Answered: You know two forces are balanced if the…

Science

Physics

You know two forces are balanced if the net force is.....

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter9: Linear Momentum And Collisions

Section: Chapter Questions

Problem 90AP: Repeat the preceding problem, but including a drag force due to air of fdrag=bv .

See similar textbooks

Related questions

Q: dropping an elephant and a mouse from a tall building, the mouse survived the fall but the elephant…

A: A mouse and an elephant dropped from same height. We have to explain as to why mouse survived the…

Q: Does fluid friction vary with speed? With area of contact?

A: The fluid friction arises due to the sliding of the different layers on top of each other moving…

Q: A 6-meter-long beam which has a mass of 40kg, is held up by two ropes. An 80kg mass is placed 1…

A: Given data: The mass of beam is m=40 kg. The length of beam is l=6 m. The mass at x=1 m is m1=80…

Q: If forces always occur in pairs that are equal and opposite, why don’t they always cancel?

A: The third law of motion states that for every action there is an equal and opposite reaction but…

Q: 4- |Ā| A 5- | B| 6-А. В

A: Given data: A→ = 2i^ + 3j^ + 4k^B →= i^ - 2j^ + 3k^

Q: A hungry bear weighing 725 N walks out on a beam in an attempt to retrieve a basket of goodies…

Q: The boom of the wall crane 4m long is held at right angles to the wall by a wire that is attached to…

A: Given: Load lifted W = 45000 N. Length L = 4m. To determine: Tension in the wire.

Q: beam that has a mass of 75kg extends from a building making a 48° angle with it. A wire is…

A: Given beam that has a mass of 75kg extends from a building making a 48° angle with it. A wire is…

Q: How this force of the same magnitude and direction should be applied that the box only slides or…

A: In case of topple, the moment will be in equilibrium condition about the point of contact.

Q: Calculate the power oft an electric motor that can lift 800 kg of water to store in a tank at a…

A: Given, mass of water=m=800kg height to lift=h=1500cm=15 m Time=20 s g=10 m/S^2 as we know that power…

Q: A body of mass 4kg is connected to a body of mass 7kg with inextensible string pass over a pulley…

A: Given quantities: first mass (m) = 4 kg second mass (M) = 7 kg tension on the first mass (T) = 50 N…

Q: A 0.700-kg ball is on the end of a rope that is 1.70 m in length. The ball a including the pole,…

A: Given:- The mass of the ball is m = 0.700 kg The length of the rope L= 1.70 m The rope makes an…

Q: A grocery sack can withstand a maximum of 230 N bee it rips. Will a bag holding 15 kg of groceries…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A sphere kept on a rough inclined plane in a equilibrium by a string Wrapped over it. If the angle…

A: To determine Tension in the string for the given data.

Q: A hungry bear weighing 705 N walks out on a beam in an attempt to retrieve a basket of goodies…

A: a. The free body diagram of the beam is shown below.

Q: All forces require an input o

A: All forces require energy. A force requires two important properties that are magnitude and…

Q: Calculate the load?

A: Given data; Mechanical advantage of a machine=10 Effort given to the machine=4kgf Calculate the…

Q: a ball is just supported by a string without breaking. If it is set swinging, it breaks, why?

A: When a ball is tied to a string, it is free to do only circular motion with the help of the string.…

Q: Why are lightweight tires preferred over lightweight frames in bicycle racing?

A: The use of lightweight tires over the lightweight frames in bicycle racing is related to the concept…

Q: A 4m woooden beam of mass 20kg rests on two scales. A bird is setting on the wooden beam. The scale…

A: Given: Length of wooden beam is 4m. Mass of wooden beam is 20 kg. Reading on the left scale is 100…

Q: dyne.sec, 7- Prove that (1 poise = ст?

A: We can write for the relation between CGS and SI units as;

Q: A strong weightless rope has a mass m hanging from the middle of it, as shown. The tension force on…

A: Given: The mass of the rod is m. The tension in the cable is 25 N. θ=20°

Q: A tadpole swims across a pond at 3.50 cm/s. The tail of the tadpole exerts a force of 28.0 mN to…

Q: What is the advantage to a gymnast of beung short in stature?

A: The centre of gravity of a person having short stature is closer to the ground than that of a taller…

Q: You have a summer job working downtown washing windows on skyscrapers (the pay is great and so are…

Q: A 10.2 kg cannonball rests between a ramp and a vertical wall as shown. The ramp is inclined at an…

A: The free-body diagram of the ball is shown below. Here, F1, F2, and m are the normal forces and the…

Q: ed tree, a rope is attached horizontally from the top of 600 N is applied downward at the center of…

Q: A horizontal force of 5 kN is acting on the wedge, as shown in the figure. The coefficient of…

A: Given data: The force act on the wedge is 5 kN The coefficient of friction is μ=0.25

Q: Why do spring balances show wrong readings after they have been used for long time?

A: Elastic fatigue is the property of an elastic body which, under the action of repeated alternating…

Q: Discuss how the shapes of different animals' bodies are designed to reduce friction

A: Required : How the shapes of different animals' bodies are designed to reduce friction.

Q: A 6 ft board with mass of 2 kg is horizontal and attached to a swivel on one side, the other is…

A: The potential energy of the center of mass of the board is converted into kinetic energy. mgh=12mv2

Q: the mast of a sailboat is supported at the bow and stern by stainless steel wires, the forstay and…

Q: kg is lifted 10 m above th , measured in watts (W): nd to the nearest whole

Q: 3.2. A spring balance indicates a mass of 10.0 g on zero load and 60.3 g with a true load of 50.0 g.…

A: In the given solution, formula used is,True load=Zero error+Compression Factor×Reading

Q: A force of 5kgf is required to cut a metal sheet. A shears used for cutting the metal sheet has its…

A: Given that, Load resistance L= 5 kg Load arm (L. A)=5cm Effort arm (E. A) = 10 cm Let effort be E

Q: 30 N D 40 N 20 N A 'B 10 N The above figure indicates a net force of 28.3 N along the diagonal CA a…

Q: Nobody at the playground wants to play with the obnoxious boy, so he fashions a seesaw as shown so…

A: The picture shows the boy sitting on the board with the fulcrum being extremely close to him and…

Q: An 80-kg man balances the boy on a teeter-totter as shown. Note: Ignore the weight of the board.…

A: Given Mass of man = 80 kg Distance of man from fulcrum = 1 m Distance of boy from fulcrum = 4 m Beam…

Q: A block with a mass m = 10kg is sitting on an inclined plane witn an angle of 30 degrees. The block…

Q: A rock is sitting on the ground. Which of the following best describes what you can do to the rock…

A: (a) 4th option is correct . Lift the rock . Explanation :- When we lift the rock it's…

Concept explainers

Debye Theory of Solids

In solid-state physics, debye theory is used to estimate the phonons contributing to the specific heat capacity in a solid. It explains that the specific heat is a consequence of the vibrations of the atomic lattice of the solid, which is in contrast to the Einstein model. In the Einstein model, solids are treated as independent, non-interacting quantum harmonic oscillators. This model clearly explains the low-temperature dependence of the heat capacity, which is proportional to T3. This is known as Debye T3 law.

Question

You know two forces are balanced if the net force is.....

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

While catching a cricket ball . the player lowers his hand . Why?
how far should you separate two particles which have 5 nC and 16 nC in order to have a force of 5.0x10-4 N? (hii favor pls huhu can u write the solution by hand, its so hard to understand the solution sometimes huhu ty!)
Why do we use cos 0 degrees when we calculate external force?
When throwing a football you are always instructed to follow-through. What is the advantage of this? You are also instructed to stand with your feet about shoulder-width apart. What is the advantage of this?
What are informed about a particular force: "the force is inversely proportional to the cube of the distance." If the distance doubles, what happens to the force? Please see photo attached.
. You push a small block that is in contact with a larger block. While the two blocks are in contact, what are the forces that act on each block and on the system as a whole.
Explain why a diver pulls his hands and legsclose to his body when jumping from a divingboard into the swimming pool in order toincrease the number of somersaults.
In a two-dimensional equilibrium problem, you have three equilibrium equations. What are they?
An apple bruises if a force greater than 8.0 N is exterted on it. Would a 0.10 kg apple bruise if it falls 2 meters and stops after sinking 0.060 meters into the grass?
A plank which makes an angle of 50° with the horizontal(green color) is supported by rope. A red color in carrying a load of 300 slugs, as shown. Determine the force exerted by the plank and the rope.
The upper leg muscle (quadriceps) exerts a force of 1200 N, which is carried by a tendon over the kneecap (the patella) at the angles shown in (See attached image). Find the magnitude and direction of the force exerted by the kneecap on the upper leg bone (the femur). ..........................N ..........................° (counter-clockwise from an axis directed to the left)
how far should you separate two particles which have 5 nC and 16 nC in order to have a force of 5.0x10-4 N?