Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 20, Problem 10RQ
Why do some manufacturers protect the headlamp circuit with a circuit breaker instead of a fuse?
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Why is high voltage needed to establish a spark across the gap of a spark plug
Why do most automotive spark plugs have a resistor between the top terminal and the centre electrode?
to increase electrode heat
to decrease voltage requirements
to increase current flow
to reduce RFI
Which one of the below is not the source of UV radiation?
Sunlight
Electric arc
UV lamp
Torchlight
Chapter 20 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 20 - What lighting systems are controlled by the...Ch. 20 - What is a CHMSL?Ch. 20 - True or False? HID lamps produce more heat and...Ch. 20 - True or False? The headlights on many adaptive...Ch. 20 - True or False? All turn signal flasher units...Ch. 20 - Which of the following may cause the turn signal...Ch. 20 - What are the most probable causes for one low-beam...Ch. 20 - How many wires are normally connected to a double...Ch. 20 - Circuits that can energize the high beams even if...Ch. 20 - Why do some manufacturers protect the headlamp...
Ch. 20 - What types of headlights do not have a filament?Ch. 20 - What is the primary tool used to diagnose an auto...Ch. 20 - Which of the following would probably not cause...Ch. 20 - The stoplight switch is normally mounted on the...Ch. 20 - Which of the following is not a true statement...Ch. 20 - While troubleshooting a headlight problem:...Ch. 20 - Technician A says that the condition of the...Ch. 20 - Composite headlights are being discussed:...Ch. 20 - While troubleshooting a brake light problem;...Ch. 20 - Technician A says that a sealed-beam headlight...Ch. 20 - While diagnosing an HID lamp that does not turn...Ch. 20 - Technician A says that flickering vehicle lights...Ch. 20 - The turn signals operate in the left direction...Ch. 20 - The right back-up lamp is dim: Technician A says...Ch. 20 - When the headlights are switched from low beam to...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- When the headlights are switched from low beam to high beam, all headlights go out: Technician A says that the problem may be a bad dimmer switch. Technician B says that the ignition switch may be bad. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardWhich of the following is not a true statement about lamp-out warning lights? The lamp-out warning module measures small changes in voltage levels. An electronic switch in the module completes a ground path for the indicator lights in the event of a bulb going out. A special resistance wire is used in multibulb systems. When a bulb burns out. the module senses the increased voltage drop and turns on the indicator lamp.arrow_forwardWhich of the following would probably not cause the headlights on both sides of the vehicle not to work? An open in the power or ground circuit A bad (control) switch A blown fuse Low generator outputarrow_forward
- While troubleshooting a headlight problem: Technician A says that when one headlamp does not work, the problem may be a burned-out bulb or lamp. Technician B says that you should check for voltage at the bulb before replacing a bulb. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardIn El systems using one ignition coil for every two cylinders: Technician A says that two plugs fire at the same time with the same voltage used by each spark plug. Technician B says that one plug fires in the normal direction (center to side electrode) and the other in reversed polarity (side to center). Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardWhen used as a photovoltaic device, how much voltage is generally produced by a photodiode?arrow_forward
- Which of the following is false? The air bag igniter assembly is a spark plug-type device with two pins that current must jump across. The air bag igniter assembly creates a spark that ignites a canister of gas generating zerconic potassium perchlorate. The air bag igniter assembly is housed in the module assembly. None of the above.arrow_forwardWhile diagnosing the location of a wire-to-wire short: Technician A checks the wiring of the affected circuits for signs of burned insulation and melted conductors. Technician B checks common connectors shared by the two affected circuits. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardHow do most electronic ignition systems differ? number of spark plugs the use of CMP and CKP sensors number of transistors the use of a distributorarrow_forward
- While discussing spark plugs: Technician A says that too narrow of a spark plug gap can cause a rough idle and premature wear of the electrodes. Technician B says that a spark plug with the wrong reach can cause preignition. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor Barrow_forwardTrue or False? A spark plug with two ground electrodes will provide two separate sparks when fired.arrow_forwardWhat types of headlights do not have a filament?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningUnderstanding Motor ControlsMechanical EngineeringISBN:9781337798686Author:Stephen L. HermanPublisher:Delmar Cengage LearningWelding: Principles and Applications (MindTap Cou...Mechanical EngineeringISBN:9781305494695Author:Larry JeffusPublisher:Cengage Learning
- Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage LearningElectrical Transformers and Rotating MachinesMechanical EngineeringISBN:9781305494817Author:Stephen L. HermanPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Understanding Motor Controls
Mechanical Engineering
ISBN:9781337798686
Author:Stephen L. Herman
Publisher:Delmar Cengage Learning
Welding: Principles and Applications (MindTap Cou...
Mechanical Engineering
ISBN:9781305494695
Author:Larry Jeffus
Publisher:Cengage Learning
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
Electrical Transformers and Rotating Machines
Mechanical Engineering
ISBN:9781305494817
Author:Stephen L. Herman
Publisher:Cengage Learning
Materials Science Mechanical Engineering - Part 3 Corrosion Explained; Author: Mega Mechatronics;https://www.youtube.com/watch?v=Il-abRhrzFY;License: Standard Youtube License