Automotive Technology: Principles, Diagnosis, And Service (6th Edition) (halderman Automotive Series)
6th Edition
ISBN: 9780135257272
Author: James D. Halderman
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 7, Problem 6CQ
Used engine oil should be disposed of by all except the following methods.
- a. Disposed of in regular trash
- b. Shipped offsite for recycling
- c. Burned onsite in a waste oil-approved heater
- d. Burned offsite in a waste oil-approved heater
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Why does a turbine blade which breaks during the operation of an aeroengine need to be contained within the engine itself?
O a.
So that the material can be recycled
b.
So that any debris does not damage the main body of the aircraft
O c.
So that it does not fall onto a populated region on the ground
d.
So that it can burn in the hotter section of the engine
Clear my choice
Which of the following statements about fuel cells is NOT true?a. A single fuel cell produces very low voltage, normally less than one volt.b. A fuel cell produces electricity through an electro-chemical reaction that combines hydrogen and oxygen to form water.c. A fuel cell is composed of two electrodes coated with a catalyst and separated from each other by an electrolyte and from the case by separators.d. In a fuel cell, catalysts are used to ignite the hydrogen; this causes a release of electrons or electrical energy.
Types of engine oil
Chapter 7 Solutions
Automotive Technology: Principles, Diagnosis, And Service (6th Edition) (halderman Automotive Series)
Ch. 7 - List five common automotive chemicals or products...Ch. 7 - The Resource conservation and Recovery Act (RCRA)...Ch. 7 - What methods need to be used when handling...Ch. 7 - How should used engine oil be disposed?Ch. 7 - Prob. 5RQCh. 7 - Hazardous materials include all of the following...Ch. 7 - To determine if a product or substance being used...Ch. 7 - Exposure to asbestos dust can cause what...Ch. 7 - Wetted asbestos dust is considered to be...Ch. 7 - An oil filter should be hot drained for how long...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that used engine coolant should be collected and recycled. Technician B says that all oil- based waste materials can be collected in the same container if an approved waste disposal company is hired to rid the shop of the oil. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardThe most common fuel oil used for residential and light commercial is A.Number 1. B. Number 2. C. Number 3. D. Number 4.arrow_forwardWhich of the following statement is correct according to the Wind Energy Conversion System? O a. Low speed high torque shaft is connected to wind turbine, high speed low torque shaft is connected to generator O b. Low speed high torque shaft is connected to generator, high speed low torque shaft is connected to wind turbine O c. Low speed high torgue shaft is connected to wind turbine, high torque low speed shaft is connected to generator O d. Low speed high torque shaft is connected to generator, high torque low speed shaft is connected to wind turbinearrow_forward
- d. Check oil level & moisture content 19. If the main wire (coil) to the distributor and the coil to the switch are broken, replace them and make sure the connections are clean and tight relevant to a. Breaking system b. Ignition system c. Ventilation system d. Combustion system 20. The required gap in ignition system between---------- a.-4 to 5 b.-0.4 to 5 c.-0.4 to 0.5 d.-4 to 0,5 |21. Which of the following is the fouled of spark plug a. Soot b. Oil c. Over heated d. All of the above |22.The suitable thread of spark plug for heavy engine is a. M19 b. M18 c. M15 d. M16 23. Using a Torque wrench, tighten the plugs to the specified torque. (Most) 4mm plugs are torqued to four kilograms per square inch. a. True b. False 24. Start the engine and evaluate its performance refers to a. Weekly Maintenance b. Annually Maintenance c. Daily Maintenance d. None of them 25. Check to see if Dynamo is working properly. If necessary, adjust the regulator refers to a. Weekly Maintenance b. Annually…arrow_forwardWhat is the major advantage of using propane or natural gas?arrow_forwardWhat two elements make up fuel oil?arrow_forward
- As the rank of the coal increases, the moisture content _________ a. increases b. decreases c. no direct changearrow_forwardWhat is required for a combustile mixture A. OXYGEN B. FUEL C. WATER PUT CHECK MARK OR CROSS MARK TO THE LETTERarrow_forwardOctane number is the measure of a fuel's ability to resist knocking. The higher the octane number, the more compression the fuel can withstand before detonating. True Falsearrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Welding: Principles and Applications (MindTap Cou...
Mechanical Engineering
ISBN:9781305494695
Author:Larry Jeffus
Publisher:Cengage Learning
Materials Science Mechanical Engineering - Part 3 Corrosion Explained; Author: Mega Mechatronics;https://www.youtube.com/watch?v=Il-abRhrzFY;License: Standard Youtube License