Conceptual Physical Science (6th Edition)
6th Edition
ISBN: 9780134060491
Author: Paul G. Hewitt, John A. Suchocki, Leslie A. Hewitt
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 6, Problem 83E
Compared with conventional water heaters in the United States, why do propane tankless water heaters (which are common in other pans of the world) cost up to 60% less to operate?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
The “Energy Guide” label on a washing machine indicates that the washer will use $85 worth of hot water per year if the water is heated by an electric water heater at an electricity rate of $0.113/kWh. If the water is heated from 12 to 55°C, determine how many liters of hot water an average family uses per week. Disregard the electricity consumed by the washer, and take the efficiency of the electric water heater to be 91 percent.
Consider two actual power plants operating with solar energy. Energy is supplied to one plant from a solar pond at 80°C and to the other from concentrating collectors that raise the water temperature to 600°C. Which of these power plants will have a higher efficiency? Explain.
You observe a grasshopper eating a blade of grass. You know that each blade of grass contains 100 units of energy. You then measure the energy level of the grasshopper using a fancy device. You notice that the grasshopper only has 20 units of Energy after eating two blades of grass. Based on what you have learned about thermodynamics, where did the rest of the energy go?
Chapter 6 Solutions
Conceptual Physical Science (6th Edition)
Ch. 6 - What are the temperatures for freezing water on...Ch. 6 - Is the temperature of an object a measure of the...Ch. 6 - Under what condition does a thermometer measure...Ch. 6 - By how much does the pressure of a gas in a right...Ch. 6 - What pressure would you expect in a rigid...Ch. 6 - Prob. 6RCQCh. 6 - How much energy can be removed from a system at 0...Ch. 6 - Prob. 8RCQCh. 6 - Does a hot object contain thermal energy, or does...Ch. 6 - How does heat differ from thermal energy?
Ch. 6 - What role does temperature have in the direction...Ch. 6 - Why is heat measured in joules?Ch. 6 - How many joules are needed to change the...Ch. 6 - Cite a way in which the energy value of foods is...Ch. 6 - Distinguish among a calorie, a Calorie, and a...Ch. 6 - Which law of thermodynamics consists of the...Ch. 6 - What becomes of heat that is added to a system but...Ch. 6 - Which law of thermodynamics is related to the...Ch. 6 - Prob. 19RCQCh. 6 - Which law of thermodynamics is related to a system...Ch. 6 - When disorder in a system increases, does entropy...Ch. 6 - Under what condition can the entropy of a system...Ch. 6 - Which warms faster when heat is applied: iron or...Ch. 6 - How does the specific heat capacity of water...Ch. 6 - What is the relationship between waters high...Ch. 6 - Why does a bimetallic strip bend with changes in...Ch. 6 - Which generally expands more for an equal increase...Ch. 6 - When the temperature of ice-cold water is...Ch. 6 - What is the reason for ice being less dense than...Ch. 6 - At what temperature do the combined effects of...Ch. 6 - Use the formula above to show that it takes 3000...Ch. 6 - Use the same formula to show that it takes 12,570...Ch. 6 - Show that 3000 cal = 12,570 J, the same quantity...Ch. 6 - Will Maynez burns a 0.6-g peanut beneath 50 g of...Ch. 6 - Consider a 6.0-g steel nail 8.0 cm long and a...Ch. 6 - If you wish to warm 50 kg of water by 20C for your...Ch. 6 - The specific heat capacity of steel is 450 J/kg C....Ch. 6 - In the lab, you submerge 100 g of 40C nails in 200...Ch. 6 - Consider a 1-m bar that expands 0.6 cm when...Ch. 6 - Suppose that the 1.3-km main span of steel for the...Ch. 6 - Imagine people breathing on the length of a...Ch. 6 - Prob. 44TARCh. 6 - Prob. 45TARCh. 6 - How much the lengths of various substances change...Ch. 6 - The precise volume of 200 grams of water in a...Ch. 6 - A friend says that molecules in a mixture of gases...Ch. 6 - A friend says that molecules in a mixture of gases...Ch. 6 - A friend tells you that the surface temperature of...Ch. 6 - Why would you expect the molecules in a gas to...Ch. 6 - Consider two glasses, one filled with water and...Ch. 6 - Which is greater: an increase in temperature of 1C...Ch. 6 - Which contains the greater amount of thermal...Ch. 6 - On which temperature scale does the average...Ch. 6 - Prob. 56ECh. 6 - What will be the temperature of 0C helium gas if...Ch. 6 - Prob. 58ECh. 6 - Instead of saying a red-hot horseshoe contains...Ch. 6 - What is the general direction of the flow of...Ch. 6 - Prob. 61ECh. 6 - Prob. 62ECh. 6 - Which raises the temperature of water more: the...Ch. 6 - If 100 joules of heat is added to a system that...Ch. 6 - If 100 joules of heat is added to a system that...Ch. 6 - Which law of thermodynamics tells us what is most...Ch. 6 - Prob. 67ECh. 6 - Prob. 68ECh. 6 - Entropy is a measure of how energy become...Ch. 6 - In the previous question, there is a reason why...Ch. 6 - What happens to the pressure within a scaled...Ch. 6 - After a car it driven along a road for some...Ch. 6 - Prob. 73ECh. 6 - What does the high specific heat of water have to...Ch. 6 - Why does jello stay cooler for a longer time than...Ch. 6 - Prob. 76ECh. 6 - Which undergoes a greater change in temperature...Ch. 6 - Prob. 78ECh. 6 - Prob. 79ECh. 6 - On cold winter nights in days past, it was common...Ch. 6 - Why does the presence of large bodies of water...Ch. 6 - If the winds at the latitude of San Francisco and...Ch. 6 - Compared with conventional water heaters in the...Ch. 6 - Prob. 84ECh. 6 - In terms of thermal expansion, why is it important...Ch. 6 - Why arc incandescent bulbs typically made of very...Ch. 6 - For many years, a method for breaking boulders was...Ch. 6 - An old technique for separating a pair of nested...Ch. 6 - A metal ball is barely able to past through a...Ch. 6 - Prob. 90ECh. 6 - State an exception to the claim that all...Ch. 6 - How does the combined volume of the billions of...Ch. 6 - A piece of solid iron sinks in a container of...Ch. 6 - In your room are things such as tables, chairs,...Ch. 6 - Why can't you determine whether you are running a...Ch. 6 - The temperature of the Suns interior is about 107....Ch. 6 - If you drop a hot rock into a pail of water, the...Ch. 6 - Structural groaning and creaking noises ate...Ch. 6 - Why is it important that glass mirrors that have a...Ch. 6 - Steel plates are commonly attached to each other...Ch. 6 - After a machinist quickly slips a hot, snugly...Ch. 6 - Suppose that water is used in a thermometer...Ch. 6 - If cooling occurred at the bottom of a pond...Ch. 6 - The motion of molecules that most affects...Ch. 6 - Prob. 2RATCh. 6 - Absolute zero corresponds to a temperature of (a)...Ch. 6 - Thermal energy is normally measured in units of...Ch. 6 - Prob. 5RATCh. 6 - Your garage gets messier day by day. In this case,...Ch. 6 - Prob. 7RATCh. 6 - A bimetallic strip used in thermostats relies on...Ch. 6 - Water at 4C will expand when it is slightly (a)...Ch. 6 - Microscopic slush in water tends to make the water...
Additional Science Textbook Solutions
Find more solutions based on key concepts
Fill in each blank with the most reasonable metric unit (km, m, cm, or mm).
23. A jet plane usually cruises at ...
Applied Physics (11th Edition)
A ball rebounds elastically from the floor. What doesthis situation share with the ideas of momentum conservati...
Modern Physics
You have a system of two negatively charged objects separated by some arbitrary finite distance. (a) What is th...
College Physics
Your companys purchasing department bought lots of cheap 2.0-F, 50-V capacitors. Your budget is maxed out and t...
Essential University Physics (3rd Edition)
In the course of pumping up a bicycle tire, a liter of air at atmospheric pressure is compressed adiabatically ...
An Introduction to Thermal Physics
At which position(s), if any, does Star B rise and set?
Lecture- Tutorials for Introductory Astronomy
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- An engine absorbs three times as much heat as it discharges. The work done by the engine per cycle is 50 J. Calculate (a) the efficiency of the engine, (b) the heat absorbed per cycle, and (c) the heat discharged per cycle.arrow_forwardA heat pump used for heating shown in Figure P18.25 is essentially an air conditioner installed backward. It extracts energy from colder air outside and deposits it in a warmer room. Suppose the ratio of the actual energy entering the room to the work done by the devices motor is 10.0% of the theoretical maximum ratio. Determine the energy entering the room per joule of work done by the motor given that the inside temperature is 20.0C and the outside temperature is 5.00C. Figure P18.25arrow_forwardThe efficiency of cooking appliances affects the internal heat gain from them since an inefficient appliance consumes a greater amount of energy for the same task, and the excess energy consumed shows up as heat in the living space. The efficiency of open burners is determined to be 73 percent for electric units and 38 percent for gas units. Consider a 2-kW electric burner at a location where the unit costs of electricity and natural gas are $0.09/kWh and $1.20/therm, respectively. Determine the rate of energy consumption by the burner and the unit cost of utilized energy for both electric and gas burners.arrow_forward
- An electric blender is used to grind soya beans. The blender runs for 5 minutes, and the power consumption is 100 W. The heat loss from the blender is 20 W. Determine the change in internal energy of the blender along with its contents.arrow_forwardAn insulated 40-ft3 rigid tank contains air at 50 psia and 120°F. A valve connected to the tank is now opened, and air is allowed to escape until the pressure inside drops to 25 psia. The air temperature during this process is maintained constant by an electric resistance heater placed in the tank. Determine the electrical work done during this process.arrow_forwardThe bulldozer for the DPWH road widening project at Koronadal City has a gasoline engine that takes 10,000 J of heat and delivers 2,200 J of mechanical work per cycle. (a) What is the thermal efficiency of this engine? (b) How much heat is discarded in each cycle?arrow_forward
- In a solar water heater, energy from the Sun is gathered by water that circulates through tubes in a rooftop collector.The solar radiation enters the collector through a transparent cover and warms the water in the tubes; this water is pumped into a holding tank. Assume that the efficiency of the overall system is 20% (that is, 80% of the incident solar energy is lost from the system). What collector area is necessary to raise the temperature of 200 L of water in the tank from 20C to 40°C in 1.0 h when the intensity of incident sunlight is 700 W/m2?arrow_forwardIf you mix food in a blender, the electric motor does work on the system, which consists of the food inside the container. This work can noticeably warm up the food. Suppose the blender motor runs at a power of 250 W for 40 s. During this time, 2000 J of heat flow from the now-warmer food to its cooler surroundings. Match the answers with questions. (Hint: Example 11.12) v W- work done on the system (food) A. 2000 J v Q- Heat into or out of the system (food) B. 8000 J v AEth - Change in thermal energy of the system (food) C. OJ D. -10,000 J E. -8000 J F. -2000 J G. 10,000 Jarrow_forwardA prototype power generation device that cycles steam between a geothermal source (temperature 393 K) and a cooling tower (temperature 280 K) has a theoretical maximum efficiency ofarrow_forward
- During a heat transfer process, the entropy of a system (always, sometimes, never) increases.arrow_forwardIt is well established that the thermal efficiency of a heat engine increases as the temperature TL at which heat is rejected from the heat engine decreases. In an effort to increase the efficiency of a power plant, somebody suggests refrigerating the cooling water before it enters the condenser, where heat rejection takes place. Would you be in favor of this idea? Why?arrow_forwardHow long would a 5.00 kW space heater have to run to put into a kitchen the same amount of heat as a refrigerator (coefficient of performance = 2.00) does when it freezes 1.25 kg of water at 23.0°C into ice at 0.0°C?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
The Laws of Thermodynamics, Entropy, and Gibbs Free Energy; Author: Professor Dave Explains;https://www.youtube.com/watch?v=8N1BxHgsoOw;License: Standard YouTube License, CC-BY