Concept explainers
(a)
Interpretation:
The work done needed to increase the surface area of a pool of chloroform by
Concept introduction:
The atoms or molecules at the surface of the liquid are considered as a film. The atoms or molecules in bulk imply a force on the atoms or molecules at the surface of the liquid and tends to minimize the surface area of the liquid. This phenomenon is known as the surface tension of the liquid.
Answer to Problem 22.5E
The work done required to increase the surface area of a pool of chloroform by
Explanation of Solution
The work done to increase the surface area is calculated by the formula shown below.
Where,
•
•
The conversion of
Therefore, conversion of
The value of
Substitute the values of
The conversion of
Therefore,
The work done to increase the surface area of pool of chloroform by
(b)
Interpretation:
The work done to make the film of chloroform having area of
Concept introduction:
The atoms or molecules at the surface of the liquid are considered as a film. The atoms or molecules in bulk imply a force on the atoms or molecules at the surface of the liquid and tends to minimize the surface area of the liquid. This phenomenon is known as the surface tension of the liquid.
Answer to Problem 22.5E
The work done to make the film of chloroform having area of
Explanation of Solution
The making of film is same as increasing the surface area of a liquid. Therefore, the work done to make the film of chloroform is calculated by the formula given below.
Where,
•
•
The conversion of
Therefore, the conversion of
The conversion of
Therefore, the conversion of
The value of
Substitute the values of
The conversion of
Therefore,
The work done to make the film of chloroform having area of
Want to see more full solutions like this?
Chapter 22 Solutions
Bundle: Physical Chemistry, 2nd + Student Solutions Manual
- If 14.5 kJ of heat were added to 485 g of liquid water, how much would its temperature increase?arrow_forwardA constant pressure calorimeter contains 286 g of water at 20.0 °C. A 13.41 g of substance X (molar mass 154 g/mol) at 20.0°C was dissolved in this water. The temperature of the solution increased to 23.5 °C. Assuming the specific heat of the mixture is 4.184 J g‑1°C‑1, and the density of the solution is 1.00 g/cm3, calculate the enthalpy change (in kJ) for the dissolution of 1 mole of X.arrow_forwardHow much energy is given off when 563.8 g of NaCl solidifies at its freezing point of 801C ?arrow_forward
- 29. (a) (b) (c) What is the definition of the specific heat of water? the amount of heat required to melt one mole of a substance at the melting point. the amount of heat required to vaporize one mole of a Kryptonite at the boiling point. the amount of heat required to raise the temperature of 1 gram of water by 1°C.arrow_forwardTwo positively charged spheres, each with a charge of 2.0 x10-5 C, a mass of 1.0 kg, and separated by a distance of1.0 cm, are held in place on a frictionless track. (a) Whatis the electrostatic potential energy of this system? (b) Ifthe spheres are released, will they move toward or awayfrom each other? (c) What speed will each sphere attainas the distance between the spheres approaches infinity?arrow_forward(a) Convert 41.3 L atm to kcal. (Use dimensional analysis) (b) Convert –279.67°F to K. (C)The standard enthalpy of formation of O(g) is 249 kJ/mol.Calculate the wavelength (in nm) of the electromagnetic radiation with the minimum amount of energy required for dissociation of one molecule of oxygen gas.arrow_forward
- The normal boiling point of a liquid is (a) the temperature at which the vapor pressure equals 1 atm. (b) the temperature at which the gas molecules have more kinetic energy than the molecules in the liquid. (c) the only temperature at which there can be equilibrium between liquid and gas. (d) the temperature at which the liquid will usually boil.arrow_forwardWhen 5.022 g of sodium hydrogen carbonate NAHCO2(s) reacts completely with 80.00 mL of acetic acidCH3COOH(aq), the temperature increases from 18.6°C to 28.4°C. CH3COOH(aq)NaHCO2 (s) → CH3COONa(aq) + CO2(g) + H2O(l) Assume that the acid solution has the same density and specific heat capacity as water and that the mass of the finalsolution is 80.00 g. Calculate the molar enthalpy of reaction, ΔHr.arrow_forwardPublic water systems often add fluoride to drinking water because, in the proper amounts, fluoride improves dental health and prevents cavities. Too much fluoride, however, can cause fluorosis, which stains teeth. In 2015, the U.S. Public Health Service (PHS) revised its 1962 recommenda- tions for the amount of fluoride in public water systems. The 1962 recommendations depended on the average temperature for the region in question as shown here. because U.S. citizens are now getting fluoride from other sources, including toothpaste and mouthwash. The rec- ommended level balances the need for fluoride to im- prove dental health with the risk of developing fluorosis from too much fluoride. Examine the data in the table and answer the following questions: (a) Determine the percent change in optimum recom- mended fluoride concentration for a water system with annual average maximum daily temperatures of 17.8–21.4 °C. Hint: the percent change is given by 1962 Fluoride Recommendations final…arrow_forward
- At 36.0 °C the density of water is 0.9936870 g/cm3.At 37.0 °C the density of water is 0.9933390 g/cm3.Use linear interpolation to calculate the density (D) of water at 36.6 °C, to the nearest 10-7g/cm3.arrow_forwardExamining the crystal structure of CsCl (Caesium Chloride), the Cs+ions form the 8 corners of a cube and the Cl−ion is a the center of the cube. From first-principles calculation, it was determined that the lattice constant of CsCl is 4.209 ̊A. (a) Calculate in detail the electrostatic force exerted by all the Cs+ atoms to the Cl−atom; (b) Assuming that 1 Cs+atom is missing in crystal structure (crystal is said to have a defect), calculate in detail what will be the net electrostatic force on the Cl−ion due to the remaining Cs+ions.arrow_forwardAcetonitrile, CH3CN, has a vapor pressure of 88.8 torr at 25.0 ̊C. If 9.22 mL of liquid acetonitrile (MCH3CN = 41.05 g/mol, dCH3CN = 0.786 g/mL) is placed into a sealed 5.25 L container at 25.0 ̊C and allowed to reach equilibrium. What would the value of [grams of CH3CN(g)/ grams of CH3CN(l)] in the container be at equilibrium?.arrow_forward
- Chemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningWorld of Chemistry, 3rd editionChemistryISBN:9781133109655Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCostePublisher:Brooks / Cole / Cengage Learning
- Chemistry by OpenStax (2015-05-04)ChemistryISBN:9781938168390Author:Klaus Theopold, Richard H Langley, Paul Flowers, William R. Robinson, Mark BlaserPublisher:OpenStaxChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage Learning