The reason for the more efficiency of the packed column as compared to the unpacked column should be determined. Concept introduction: A technique used to separate various components or a fraction from mixture based on their volatilities is called fractional distillation. The fractional distillation is used to separate different components of the mixture if boiling point difference is less than 75 ° C . Fractional distillation is better than the simple distillation due to the low boiling point range. It is used to separate useful substances from crude oil in oil refineries.

Question

1. What are the principal natural processes that affect the petrophysical properties of sedimentary rocks? 2. As shown in Table 1.1, the total bulk chemical analysis of rock samples is clearly different from the surface analysis. What effect does this have on the rock properties?

Answer 1

Question

Chapter 5, Problem 10Q

Interpretation Introduction

Interpretation:

The reason for the more efficiency of the packed column as compared to the unpacked column should be determined.

Concept introduction:

A technique used to separate various components or a fraction from mixture based on their volatilities is called fractional distillation. The fractional distillation is used to separate different components of the mixture if boiling point difference is less than 75 °C. Fractional distillation is better than the simple distillation due to the low boiling point range. It is used to separate useful substances from crude oil in oil refineries.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

1. What are the principal natural processes that affect the petrophysical properties of sedimentary rocks? 2. As shown in Table 1.1, the total bulk chemical analysis of rock samples is clearly different from the surface analysis. What effect does this have on the rock properties?

Please use phase diagram to explain why micro-segregation and macro-segregation happen during practical solidification.

From the practical standpoint, is it better to use a "good" solvent or a "poor" solvent when measuring polymer molecular weight? Explain.