Determine the required volume of calcium oxide.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4, Problem 8P

To determine

Determine the required volume of calcium oxide.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Methanol (CH3OH) can be degraded as shown in the reaction below. Answer the following questions if methanol is present in a water at a concentration of 260 mg/L and the water flowrate is 1.7 million gallons per day (mgd). 2. CH3OH + 1.5 O2 → CO2 + 2 HLO What amount of carbon dioxide (CO2) will be produced each day (in lbs and kg)? How much oxygen (O2) will need to be supplied to degrade the methanol (in mg/L and lbs/day) if the oxygen transfer process is 48% efficient? а. b.

A 1000 MW coal fired power plant (30% efficiency). The coal is 75% carbon and has a heat content of 10, 000 BTU/lb. What is the carbon emission (ton carbon per year)?A 1000 MW natural gas plant (45% efficiency). The gas is CH4 with a heat content 800 BTU/mol. What is the carbon emission (ton carbon per year)?Calculate carbon emission reduction if the above natural gas plant is used to replace the coal fired plant.(Here ton is metric ton, 1 ton=2,200 lb)

Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from a nearby river (with an upstream flow of 10-m3/s and temperature 20 °C) to take care of waste heat. The heat content of the coal is 8,000 Btu/lb, the carbon content is 60% by mass, and the sulfur content is 2% by mass. How much electricity (in kWh/yr) would the plant produce each year? How many pounds per hour of coal would need to be burned at the plant? Estimate the annual carbon emissions from the plant (in metric tons C/year). If the cooling water is only allowed to rise in temperature by 10 °C, what flow rate (in m3/s) from the stream would be required? What would be the river temperature if all the waste heat was transferred to the river water assuming no heat losses during transfer? Estimate the hourly SO2 emissions (in kg/h) from the plant assuming that all the sulfur is oxidized to SO2 during combustion.