Concept explainers
If the rate of movement along a fault is known, the amount of offset over a period of time can be calculated. The basic relationship is
Movement along the San Andreas Fault is about 3.5 cm/yr. If a fence were built across the fault in 2003, how far apart would the two sections of the by-then-broken fence be in 2025?
Want to see the full answer?
Check out a sample textbook solutionChapter 21 Solutions
EP CONCEPTUAL PHYSICAL SCI.-MOD.MASTER.
Additional Science Textbook Solutions
An Introduction to Thermal Physics
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
The Cosmic Perspective Fundamentals (2nd Edition)
College Physics (10th Edition)
Cosmic Perspective Fundamentals
Essential University Physics: Volume 2 (3rd Edition)
- HEIGHT OF A CONTINENT ABOVE THE MANTLE. In the figure below, a simple model considers a continent as a block (density = 2,800 kg/m^3) floating in the mantle (density = 3,300 kg/m3). Assuming the continent is 35 km thick (the average thickness of the Earth's crust), estimate the height (in km) of the continent above the surrounding mantle. Continent (density = 2800 kg/m3) mg Mantle rock (density = 3300 kg/m³) 5.3. 7.4. 9.8 12. 17.arrow_forwardYou want to use radiometric dating to determine the age of a specimen. You use Isotope Z, which has a half-life of 645 years. You measure your sample and find that 1/16 of the original amount of Isotope Z is present. How old is the sample?arrow_forwardThe majority of the research shows that tectonic plates move at the average rate of between approximately 0.60 cm/yr to 10 cm/yr. (a) What distance does it move in 1 s at this speed range? (b) What is its speed in kilometers per million years?arrow_forward
- Earth's mass ia 6x10^24 kg and its radius is 6.4x10^6 m. What is the average mass density of Earth? The density of the rocks compromising Earth's outermost layer (its "crust") ranges from 2000 to 3500 kg/m ^3. Based on your answer, what can you conclude about the material deep inside Earth's interior?arrow_forwardA seismic station located 60 km from the epicenter of an earthquake, recorded the maximum height of the S-waves to be 50 mm. What was the Richter magnitude of this earthquake?arrow_forwardYou are on an oceanographic research expedition that began in San Juan, Puerto Rico on September 14. The ship left port at 0630 hr on 14 September and covered a distance of 1608 km to the first drill location (Site 1) where you are going retrieve a drill core of seafloor sediments. The ship arrived at the first drill site at 1800 hr on 16 September. Calculate the rate of travel (i.e., speed) of the ship during its transit to the first drill site.arrow_forward
- The energy released in an aftershock is 1/8 of that in an earthquake with a magnitude of 7.2 on the Richter scale. Find the magnitude of the aftershock on the Richter scale. (Give your answer correct to 1 decimal place.)arrow_forwardHow far from a seismic station did an earthquake occur if S-waves arrived there 7 minutes after P-waves. (You may assume that P- and S-waves travel at speeds of 5 km/s and 3 km/s, respectively).arrow_forwardUse the Richter scale r=log 1/i0 to find the intensity of the following earthquakes (let i0=1) a. magnitude 7.6 earthquake in Peru (2015) b. Magnitude 5.5 earthquake in Pakistan c how many times more intense was the earthquake in Peru compared to the one in Pakistanarrow_forward
- Calculate the surface wave magnitude MS for an earthquake with IMM of VII, in an area that can be approximated by a circle with radius 20 km for a site at the borders of the given isoseismal. This site is located in the western United States. Compare the ensuing value with the estimations from relationships with other magnitude scales. Calculate the fault surface displacements. Assume that the earthquake mechanism is normal faulting.arrow_forwardThe intensity of a wave of an earthquake is measured as 9 J/m². At a different point 8.6 km away from the first point the intensity is reduced by 20%. At what distance from the centre of the earthquake is the first intensity measured. Please give your result in km with 1 decimal. (The centre of the earthquake, the first point and the second point should all be in one straight line).arrow_forwardThe Richter Scale is used for measuring the magnitude of earthquakes. the magnitude of an earthquake is, by deifnition, measured 100 kilometers from its originating point, and is given by the equation M = log(s/10^-4), where S is the "strength" of the earthquake, as determined by the shockwaves it sends through the ground. Earthquake strengths vary greatly from 0 in some cases to 800,000,000 or more in other cases which is why a logarithmic scale is used to measure their magnitudes. (I already know Part A) Part B Suppose a given earthquake is twice as strong as another earthquake. Determine the difference in magnitude of these earthquakes. Part C The largest manmade explosion was the test detonation of the Tsar Bomba hydrogen bomb. It was equivalent to about 50 million tons of TNT. It was similar in intensity to a magnitude 8.5 earthquake. The stronger earthquake ever recorded was the 1960 Valdivia earthquake than the Tsar Bomba? How much TNT was the earthquake equivalent to? Show…arrow_forward
- Foundations of Astronomy (MindTap Course List)PhysicsISBN:9781337399920Author:Michael A. Seeds, Dana BackmanPublisher:Cengage LearningAn Introduction to Physical SciencePhysicsISBN:9781305079137Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar TorresPublisher:Cengage Learning
- AstronomyPhysicsISBN:9781938168284Author:Andrew Fraknoi; David Morrison; Sidney C. WolffPublisher:OpenStax