The factors influencing the vehicles turning right on red indication and the recommendation provided by Highway Capacity Manual, if the field data on the right turn on reds cannot be collected.

Question

Want to see the full answer?

Answer 1

Question

Chapter 10, Problem 2P

To determine

The factors influencing the vehicles turning right on red indication and the recommendation provided by Highway Capacity Manual, if the field data on the right turn on reds cannot be collected.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Two adjacent signalized intersections along a major arterial are 650 ft apart (stop line to stop line distance). If the space mean speed between these two intersections is 22 mph, what should be the signal offset of the downstream intersection relative to the upstream intersection? Group of answer choices 20.0 sec 13.5 sec 40.0 sec 29.5 sec

A developer has applied for a construction permit to build a supermarket at the southeast cornerof an intersection that is formed by a four-lane divided highway in the east-west direction and atwo-lane road in the north-south direction. Traffic on the two-lane road is controlled by a stop signat the intersection. The speed limit on the four-lane highway is 88 km/h. using the sight trianglerequirements at the intersection (Case B1), determine whether permission should be given for theconstruction if the following conditions exist. Provide a diagram for your solution.Major road lane width = 3.6 mMinor road lane width = 3.3 mMedian lane = 2.8 mDesign vehicle is a passenger carApproach grade = 2%Maximum feasible distance building from the center of the nearest lane of four-lane road = 5.4 mMaximum feasible distance building from the center of the nearest lane of two-lane road = 16.5 m

Task 3: The Intersection design a. Describe the various principles involved in the design of at-grade intersections and the different types of at-grade intersections. Also, give an example of an appropriate location for the use of each type. b. Design a suitable signal phasing system and phase lengths for the intersection using the Webster method. Show a detailed layout of the phasing system and the intersection geometry used for the geometric and traffic characteristics shown in table 6 below. And the saturation flow of the intersection is shown in table 7 Discuss the effect of increasing saturation flow rates by 10% higher on the cycle length? Table 6:The geometric and traffic characteristics of the intersection Approach (Width) North (56m) South (56 m) East (68m) West (68m) Peak hour approach volumes Left turn 133 73 168 134 Through movement 420 373 563 516 Right turn 140 135 169 178 Conflicting pedestrian volumes 900 1200 1200 900 PHF 0.95 0.95 0.95 0.95…