Traffic and Highway Engineering
5th Edition
ISBN: 9781305156241
Author: Garber, Nicholas J.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Question
Chapter 7, Problem 8P
To determine
The realignment of T-intersection of the State route
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
55 mph roadway with two northbound through lanes (both are 11 feet in width) through an intersection. Beyond the intersection, the lanes merge into one lane. Please calculate the merge taper AND the distance the sign must be place AHEAD or upstream of the beginning of the merge.
Pls hand written solution
A six-lane freeway (three lanes in each direction) in mountainous terrain has 10-ft lanes and obstructions 5 ft
from the right edge. There are zero ramps within three miles upstream of the segment midpoint and one ramp
within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuters with
a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the
level of service?
A developer has applied for a construction permit to build a supermarket at the southeast cornerof an intersection that is formed by a four-lane divided highway in the east-west direction and atwo-lane road in the north-south direction. Traffic on the two-lane road is controlled by a stop signat the intersection. The speed limit on the four-lane highway is 88 km/h. using the sight trianglerequirements at the intersection (Case B1), determine whether permission should be given for theconstruction if the following conditions exist. Provide a diagram for your solution.Major road lane width = 3.6 mMinor road lane width = 3.3 mMedian lane = 2.8 mDesign vehicle is a passenger carApproach grade = 2%Maximum feasible distance building from the center of the nearest lane of four-lane road = 5.4 mMaximum feasible distance building from the center of the nearest lane of two-lane road = 16.5 m
Chapter 7 Solutions
Traffic and Highway Engineering
Ch. 7 - Prob. 1PCh. 7 - Prob. 2PCh. 7 - Prob. 3PCh. 7 - Prob. 4PCh. 7 - Prob. 5PCh. 7 - Prob. 6PCh. 7 - Prob. 7PCh. 7 - Prob. 8PCh. 7 - Prob. 9PCh. 7 - Prob. 10P
Ch. 7 - Prob. 11PCh. 7 - Prob. 12PCh. 7 - Prob. 13PCh. 7 - Prob. 14PCh. 7 - Prob. 15PCh. 7 - Prob. 16PCh. 7 - Prob. 17PCh. 7 - Prob. 18PCh. 7 - Prob. 19PCh. 7 - Prob. 20PCh. 7 - Prob. 21PCh. 7 - Prob. 22PCh. 7 - Prob. 23PCh. 7 - Prob. 24PCh. 7 - Prob. 25PCh. 7 - Prob. 26PCh. 7 - Prob. 27PCh. 7 - Prob. 28P
Knowledge Booster
Similar questions
- 6.3 A four-lane freeway (two lanes in each direction) is located on rolling terrain and has 12-ft lanes, no lateral obstructions within 6 ft of the pavement edges, and there are 2 ramps within 3 miles upstream of the segment midpoint and 3 ramps within 3 miles downstream of the segment midpoint. A weekday directional peak-hour volume of 1800 vehicles (familiar users) is observed, with 700 arriving in the most congested 15-min period. If a level of service no worse than C is desired, determine the maximum number of heavy vehicles that can be present in the peak-hour traffic stream.arrow_forward6.3 A four-lane freeway (two lanes in each direction) is located on rolling terrain and has 12-ft lanes, no lateral obstructions within 6 ft of the pavement edges, and there are 2 ramps within 3 miles upstream of the segment midpoint and 3 ramps within 3 miles downstream of the segment midpoint. A weekday directional peak-hour volume of 1800 vehicles (familiar users) is observed, with 700 arriving in the most congested 15-min period. If a level of service no worse than C is desired, determine the maximum number of heavy vehicles that can be present in the peak-hour traffic stream. (Ans 322)arrow_forwardA six-lane urban freeway (three lanes in each direction) is on rolling terrain with 11-ft lanes, obstructions 2 ft from the right edge of the traveled pavement, and nine ramps within three miles upstream and three miles downstream of the midpoint of the analysis segment. The traffic stream consists primarily of commuters. A directional weekday peak-hour volume of 2300 vehicles is observed, with 700 vehicles arriving in the most congested 15-min period. If the traffic stream has 15% large trucks and buses and no recreational vehicles and at some point, further along the roadway there is a 6% upgrade that is 1.5 mi long. (assuming that the proportion of vehicle types and the peak-hour factor remain constant) Determine the FFS value in mi/hDetermine the PHF or Peak Hour FactorDetermine the fHVDetermine the value of vparrow_forward
- Draw the intersection diagram for a given traffic volume summary of a T intersection and design the most appropriate and logical phasing pattern for the unsignalized intersection.arrow_forwardThe following diagram illustrates the number of conflicting points at a 4-approach unsignalized intersection with one lane for each approach. The conflicting points are classified as points for merging, diverging, and crossing. How many conflict points will there be if the intersection geometry is changed to two off-set “T” intersections? Scratch your solution and label all conflicting points by classification.arrow_forwardA two-lane minor road intersects a two-lane undivided major road at 90 degrees, forming a four-leg intersection with traffic on the minor road controlled by a yield sign. A building is located 50 m from the center line of the outside lane of the major road and 14 m from the center line of the nearest lane of the minor road. A passenger car on the minor road would like to cross the major road. Using the AASHTO procedure, determine the maximum speed that can be allowed on the minor road if the design speed on the major road is 80 km/h. Assume a 3% approach grade for the minor road. Note: 1km/hr = 0.62mi/h, 1ft = 0.3048marrow_forward
- (TRAFFIC AND HIGHWAY ENGINEERING) An undivided multilane highway segment has two 11-ft lanes in the eastbound direction with no shoulders and a 55 mi/h speed limit. This highway segment has 40 access points on a 1.25-mile, 2.5% upgrade. During the highest 15 minutes of traffic flow within the peak hour, there are 755 vehicles and 12% of these are heavy vehicles with a 70%/30% mix of single-unit and tractor-trailer trucks. What are the estimated speed, density, and LOS of upgrade?arrow_forwardA six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLW = 6.0 mph) 4 ft from the right edge of the traveled pavement (fLC = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). What is the estimated free-flow speed of the traffic stream in mph (whole number, nearest 5)? What is the peak-hour factor (3 decimal places)? What is the heavy-vehicle adjustment factor (2 decimal places)? What is the service flow rate (whole number, nearest 5)? What is the service measure value if the average speed of the traffic stream is 65 mph (one decimal place)?arrow_forwardA six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLW = 6.0 mph) 4 ft from the right edge of the traveled pavement (fLC = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). What is the peak-hour factor (3 decimal places)arrow_forward
- An eight-lane freeway (four lanes in each direction) is on rolling terrain and has 11-ft lanes with a 4- ft right-side shoulder. The total ramp density is 1.5 ramps per mile. The directional peak-hour traffic volume is 5400 vehicles with 11% heavy vehicles. The peak 15-minute volume is 1421 vehicles. What are the freeway’s density and level of servicearrow_forwardA six-lane freeway (three lanes in each direction in mountainous terrain has 10-ft lanes and obstructions 1ft from the right edge. There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuter with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service?arrow_forwardA six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLw = 6.0 mph) 4 ft from the right edge of the traveled pavement (fic = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). 1.) What is the estimated free-flow speed of the traffic stream in mph (whole number, nearest 5)? 2.) What is the peak-hour factor 3.) What is the heavy-vehicle adjustment factor? 4.) What is the service flow rate? 5.) What is the service measure value if the average speed of the traffic stream is 65 mpharrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning