Chemistry for Today: General, Organic, and Biochemistry
9th Edition
ISBN: 9781305960060
Author: Spencer L. Seager, Michael R. Slabaugh, Maren S. Hansen
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 6, Problem 6.87E
Interpretation Introduction
Interpretation:
The effect of temperature on cohesive and disruptive forces on heating solids is to be explained.
Concept Introduction:
The cohesive forces are the intermolecular forces between the molecules of same substance. It resists the separation of liquids. The disruptive forces are related to the motion of the particles.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
What is the difference between a chemical and physical change?
What is the difference between an intermolecular force and an intramolecular force?
Explain why it takes more energy to break an intramolecular force than it does an intermolecular force.
Define viscosity.
Describe what surface tension is and how you know that water has a higher surface tension than alcohol.
If a substance has a high viscosity, then it has strong intermolecular forces. For example, in the investigation we did, we found that room-temperature corn syrup had stronger intermolecular forces/higher viscosity than the hot corn syrup because it took longer for it to pour out of the beaker.
Describe cohesion and adhesion and how they relate to your everyday life.
Substances with high boiling, melting, and freezing points have stronger intermolecular forces.
Four types of intermolecular forces: dispersion forces, hydrogen bonds (H-O, H-F, H-N), ion-dipole, dipole-dipole
Which intermolecular force exists…
Identify the true statements about surface tension.
Molecules along the surface of a liquid behave differently than those in the bulk liquid.
Water forming a droplet as it falls from a faucet is a primary example of surface tension.
Mercury has a lower surface tension than water.
Surface tension increases as the temperature of the liquid rises.
Cohesive forces attract the molecules of the liquid to one another.
Cohesion happens between all molecules in a liquid, but because the molecules in the middle of the droplet pull each equally in all directions they generally cancel each out. This strong inward force causing molecules on the surface to contract and resist being pulled apart. This is known as surface tension.
Based on this information. Answer the question .
Chapter 6 Solutions
Chemistry for Today: General, Organic, and Biochemistry
Ch. 6 - Calculate the volume of 125g of the following...Ch. 6 - Calculate the volume of 125g of the following...Ch. 6 - Copper metal has a density of 8.92g/cm3 at 20.0C...Ch. 6 - Liquid water has a density of 1.00g/mL at 10.0C...Ch. 6 - Gallium metal melts at 29.8C. At the melting...Ch. 6 - Prob. 6.6ECh. 6 - Describe the change in form of energy kinetic...Ch. 6 - Prob. 6.8ECh. 6 - Prob. 6.9ECh. 6 - At 25.0C, helium molecules (He) have an average...
Ch. 6 - Prob. 6.11ECh. 6 - Prob. 6.12ECh. 6 - Explain each of the following observations using...Ch. 6 - Prob. 6.14ECh. 6 - The following statements are best associated with...Ch. 6 - Prob. 6.16ECh. 6 - Prob. 6.17ECh. 6 - Prob. 6.18ECh. 6 - Prob. 6.19ECh. 6 - Prob. 6.20ECh. 6 - Prob. 6.21ECh. 6 - Convert each of the following temperatures from...Ch. 6 - Prob. 6.23ECh. 6 - Prob. 6.24ECh. 6 - A 200.mL sample of oxygen gas is collected at...Ch. 6 - A 200.mL sample of nitrogen gas is collected at...Ch. 6 - Prob. 6.27ECh. 6 - Prob. 6.28ECh. 6 - What volume in liters of air measured at 1.00atm...Ch. 6 - What volume in liters of air measured at 1.00atm...Ch. 6 - Prob. 6.31ECh. 6 - Prob. 6.32ECh. 6 - Prob. 6.33ECh. 6 - Prob. 6.34ECh. 6 - A sample of gas has a volume of 375mL at 27C. The...Ch. 6 - What volume of gas in liters at 120.C must be...Ch. 6 - Prob. 6.37ECh. 6 - Prob. 6.38ECh. 6 - Prob. 6.39ECh. 6 - A helium balloon was partially filled with...Ch. 6 - You have a 1.50-L balloon full of air at 30.C. To...Ch. 6 - Prob. 6.42ECh. 6 - What minimum pressure would a 250.-mL aerosol can...Ch. 6 - Prob. 6.44ECh. 6 - Prob. 6.45ECh. 6 - Prob. 6.46ECh. 6 - Prob. 6.47ECh. 6 - Prob. 6.48ECh. 6 - Prob. 6.49ECh. 6 - The pressure gauge of a steel cylinder of methane...Ch. 6 - Suppose 12.0g of dry ice (solidCO2) was placed in...Ch. 6 - Prob. 6.52ECh. 6 - Prob. 6.53ECh. 6 - A sample of gaseous methyl ether has a mass of...Ch. 6 - A sample of gaseous nitrogen oxide is found to...Ch. 6 - A sample of gas weighs 0.176g and has a volume of...Ch. 6 - Prob. 6.57ECh. 6 - Prob. 6.58ECh. 6 - Prob. 6.59ECh. 6 - Prob. 6.60ECh. 6 - Prob. 6.61ECh. 6 - Prob. 6.62ECh. 6 - Prob. 6.63ECh. 6 - Classify each of the following processes as...Ch. 6 - Classify each of the following processes as...Ch. 6 - Prob. 6.66ECh. 6 - Prob. 6.67ECh. 6 - Prob. 6.68ECh. 6 - Prob. 6.69ECh. 6 - Prob. 6.70ECh. 6 - Prob. 6.71ECh. 6 - Prob. 6.72ECh. 6 - Prob. 6.73ECh. 6 - Prob. 6.74ECh. 6 - Prob. 6.75ECh. 6 - Using the specific heat data of Table 6.8,...Ch. 6 - Using the specific heat data of Table 6.8,...Ch. 6 - Prob. 6.78ECh. 6 - Prob. 6.79ECh. 6 - Liquid Freon (CCl2F2) is used as a refrigerant. It...Ch. 6 - Prob. 6.81ECh. 6 - What is the density of argon gas in g/mL at STP?Ch. 6 - Prob. 6.83ECh. 6 - Prob. 6.84ECh. 6 - Prob. 6.85ECh. 6 - Prob. 6.86ECh. 6 - Prob. 6.87ECh. 6 - Prob. 6.88ECh. 6 - Prob. 6.89ECh. 6 - Prob. 6.90ECh. 6 - Prob. 6.91ECh. 6 - Prob. 6.92ECh. 6 - Refer to Figure 6.12 and answer the question....Ch. 6 - Prob. 6.94ECh. 6 - Prob. 6.95ECh. 6 - Definite shape and definite volume best describes...Ch. 6 - Prob. 6.97ECh. 6 - Prob. 6.98ECh. 6 - Prob. 6.99ECh. 6 - Which of the following indicates the relative...Ch. 6 - Prob. 6.101ECh. 6 - Prob. 6.102ECh. 6 - What are the differentiating factors between...Ch. 6 - Prob. 6.104ECh. 6 - Prob. 6.105ECh. 6 - When a vapor condenses into a liquid: a.it absorbs...Ch. 6 - Prob. 6.107ECh. 6 - Prob. 6.108ECh. 6 - Prob. 6.109ECh. 6 - Prob. 6.110ECh. 6 - Prob. 6.111ECh. 6 - Prob. 6.112ECh. 6 - How much heat is required to raise the temperature...Ch. 6 - Prob. 6.115ECh. 6 - Prob. 6.116ECh. 6 - Prob. 6.117ECh. 6 - Prob. 6.118ECh. 6 - Prob. 6.119ECh. 6 - Prob. 6.120ECh. 6 - Prob. 6.121ECh. 6 - Prob. 6.122ECh. 6 - Prob. 6.123ECh. 6 - Prob. 6.124ECh. 6 - Prob. 6.125E
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.Similar questions
- The amount of heat required to melt 2 lbs of ice is twice the amount of heat required to melt 1 lb of ice. Is this observation a macroscopic or microscopic description of chemical behavior? Explain your answer.arrow_forwardWhat is formed when gas is enclosed in a chamber then liquified under very high pressure? * What latent heat value signifies the lost of heat during a phase change? What is the unique temperature and pressure at which the three phases of a substance are in equilibrium with each other? * Which liquid crystal is of pharmaceutical significance? *arrow_forwardTo calculate the amount of heat absorbed as a substance melts, which of the following information is NOT needed?arrow_forward
- Explain how crystalline and amorphous solids are organized. Give some examples emphasizing the crystalline system and its long- and short-range ordering.arrow_forwardIn everyday life, you observe bulk properties such as melting points, boiling points, and surface tension. Give one example for each- Boiling point, melting points, and surface tension.arrow_forwardDistinguish between amorphous and crystalline solids.arrow_forward
- Identify the true statements about surface tension. Molecules along the surface of a liquid behave differently than those in the bulk liquid. Surface tension increases as the temperature of the liquid rise. Cohesive forces attract the molecules of the liquid to one another. Water forming a droplet as it falls from a faucet is a primary example of surface tension. Mercury has a lower surface tension than water.arrow_forwardDescribe the properties of a liquid, including vapor pressure, viscosity, and surface tensionarrow_forwardGiven that a 10.0 g sample of ice at 0.0 °C melts and then the resultant water proceeds to warm to 20.0 °C, there are two separate processes (dealing with the transfer of heat) that describe that occurrence. What are those two processes?arrow_forward
- What is needed for a liquid to freeze?arrow_forwardDuring a phase change, the temperature remains constant although heat is being added. What is the best explanation for what the heat energy is being used to do? Making chemical bonds to form new substances Weakening or breaking the intermolecular forces Increasing the movement of the particles Moving the particles closer togetherarrow_forwardDuring a phase change, the temperature remains constant although heat is still being added. What is the best explanation for what the heat energy is being used to do? moving the particles closer together breaking chemical bonds to form brand new substances increasing the movement of particles weakening or breaking the intermolecular forcesarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Chemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStaxIntroductory Chemistry: An Active Learning Approa...ChemistryISBN:9781305079250Author:Mark S. Cracolice, Ed PetersPublisher:Cengage LearningWorld of Chemistry, 3rd editionChemistryISBN:9781133109655Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCostePublisher:Brooks / Cole / Cengage Learning
- Organic Chemistry: A Guided InquiryChemistryISBN:9780618974122Author:Andrei StraumanisPublisher:Cengage LearningPhysical ChemistryChemistryISBN:9781133958437Author:Ball, David W. (david Warren), BAER, TomasPublisher:Wadsworth Cengage Learning,
Chemistry by OpenStax (2015-05-04)
Chemistry
ISBN:9781938168390
Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark Blaser
Publisher:OpenStax
Introductory Chemistry: An Active Learning Approa...
Chemistry
ISBN:9781305079250
Author:Mark S. Cracolice, Ed Peters
Publisher:Cengage Learning
World of Chemistry, 3rd edition
Chemistry
ISBN:9781133109655
Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste
Publisher:Brooks / Cole / Cengage Learning
Organic Chemistry: A Guided Inquiry
Chemistry
ISBN:9780618974122
Author:Andrei Straumanis
Publisher:Cengage Learning
Physical Chemistry
Chemistry
ISBN:9781133958437
Author:Ball, David W. (david Warren), BAER, Tomas
Publisher:Wadsworth Cengage Learning,