.). Material A has an HVL of 1.5 mm. Calculate the ratio l/lz as shown in Figure 1 if x-5 mm. lo HA=?? 2x Figure 1: Schematic diagram fr question 3.arrow_forwardA linear particle accelerator using beta particles collides electrons with their anti-matter counterparts, positrons. The accelerated electron hits the stationary positron with a velocity of 77 x 10° m/s, causing the two particles to annihilate. If two gamma photons are created as a result, calculate the energy of each of these two photons, giving your answer in MeV (mega electron volts), accurate to 1 decimal place. Take the mass of the electron to be 5.486 x 104 u, or 9.109 x 1031 kg. Note: Assume that the kinetic energy is also converted into the gamma rays, and is included in the two photons.arrow_forwardCalculate the wavelength corresponding to an electron with the energy of 104 eV (kiloelectronvolt). Give your answer in Angstrom (10-10 m, for example, if the answer is 1.6x10-10 m, then write 1.6 as your answer). This should give you a good idea why one can use a crystal lattice with an average interatomic distance of around 10-10 m to observe electron diffraction.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Modern PhysicsPhysicsISBN:9781111794378Author:Raymond A. Serway, Clement J. Moses, Curt A. MoyerPublisher:Cengage Learning
University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Modern Physics
Physics
ISBN:9781111794378
Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher:Cengage Learning
University Physics Volume 3
Physics
ISBN:9781938168185
Author:William Moebs, Jeff Sanny
Publisher:OpenStax
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers with Modern ...
Physics
ISBN:9781337553292
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning