Concept explainers
In Fig. 5-59, 4.0 kg block A and 6.0 kg block B are connected by a string of negligible mass. Force
Figure 5.59 Problem 69.
Want to see the full answer?
Check out a sample textbook solutionChapter 5 Solutions
FUNDAMENTALS OF PHYSICS (LLF)+WILEYPLUS
Additional Science Textbook Solutions
Modern Physics
University Physics with Modern Physics (14th Edition)
Physics for Scientists and Engineers
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
Cosmic Perspective Fundamentals
Introduction to Electrodynamics
- A bag of cement weighing 325 N hangs in equilibrium from three wires as suggested in Figure P4.23. Two of the wires make angles 1 = 60.0 and 2 = 40.0 with the horizontal. Assuming the system is in equilibrium, find the tensions T1, T2, and T3 in the wires. Figure P4.23 Problems 23 and 24.arrow_forwardA 3.00-kg object is moving in a plane, with its x and y coordinates given by x = 5t2 1 and y = 3t3 + 2, where x and y are in meters and t is in seconds. Find the magnitude of the net force acting on this object at t = 2.00 s.arrow_forwardTwo blocks, each of mass m = 3.50 kg, are hung from the ceiling of an elevator as in Figure P4.33. (a) If the elevator moves with an upward acceleration a of magnitude 1.60 m/s2, find the tensions T1 and T2 in the upper and lower strings. (b) If the strings can withstand a maximum tension of 85.0 N, what maximum acceleration can the elevator have before a string breaks? Figure P4.33 Problems 33 and 34.arrow_forward
- Let there be 2 blocks stacked on a table. The top block has a mass of 2.0 kg, and the bottom block has a mass of 5.0 kg. The coefficient of static friction between the two blocks is 0.40, and the coefficient of static friction between the bottom block and table is 0.10. What is the maximum horizontal force you can apply to the top block such that neither block moves?arrow_forwardA 12 N horizontal force F pushes a block weighing 5.3 N against a vertical wall (see the figure). The coefficient of static friction between the wall and the block is 0.61, and the coefficient of kinetic friction is 0.48. Assume that the block is not moving initially. (a) Will the block move? ("yes" or "no") |(b) In unit-vector notation what is the force on the block from the wall?arrow_forwardA 100 N force, directed at an angle u above a horizontal floor, is applied to a 25.0 kg chair sitting on the floor. If u =0, what are (a) the horizontal component Fh of the applied force and (b) the magnitude FN of the normal force of the floor on the chair? If u =30.0, what are (c) Fh and (d) FN? If u =60.0, what are (e) Fh and (f) FN? Now assume that the coefficient of static friction between chair and floor is 0.420. Does the chair slide or remain at rest if u is (g) 0, (h) 30.0, and (i) 60.0?arrow_forward
- A 1.09 kg block is placed at one end of a wooden plank that is 2.02 m long. The plank is slowly tilted. M (a) The block starts to slide when the angle reaches 16 degrees. What is the coefficient of static friction between the block and the ramp? (b) The coefficient of kinetic friction between the block and the ramp is about 0.20. At what rate will the block accelerate down the plank if it is tilted at 16 μκ degrees?arrow_forward*64. GO A block is pressed against a vertical wall by a force P, as the drawing shows. This force can either push the block upward at a constant ve- locity or allow it to slide downward at a constant velocity. The magnitude of the force is different in the two cases, while the directional angle 0 is the same. Kinetic friction exists between the block and the wall, and the coefficient of kinetic friction is 0.250. The weight of the block is 39.0 N, and the directional angle for the force P is 0 = 30.0°. Determine the magnitude of P when the block slides (a) up the wall and (b) down the wall.arrow_forwardA 1.00 × 103-N crate is being pushed across a level floor at a constant speed by a force → F of 3.00× 102 N at an angle of 20.0° below the horizontal, as shown in Figure a. (a) What is the coefficient of kinetic friction between the crate and the floor? (b) If the 3.00 × 102-N force is instead pulling the block at an angle of 20.0° above the horizontal, as shown in Figure b, what will be the acceleration of the crate? Assume that the coefficient of friction is the same as that found in part (a).arrow_forward
- Force T pulls at angle a up from the horizontal on a section of pipe of weight W as shown, but the pipe remains motionless. The coefficient of static friction between pipe and floor is µ. We know that the magnitude of the total frictional force on the pipe by the floor is: 1(c T. A) 27 cos a B) µ(W +T sin a) C) µW +T cos a D) T cosa W A Barrow_forwardA stacked pair of books with masses m1= 2.0 kg (bottom book) and m2 = 1.5 kg (top book) are tossed onto a table. The books strike the table with no vertical velocity and their common horizontal speed is vo = 0.75 m/s.The kinetic friction coefficient between the bottom book and the table is Muek1=0.45; the kinetic and staticfriction coefficients between the two books are Muek2=0.3 and Mues2= 0.6. Find the final horizontalposition of each book relative to the spot where the stack hits the table.arrow_forwardA 2 kg aluminum block and a 6 kg copper block are connected by a light string over a frictionless pulley. The two blocks are allowed to move on a fixed steel block wedge (of angle 8 = 35°) as shown in the Fig. (2). The coefficient of kinetic friction for each block is shown in the figure. Determine: (a) The acceleration of the two blocks. (b) The tension in the string. Aluminum Copper H = 0.47 Steel P0.36 Fig. 2arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningClassical Dynamics of Particles and SystemsPhysicsISBN:9780534408961Author:Stephen T. Thornton, Jerry B. MarionPublisher:Cengage Learning