Electric Circuits (10th Edition)
10th Edition
ISBN: 9780133760033
Author: James W. Nilsson, Susan Riedel
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Question
Chapter 10, Problem 18P
To determine
Find the average power, the reactive power, and the apparent power absorbed by the load in the given circuit using PSPICE.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
2. A 3-phase, 75 MVA, 11-8 kV star-connected alternator with a solidly earthed neutral point has the fol-
lowing p.u. impedances based on rated phase voltage and rated phase current :
Positive phase sequence impedance
Negative phase sequence impedance
Zero phase sequence impedance
=
j 2 p.u.
=
j 0.16 p.u.
=
j 0.08 p.u.
Determine the steady-state fault current for the following: (i) 3-phase symmetrical short-circuit (ii) one
line-to-earth fault (iii) two line-to-earth fault. The generated e.m.f. per phase is equal to the rated voltage.
[(i)1840 A (ii) 4920 A (iii) 3580 A]
Make sure you indicate clearly the questions attempted
Show your work to earn marks.
• Enjoy
Q1. With the help of a well-drawn diagram, explain concept map of an electromechanical
system modelling.
[20]
Q2. Separately-excited generator develops a no load emf of 150V at an armature spend of 20
rev/s and a flux per pole of 0.1 Wb. determine the generated emf when
a. The spend increases to 25rev/s and the pole flux remains unchanged.
b. The speed remains at 20 rev/s and the pole flux is decreased to 0.08Wb.
c. The speed increases to 24 rev/s and the pole flux is decreased to 0.07 Wb
Write short notes on the following term
a. Copper loss
b. Iron loss
c. Friction and Windage losses.
[20]
Q4. A 415V, three phase, 50 Hz 4 pole, star connected induction motor ruins at 24 rev/s on
full load. The rotor resistance and reactance per phase are 0.35 ohms and rotor respectively
and the effective rotor stator turns ratio is 0.85:1 calculate:
a. The synchronous speed
b. The slip.
c. The full load torque.
d. The power output if mechanical losses amount to 770 W
e. The maximum torque
f. The speed at which maximum torque occurs
g. The starting torque
h. Direct on-line starting
i. Star delta starting
[20]
Chapter 10 Solutions
Electric Circuits (10th Edition)
Ch. 10.2 - For each of the following sets of voltage and...Ch. 10.2 - Compute the power factor and the reactive factor...Ch. 10.3 - The periodic triangular current in Example 9.4,...Ch. 10.5 - The voltage at the terminals of a load is 250...Ch. 10.5 - Find the phasor voltage Vs in the circuit shown if...Ch. 10.6 - Find the average power delivered to the 100Ω...Ch. 10.6 - Find the average power delivered to the 400Ω...Ch. 10.6 - Prob. 11APCh. 10 - Prob. 1PCh. 10 - A college student wakes up hungry. He turns on the...
Ch. 10 - Show that the maximum value of the instantaneous...Ch. 10 - A load consisting of a 480 Ω resistor in parallel...Ch. 10 - Prob. 5PCh. 10 - Prob. 6PCh. 10 - The op amp in the circuit shown in Fig. P10.8 is...Ch. 10 - Calculate the real and reactive power associated...Ch. 10 - Prob. 9PCh. 10 - The load impedance in Fig. P10.10 absorbs 6 kW and...Ch. 10 - A personal computer with a monitor and keyboard...Ch. 10 - Prob. 12PCh. 10 -
The periodic current shown in Fig. P10.12...Ch. 10 - Find the rms value of the periodic voltage shown...Ch. 10 - Prob. 15PCh. 10 - Prob. 16PCh. 10 - The current Ig in the frequency-domain circuit...Ch. 10 - Prob. 18PCh. 10 - Find VL (rms) and θ for the circuit in Fig. P10.17...Ch. 10 - Find the average power, the reactive power, and...Ch. 10 -
Two 480 V (rms) loads are connected in parallel....Ch. 10 -
The two loads shown in Fig. P10.22 can be...Ch. 10 - Prob. 23PCh. 10 - Prob. 24PCh. 10 - Prob. 25PCh. 10 - Prob. 26PCh. 10 - Prob. 27PCh. 10 - Three loads are connected in parallel across a 300...Ch. 10 - The three loads in Problem 10.28 are fed from a...Ch. 10 - The three loads in the circuit in Fig. P10.27 can...Ch. 10 - Find the average power dissipated in the line in...Ch. 10 - Prob. 32PCh. 10 - Prob. 33PCh. 10 - A factory has an electrical load of 1600 kW at a...Ch. 10 - Prob. 35PCh. 10 - Prob. 36PCh. 10 - Find the average power delivered to the 8 Ω...Ch. 10 - Prob. 38PCh. 10 - Find the average power dissipated in each resistor...Ch. 10 - Prob. 40PCh. 10 - Prob. 41PCh. 10 - Prob. 42PCh. 10 - Prob. 43PCh. 10 - Prob. 44PCh. 10 - Prob. 45PCh. 10 - The variable resistor in the circuit shown in Fig....Ch. 10 - Prob. 47PCh. 10 - Prob. 50PCh. 10 - Prob. 51PCh. 10 - The 160 Ω resistor in the circuit in Fig. P10.51...Ch. 10 - Prob. 53PCh. 10 - Prob. 54PCh. 10 - The values of the parameters in the circuit shown...Ch. 10 - Prob. 57PCh. 10 - Prob. 58PCh. 10 - Prob. 59PCh. 10 - Prob. 60PCh. 10 - Prob. 61PCh. 10 - The ideal transformer connected to the 5 kΩ load...Ch. 10 - Prob. 63PCh. 10 - Prob. 64PCh. 10 - Prob. 67PCh. 10 - Prob. 68PCh. 10 - Prob. 69PCh. 10 - Prob. 70PCh. 10 - Prob. 71P
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- 3. The per unit values of positive, negative and zero sequence reactances of a network at fault are 0.08, 0.07 and 0.05 respectively. Determine the fault current if fault is line-to-line-to-ground. [j 16 p.u.]arrow_forwardFor the network shown in Figure B2, the switch is closed on to position I when t = 0 and then moved to position 2 when t = 100 ms. 1V 50 R₁ R₂ 200 10 mH Figure B2 a) i. What is the value of the time constant when charging (position I)? ii. Determine the current equation when charging (position I) [I mark] [2 marks] b) Determine the value of the charging current at 1.5 ms. [3 marks] i. What is the value of the time constant when discharging? [2 marks] ii. Determine current equation when discharging (remember switch is moved to position 2 when t = 100 ms) [3 marks] c) Determine the current in the inductor when t = 102.5 ms (remember switch is moved to position 2 when t = 100 ms) [4 marks]arrow_forwardNEED HANDWRITTEN SOLUTION PLEASE DO NOT USE AIarrow_forward
- NEED HANDWRITTEN SOLUTION PLEASE DO NOT USE AIarrow_forward1) What is the value of the current through the battery when the switches SW1, SW2, and SW3 are OPEN?arrow_forwardIn the circuit of the figure, ε = 12.2 V, R = 7.34 Ω and L = 5.48 H. The battery is connected at t = 0. Determine: a) The amount of energy delivered by the battery during the first 2.00 s. b) The amount of energy stored in the magnetic field of the inductor. c) The amount of energy dissipated in the resistor.arrow_forward
- 4) For the sinusoidal signal m(t) = 2 sin(1000πt + 0.0557), shown down, is sampled, quantized and then encoded using the PCM technique. If a uniform quantizer, with 8 levels and a dynamic range [-2, 2], is used (a) Calculate the first 4 quantized samples and the ciated quantization errors. (b) Calculate the maximum quantization error (c) Calculate the signal-to-quantization- noise ratio. (d) Calculate the resultant bit rate. italicio (e) If it is required to increase the signal-to-quantization-noise ratio by 6 dB, how many quantization levels should be used in this case? What is the ratio between the new bit rate and the previous bit rate? msecarrow_forwardThe current of a 90.0 mH inductor changes with time in the form I=1.00t2 - 6.00t (in SI units). Determine the magnitude of the induced fem at a) t=1.00 s b) At what time will the fem equal zero?arrow_forwardA coil of 200 turns and 4 cm2 of section, is rotating in a magnetic field of 0.5 T. a) What must be its angular frequency to generate a maximum fem (εm) of 10 V?b) What is the value of εm if it rotates at 60 rev/s?arrow_forward
- An aluminum wire of constant circular cross section with a diameter of 4.00 mm is subjected to a uniform electric field of 0.2 V/m. Determine: (a) The current through the conductor if its conductivity is 3.64x107 Ω-1.m-1. b) The number of free electrons per unit volume if one conduction electron per aluminum atom is assumed. (The density is 2.7 g/cm3 and the molar mass is 27 g/mol). c) The drift velocity.arrow_forwardQ1) Your Company has a large data store that needs to back up to a new site every week. The volume of the data to backup every week is 10 TB. You have two choices: Choice #1: Use your high-speed Internet connection and transfer all the data over the Internet; Your Internet connection is 100 Mbps. Choice #2: Copy your data to a number of portable hard disks, drive them over in your van, then read data from the hard disks at the new site. The read/write speed of your portable hard disks is 500 Mbps. Each disk can hold 1 TB. You can only copy to or read data from one disk at a time. You need to drive 1 hour to the new site. a) Compute the data rate for the two choices. b) Which choice is faster?arrow_forwardframe size frame containing the seven bits 1100010 is received. The last 3 bits are the CRC generated using the generator polynomial G(x) = x+x+1. Does this frame contain an error? Show your calculations. data stream. Harrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,
Introductory Circuit Analysis (13th Edition)
Electrical Engineering
ISBN:9780133923605
Author:Robert L. Boylestad
Publisher:PEARSON
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Programmable Logic Controllers
Electrical Engineering
ISBN:9780073373843
Author:Frank D. Petruzella
Publisher:McGraw-Hill Education
Fundamentals of Electric Circuits
Electrical Engineering
ISBN:9780078028229
Author:Charles K Alexander, Matthew Sadiku
Publisher:McGraw-Hill Education
Electric Circuits. (11th Edition)
Electrical Engineering
ISBN:9780134746968
Author:James W. Nilsson, Susan Riedel
Publisher:PEARSON
Engineering Electromagnetics
Electrical Engineering
ISBN:9780078028151
Author:Hayt, William H. (william Hart), Jr, BUCK, John A.
Publisher:Mcgraw-hill Education,
02 - Sinusoidal AC Voltage Sources in Circuits, Part 1; Author: Math and Science;https://www.youtube.com/watch?v=8zMiIHVMfaw;License: Standard Youtube License