Concept explainers
A solution is saturated in
?
a. Solid
b. Gaseous
c. Solid
d. Nothing happens (both
Want to see the full answer?
Check out a sample textbook solutionChapter 13 Solutions
INTRODUCTORY CHEMISTRY-W/SEL.SOLN.MAN.
Additional Science Textbook Solutions
Chemistry: The Central Science (14th Edition)
Organic Chemistry
Organic Chemistry
Chemistry
Elementary Principles of Chemical Processes, Binder Ready Version
- According to the Resource Conservation and Recovery Act (RCRA), waste material is classified as toxic and must be handled as hazardous if the lead concentration exceeds 5 mg/L. By adding chloride ion, the lead ion will precipitate as PbCl2, which can be separated from the liquid portion. Once the lead has been removed, the rest of the waste can be sent to a conventional waste treatment facility. How many grams of sodium chloride must be added to 500 L of a waste solution to reduce the concentration of the Pb2+ ion from 10 to 5 mg/L?arrow_forwardA 0.250-M sodium sulfate solution is added to a 0.200-M barium nitrate solution and 0.700 g barium sulfate precipitates. Write the balanced equation for this reaction. Calculate the minimum volume of barium nitrate solution that was used. Calculate the minimum volume of sodium sulfate needed to precipitate 0.700 g barium sulfate. Assume 100% yield.arrow_forward. Why does the amount of excess solid solute present in a solution not affect the amount of solute that ultimately dissolves in a given amount of solvent?arrow_forward
- Simple acids such as formic acid, HCOOH, and acetic acid, CH3COOH, are very soluble in water; however, fatty acids such as stearic acid, CH3(CH2)16COOH, and palmitic acid, CH3(CH2)14COOH, are water-insoluble. Based on what you know about the solubility of alcohols, explain the solubility of these organic acids.arrow_forwardMaple syrup sap is 3% sugar (sucrose) and 97% water bymass. Maple syrup is produced by heating the sap toevaporate a certain amount of the water. (a) Describe what happens to the composition and boilingpoint of the solution as evaporation takes place. (b) A rule of thumb among maple syrup producers is thatthe finished syrup should boil about 4 C higher than theoriginal sap being boiled. Explain the chemistry behindthis guideline. (c) If the finished product boils 4 C higher than the originalsap, calculate the concentration of sugar in the finalproduct. Assume that sugar is the only solute and theoperation is done at 1 atm pressure.arrow_forwardThe solubility of ammonium formate, NH4CHO2, in 100. g of water is 102 g at 0 C and 546 g at 80 C. A solution is prepared by dissolving NH4CHO2 in 200. g of water until no more will dissolve at 80 C. The solution is then cooled to 0 C. What mass of NH4CHO2 precipitates? (Assume that no water evaporates and that the solution is not supersaturated.)arrow_forward
- Dissolving CaCO3 is an endothermic reaction. The following five graphs represent an experiment done on CaCO3. Match the experiment to the graph. (a) HCl is added. (b) The temperature is increased. (c) CaCl2 is added. (d) NaCl is added.arrow_forwardCalcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?arrow_forwardThe ore cinnabar (HgS) is an important source of mercury. Cinnabar is a red solid whose solubility in water is 5.5 X 10-2 mol L-1. Calculate its \p. What is its solubility' in grams per 100 g of water?arrow_forward
- Some lithium chloride, LiCl, is dissolved in 100 mL of water in one beaker, and some Li2SO4 is dissolved in 100 mL of water in another beaker. Both are at 10 C, and both are saturated solutions; some solid remains undissolved in each beaker. Describe what you would observe as the temperature is raised. The following data are available to you from a handbook of chemistry:arrow_forward. K for copper(II)hydroxide, Cu(OH)2, has a value 2.21020at 25 °C. Calculate the solubility of copper(II) hydroxide in mol/L and g/L at 25 °C.arrow_forwardYou are designing a process to remove carbonate ions from an aqueous system by precipitation. If the effectiveness of the process is the only concern (meaning there are no environmental or other issues involved), which of the following metal ions would be the best choice: Ca2+,Fe2+,Pb2+,orAg2+ ? Explain your answer. Salt Ksp CaCO3 4.8109 FeCO3 3.51011 PbCO3 1.51013 Ag2CO3 8.21012arrow_forward
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage Learning
- Introductory Chemistry: A FoundationChemistryISBN:9781337399425Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningWorld of Chemistry, 3rd editionChemistryISBN:9781133109655Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCostePublisher:Brooks / Cole / Cengage Learning