Sketch the amplitude and phase plots for the given periodic voltage.

Question

Want to see the full answer?

Answer 1

Question

Chapter 16, Problem 50P

a.

To determine

Sketch the amplitude and phase plots for the given periodic voltage.

b.

To determine

Sketch the amplitude and phase plots for the given periodic current.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

2. A 3-phase, 75 MVA, 11-8 kV star-connected alternator with a solidly earthed neutral point has the fol- lowing p.u. impedances based on rated phase voltage and rated phase current : Positive phase sequence impedance Negative phase sequence impedance Zero phase sequence impedance = j 2 p.u. = j 0.16 p.u. = j 0.08 p.u. Determine the steady-state fault current for the following: (i) 3-phase symmetrical short-circuit (ii) one line-to-earth fault (iii) two line-to-earth fault. The generated e.m.f. per phase is equal to the rated voltage. [(i)1840 A (ii) 4920 A (iii) 3580 A]

Make sure you indicate clearly the questions attempted Show your work to earn marks. • Enjoy Q1. With the help of a well-drawn diagram, explain concept map of an electromechanical system modelling. [20] Q2. Separately-excited generator develops a no load emf of 150V at an armature spend of 20 rev/s and a flux per pole of 0.1 Wb. determine the generated emf when a. The spend increases to 25rev/s and the pole flux remains unchanged. b. The speed remains at 20 rev/s and the pole flux is decreased to 0.08Wb. c. The speed increases to 24 rev/s and the pole flux is decreased to 0.07 Wb Write short notes on the following term a. Copper loss b. Iron loss c. Friction and Windage losses. [20]

Q4. A 415V, three phase, 50 Hz 4 pole, star connected induction motor ruins at 24 rev/s on full load. The rotor resistance and reactance per phase are 0.35 ohms and rotor respectively and the effective rotor stator turns ratio is 0.85:1 calculate: a. The synchronous speed b. The slip. c. The full load torque. d. The power output if mechanical losses amount to 770 W e. The maximum torque f. The speed at which maximum torque occurs g. The starting torque h. Direct on-line starting i. Star delta starting [20]