Sustainable Energy
2nd Edition
ISBN: 9781337551663
Author: DUNLAP, Richard A.
Publisher: Cengage,
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 6, Problem 9P
To determine
Find the flow rate of the water in kg/s.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
An engine absorbs 100 J and rejects 60 J in each cycle. (a) What is its efficiency?
(b) If each
cycle takes 0.5 s, find the power output of this engine in watts.
If the energy present in a jet of water of 20 cm diameter and having a velocity of 25 m/s could be extracted by a device with 90% efficiency, the power extracted would be nearly.
sec²
m
tak ing
1
2g
0.051
A certain brand of hotdog cooker works by applying a potential difference of 146 V across opposite ends of a hot dog and allowing it to
cook by means of the thermal energy produced. The current is 12.8 A, and the energy required to cook one hot dog is 60.8 kJ. If the
rate at which energy is supplied is unchanged, how long will it take to cook three hot dogs simultaneously?
Number
i
Units
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.Similar questions
- A piston cylinder device contains 5 kg hydrogen gas. Heat is transferred to the hydrogen as the temperature increases by 23.28 F. What is the boundary work done during this process kW.arrow_forwardA diesel engine required 9,800 kJ of heat to produce 1,800 kJ of power. What is its efficiency?arrow_forwardA coal-fired power plant discharges 1 m^3/s of cooling water into a river, which has a flow of 9 m^3/s and a temperature of 20 degree C. According to the regulation, the temperature in the river immediately below the discharge cannot be increased by higher than 1 degree C. Therefore, what is the highest temperature of the cooling water is allowed for discharge?arrow_forward
- 3. A storage tank with a surface area of 35 m² and a wall thickness of 100 mm contains 2000 kg of hydrogen gas at a concentration of 110 kg/m³. The atmosphere outside the tank has a hydrogen concentration of 0.2 kg/m³. If D = 8×10-¹¹ m²/s, how long will it take (in years) for 4% of the hydrogen to diffuse out of the tank? Assume steady-state conditions.arrow_forwardA turbine generates the power of 150,000 kW while working at the speed of 300 rpm at the head of 100 m. What is the specific speed of the turbine?arrow_forwardA volume tank 9m in a diameter and 1.20 m high fill water 20°C in 14 minutes and 6sec. what is the volume flux? And the mass flux (in kilograms per second).arrow_forward
- An automobile has an average power of 22 kW/hour for a trip. By a thermal efficiency of 30% how much fuel energy was used? What happened to all the energy? What change in entropy occurs when assuming ambient at 2000 C?arrow_forwardA refrigerator absorbs 5 kJ of energy from a cold reservoir and rejects 8 kJ to a hot reservoir. (a) Find the coefficient of performance of the refrigerator. (b) The refrigerator is reversible and is run backward as a heat engine between the same two reservoirs. What is its efficiency?arrow_forwardA 60 MW steam power station has a thermal efficiency of 30%. If the coal burnt has a calorific value of6950 kcal/kg, calculate :(i) the coal consumption per kWh,(ii)the coal consumption per day.arrow_forward
- A certain parallel-plate capacitor is filled with a dielectric for which K = 6.50. The area of each plate is 0.0524 m², and the plates are separated by 2.97 mm. The capacitor will fail (short out and burn up) if the electric field between the plates exceeds 179 KN/C. What is the maximum energy that can be stored in the capacitor? Number i ! Units Jarrow_forwardThe concentration of chlorine in a water tower tank was 2 mg/L when the tower was taken out of service. If the chlorine decays by first-order kinetics with a rate constant of 1.0 1/d, what is the chlorine concentration when the tank is put back in service 8 hours later? What mass of chlorine in kg must be added to the tank to raise the chlorine level back to 2 mg/L. (Assume completely-mixed tank).arrow_forward2. With an initial pressure of 30x105 Pa and constant operating temperature of 200°K in a 40 m³-tank containing ethylene and connected through a long pipe with a length of 1500 m and a diameter of 0.2 m to a reactor operating at atmospheric pressure. a. Calculate the volumetric flow in m3/s to the reactor when the valve is opened. b. Calculate the time needed to halve the pressure in the tank. c. Calculate the mass of gas discharged from the tank from the condition of b.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
