Understanding Motor Controls
4th Edition
ISBN: 9781337798686
Author: Stephen L. Herman
Publisher: Delmar Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 34, Problem 2RQ
To determine
Identify why high-impedance stator windings are used in induction motors intended to be controlled by variable voltage.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
A three phase induction motor
operates with a rotor speed of 1440
rpm and develops a torque of
66.32NM at full load. The full load
power output is *
O 10 kw
O 9 kw
O 8 kW
O 11 kW
Name three factors that determine the amount of voltage induced in the rotor of a wound-rotor motor.
Name three factors that determine the torque produced by an induction motor.
Chapter 34 Solutions
Understanding Motor Controls
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Why can an induction motor never operate at synchronous speed?arrow_forwardProblem 5 1. Where and why is a centrifugal switch used in a split-phase motor? 2. Why and where is a capacitor used in the single-phase AC motor? 3. What type of motor would you select to perform each of the following jobs? (a) Electric drill: (b) Refrigerator: (c) Hair driers and desk fans: (d) Air Conditioner Fan: (e) XY plotters and printers: (f) Electric clock:arrow_forwardA (21 HP, 3-Phase, 380 volts) motor with an efficiency of 95% is operating at a load factor of 0.63. What is the input current (Amperes) when the power factor is 89%? (1 HP = 0.75 kW)arrow_forward
- When a repulsion-start induction-run motor reaches about 75% of rated full-load speed, it stops operating as a repulsion motor and starts operating as a squirrel-cage motor. What must be done to cause the motor to begin operating as a squirrel-cage motor?arrow_forwardWhich of the following is a symbol of an air motor in one direction with invariable capacity isarrow_forwardQuestion 2 Beli vifth Slack side Motor (imprut) Tight side Beli thickpess\ Centre distance Figure 2 Figure 2 shows an open flat belt drive connected to a motor and a pulley. The motor transmits 20 kw to the connect pulley of 450 mm diameter and is rotating at 850 r/min to a second pulley rotating at 400 r/min. The distance between pulley centres is approximately 2 m. The belt is 6 mm thick and has a density of 970 kg/m. The maximum stress in the belt is not to exceed 2,7 MPa. The coefficient of friction for both pulleys is 0,3. Determine: 2.1. The diameter of the second pulley. 2.2. The length of the belt. 3.3. The width of the belt taking centrifugal tension into account.arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
Understanding Motor ControlsMechanical EngineeringISBN:9781337798686Author:Stephen L. HermanPublisher:Delmar Cengage Learning
Electrical Transformers and Rotating MachinesMechanical EngineeringISBN:9781305494817Author:Stephen L. HermanPublisher:Cengage Learning
Understanding Motor Controls
Mechanical Engineering
ISBN:9781337798686
Author:Stephen L. Herman
Publisher:Delmar Cengage Learning
Electrical Transformers and Rotating Machines
Mechanical Engineering
ISBN:9781305494817
Author:Stephen L. Herman
Publisher:Cengage Learning