Concept explainers
Entropy change of air and helium across the normal shock wave.
Answer to Problem 75P
Explanation of Solution
Given:
The properties of air are:
The properties of helium are,
The air properties upstream the shock is, Pressure
Temperature
Mach number
Calculation:
Assumptions
- Air and helium are ideal gases with same specific heats.
- Flow through the nozzle is constant, single dimensional and isentropic before the shock occurs.
Figure shows the air flow with the Mach number,
Downstream Mach number is given by,
Downstream pressure ratio is given by,
Downstream temperature ratio is given by,
Calculate the air, entropy change across the shock ,
Downstream Mach number for helium is given by,
Downstream pressure ratio is given by,
Downstream temperature ratio is given by,
Calculate the helium, entropy change across the shock ,
Conclusion:
Hence, the entropy change of air across the normal shock wave is:
The entropy change of helium across the normal shock wave is:
Want to see more full solutions like this?
Chapter 12 Solutions
FLUID MECHANICS FUND. (LL)-W/ACCESS
- -Converging nozzle is supplied with Po=10 bars and To=D1000 K and discharges to atmosphere with pressure of 9.8 bars and the nozzle exit area is 10 cm. The Mach number at nozzle exit will be: Select one: O a. M-0.46 O b. M=0.55 Oc. M-0.17 O d. M-0.27arrow_forwardGive a physical description of the phenomenon of chokingin a converging-nozzle gas fl ow. Could choking happeneven if wall friction were not negligible?arrow_forwardFind the expression for the ratio of the stagnation pressure after a shock wave to the static pressure before the shock wave as a function of k and the Mach number upstream of the shock wave Ma1arrow_forward
- The velocity of flow after a normal shock wave when (Tx= 315 K, vx= 555 ms-1)arrow_forward69. Determine the aircraft Mach no. flies with the same Mach no. at elevations of 8700m (T=-55 C°) and 11700 m (T = - 62 C°), if the aircraft flies 15% slower at 11700 m altitude. Juls wụs ibarrow_forwardA con area of o.0052r venging-diverg ing nozzle with a th voat D attached to Very lange tank of air in which the pressure 's 136 k pa and temperatune is 67 C O-00 The nozzle exhaupt to atmosphene With a pressune of l05 kpa-if the meess- flow vate is (2 kys)• Jerermine the exik and Mach noutber num ber' at the throat- The flow in the hozle is isenaropic Po:136 Ken Pbsl05Kpy To z67 Carrow_forward
- For steady isentropic flow of perfect gas in constant area duct, the change of gas velocity to the sound speed relation can be given byarrow_forward(a) What is the exit temperature? (b) What is speed of sound at the exit? (c) What is the exit speed? (a) Texit = i (b) Cexit = (c) Vexit = i i R ft/s ft/sarrow_forward10-20 kg m-3. Consider a blast wave expanding radially in a solar wind with p = Po(R/AU)-2 and Po A large flare can release 1025 J of energy. Calculate, using the Taylor-Sedov solution with C' = 1, how far the shock wave propagates before it is decelerated to the solar wind speed of 400 km s-1. %3Darrow_forward
- Air flows in a constant-area duct as shown in the figure. Assume Rayleigh line flow and the air to behave as a perfect gas with constant specific heats. For choked duct, determine: 1. Mach number at inlet (M1) 2. Stagnation temperature at inlet (To1) 3. Critical stagnation temperature (T.") 4. Mass flow rate 5. Heat input to choke the duct (q). q =? Vi = 100 m/s T1 = 320 K P1 = 200 kPa d = 1.5 cmarrow_forwardFalcon 9 rocket engine, fuel mixture LOX/RP1 is combusted in a large tank and exhauststhrough a converging-diverging (C-D) nozzle. The combustion gas (k = 1.221, R = 0.3885kJ/kg.K) in the large tank has a temperature of 3500 K and pressure 9 MPa (abs). The throatdiameter of the C-D nozzle is 0.5334 m and the nozzle operates at design condition at 20km altitude. The flow in the C-D nozzle is steady and isentropic.Air pressure above sea level can be calculated as :p = 101325 (1 – H x 2.25577 x 10-5)5.25588where101325 = normal temperature and pressure at sea level (Pa)p = air pressure (Pa)H = altitude above sea level (m) Express ALL answers in 4 significant figures. (a) Calculate : Velocity at the Exit and the diameter of the EXIT.(b) Calculate the Thrust produced. Help me to solve a and b please im stuckarrow_forwardGas dynamics Dr. Sajida Lafta Q5- Air enters a 15 m long. 4 cm diameter adiabatic duct at V=70 m's, T=500 K, and P=300 kPa. The average friction factor for the duct is estimated to be 0.023. Determine the Mach number at the duct exit, the exit velocity, and the mass flow rate of air.arrow_forward
- Elements Of ElectromagneticsMechanical EngineeringISBN:9780190698614Author:Sadiku, Matthew N. O.Publisher:Oxford University PressMechanics of Materials (10th Edition)Mechanical EngineeringISBN:9780134319650Author:Russell C. HibbelerPublisher:PEARSONThermodynamics: An Engineering ApproachMechanical EngineeringISBN:9781259822674Author:Yunus A. Cengel Dr., Michael A. BolesPublisher:McGraw-Hill Education
- Control Systems EngineeringMechanical EngineeringISBN:9781118170519Author:Norman S. NisePublisher:WILEYMechanics of Materials (MindTap Course List)Mechanical EngineeringISBN:9781337093347Author:Barry J. Goodno, James M. GerePublisher:Cengage LearningEngineering Mechanics: StaticsMechanical EngineeringISBN:9781118807330Author:James L. Meriam, L. G. Kraige, J. N. BoltonPublisher:WILEY