LINUX+ AND LPIC-1 GDE.TO LINUX CERTIF.
5th Edition
ISBN: 9781337569798
Author: ECKERT
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Expert Solution & Answer
Chapter 6, Problem 17RQ
Program Description Answer
RAM problems, overclocked Central Processing Unit (CPU) and faulty hardware components can turn into a segmentation fault at the time of Fedora installation.
Hence, correct answer is option “D”.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
Should the bus between the CPU and RAM be synchronised or not? Which is better? Explain your pick.
6. Which among the CPU registers of PIC16F7X is not 8-bit wide?
A. Status Register
B. Program Counter Low Byte (PCL) Register
DOL
wn
C. Program Counter Latch (PCLATH) Register
D. File Selection Register (FSR)
You have been tasked with developing a boot-loader that will be executed when the CPU is powered on. What attribute of the CPU should you investigate that will help you determine where the boot-loader code should be placed in the system's non-volatile storage?
a. reset vector address
b. the amount of cache
c. location of the program counter
d. internal clock speed
Chapter 6 Solutions
LINUX+ AND LPIC-1 GDE.TO LINUX CERTIF.
Ch. 6 - Prob. 1RQCh. 6 - Prob. 2RQCh. 6 - Prob. 3RQCh. 6 - Prob. 4RQCh. 6 - Which command can you use during a system rescue...Ch. 6 - Prob. 6RQCh. 6 - Where is the /proc filesystem stored?
in RAM
on...Ch. 6 - Prob. 8RQCh. 6 - Prob. 9RQCh. 6 - Prob. 10RQ
Ch. 6 - Prob. 11RQCh. 6 - What command can be used to create a ZFS volume...Ch. 6 - To which directory will the test ZFS volume from...Ch. 6 - Prob. 14RQCh. 6 - Prob. 15RQCh. 6 - ZFS volumes are mounted at boot time from entries...Ch. 6 - Prob. 17RQCh. 6 - Prob. 18RQCh. 6 - Prob. 19RQCh. 6 - Prob. 20RQ
Knowledge Booster
Similar questions
- Which of the following statements is TRUE? Turbo Boost increases the speed of CPU by enabling all the available cores PCI-express bus is faster than the CPU-RAM bus cache is part of the main memory CPU-RAM bus connects the CPU with the main memory hyper-threading increases the speed of the CPU by using additional coresarrow_forwardA. Choose the correct answer: 1. Increasing the number of cores inside the processor will increase the a. Response time b. Throughput c. Execution Time d. Clock Ratearrow_forwardYou need to design an I/O device that can accept bursts of data that can be held until the CPU is ready for it. Which of the following is a component you might want to include in your design to meet this requirement? a. status register b. FIFO chip c. port-mapped memory d. programmed I/Oarrow_forward
- In which technique, does the CPU issue an 1/0 command, continues to execute subsequent instructions, and is interrupted by the l/O module when the latter has completed its work? a. 1/O Registers b. Programmed I/O O c. 1/0 Channel O d. Interruptsarrow_forwardTime left 0:57:35 Your company could speed up a Java program on their new computer by adding hardware support for garbage collection. Garbage collection currently comprises 20% of the cycles of the program. You have two possible changes to the machine. The first one would be to automatically handle garbage collection in hardware. This causes an increase in cycle time by a factor of 1.2. The second would be to provide for new hardware instructions to be added to the ISA that could be used during garbage collection. This would halve the number of instruction needed for garbage collections but increase the cycle time by 1.1. Which of these two options, if either, should you choose? Explain your answer. B IIarrow_forwardCMPE 3437/ELEE 3435 Lab 01: DOS Debug A. Objectives: to get familiar with the debug program and use debug commands to examine registers and memory contents. B. Resources 1. Online resources 2. Textbook C. Lab Preparation 1. Read the online guide or textbook to understand the debug commands used in the assignment. 2. Start the Debug Application. Note that in the lab report, you will be required to show the results you obtained in your experiments. You thus need to take screenshots of your work. D. The Lab You will practice some commands useful in debug, such as the dump, enter, and fill commands. First, execute the following command to fill the memory with some data: -f 0 fff ac cb f5 4e 65 8d 1. Execute the command r to examine the contents of registers. You can change the value of a register by doing the following. -r IP IP 0100 Now you can enter a new value for the IP register after the prompt. 2. Display and modify memory contents. Use the command d to dump (display) the memory…arrow_forward
- Is it better to link the CPU directly to the RAM through an asynchronous interface or a synchronous one? Explicit justification is required.arrow_forwardThe answers are listed below. Drag and drop the answer into the empty boxes per number. 1. device. 3. 4. 5. 6. polling CPU 7. memory mapped 2. service for an I/O device. 10. arbiter device controller vectored interrupt advanced peripheral bus (APB) control signals interrupt bus daisy chain sequential interrupt device driver non-vectored interrupt register maps branch and link DMA I/O device nested interrupt AMBA DMA controller advanced high performance bus (AHB) isolated I/O single bus integrated DMA is the type of I/O interface method where an I/O device can communicate directly to a memory with an additional controller. This way the CPU can run simultaneously while the data transfer is taking place. is the master mind of a computer system. This is where the OS resides. is the type of I/O interface method where we have to constantly probe the status of the 1/0 is the type of I/O interface method where an asynchronous signal triggers and requests is the master mind of the AMBA bus. It…arrow_forwardInstruction: Analyze the given Emu8086 assembly codes and answer the following questions. Note: You can execute the program if you have the Emu8086 Emulator installed on your computer. What is the purpose of the next: section in the program? What is the purpose of al and bx in the program? In the print: section of the program, what does the jz instruction perform? In the print_al procedure of the program, what does the jne instruction perform? In the print_al_r: section of the program, what does the je instruction perform?arrow_forward
- H. data register In which type of I/O does the CPU execute special instructions to read and write the I/O ports? a. memory-mapped 1/0 b. DMA-controlled 1/0 c. port-mapped I/O d. programmed I/O H 55arrow_forwardConsider the following statements:1. INC never sets Carry flag2. XOR modifies only the sign, Zero and parity flag3. ADD affects all CPU status flags4. AND modifies only overflow and carry flags Which of the above statements are true?arrow_forwardWhen do you need to use the word "Interrupt?" Is it conceivable, by listing the many kinds of hardware interruptions, to explain why none are anticipated?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- A+ Guide to Hardware (Standalone Book) (MindTap C...Computer ScienceISBN:9781305266452Author:Jean AndrewsPublisher:Cengage LearningSystems ArchitectureComputer ScienceISBN:9781305080195Author:Stephen D. BurdPublisher:Cengage LearningComptia A+ Core 1 Exam: Guide To Computing Infras...Computer ScienceISBN:9780357108376Author:Jean Andrews, Joy Dark, Jill WestPublisher:Cengage Learning
A+ Guide to Hardware (Standalone Book) (MindTap C...
Computer Science
ISBN:9781305266452
Author:Jean Andrews
Publisher:Cengage Learning
Systems Architecture
Computer Science
ISBN:9781305080195
Author:Stephen D. Burd
Publisher:Cengage Learning
Comptia A+ Core 1 Exam: Guide To Computing Infras...
Computer Science
ISBN:9780357108376
Author:Jean Andrews, Joy Dark, Jill West
Publisher:Cengage Learning