You have 4 acre of watermelons that you irrigate. The irrigation system you use under standard pressure of 35 psi has a flow rate of 105 gpm. The nozzle sprays a circular area with a radius of 24 feet. a. How many square feet are in the water- melon patch? b. What is the area covered by one nozzle? c. How many nozzles are needed?

You have 4 acre of watermelons that you irrigate. The irrigation system you use under standard pressure of 35 psi has a flow rate of 105 gpm. The nozzle sprays a circular area with a radius of 24 feet. a. How many square feet are in the water- melon patch? b. What is the area covered by one nozzle? c. How many nozzles are needed?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

PLEASE PUT ALL THE DECIMAL PLACES. THANK YOU The average hourly water consumption per person is 2.5 Liters anf there are 264 people in the area. Determine the following. a. the minimum rate of flow in L/s in the spring b. Total Daily water demand in L/day c. The daily yield is sufficient to the water demand of the community if the rate of flow is 0.182 L/s d. the height of the cylinder in cm thatt the minimum discharge can fill within 300 secs. diameter of the cylinder is 10 cm.
e sp .gr.= 0.90, is flowing a) what is the discharge in gallons per minuk (gpn)! b.) what is the dischage in mega gallons per day (mgd)! 1-A liquid, sp.gr.= 0.90, is flowing in a 200-mn diareler PIpe at 12m/s.
Do not attempt wrong. If not sure let others expert do it. Don't waste it. Water is withdrawn with differential daily flowrate over 3 days from a groundwater well in a confined aquifer of T = 180m ^ 2 / d * ay Calculate the flowrate during the second day at an observation well 60m away from the main well, given that the discharge for the first day is 125 L/s and for the third day is 100L/s. The total head drop over the three days is 17m. The volume released per unit volume of aquifer per unit drop in the phreatic surface is 0.007.
Below a right circular tank having a diameter of 4m and a meter high is a superimposed hemispherical bowl 2m in radius. A 150mm diameter sharp-edge orifice with a coef. of discharge equal to 0.60 is located at the lowest part of the bowl. If the tank is full of water, determine the a. time in minutes to remove half of the volume contained through the orifice b. time in seconds to remove the content of the cylindrical tank when it's initially full c. time in minutes to empty the composite tank c. time in minutes to empty the composite tank. Please answer all subparts with explanation. Don't copy from other sources. Thanks
In a 20 cm wide rectangular flume, how much time it takes to discharge 1 liter of water? The water is moving at a 1 cm/sec velocity and the flow is 16 cm deep. O 3 sec O 6 sec O 1 sec O 11 sec
Quèstion 49 Avertical cylinder having a circular base of radius 'r and a height of 12 m is filled with water at the rate of 1 m-/min. If the depth of water in the cylinder at the vertical position is 3 m, what would be the resulting depth when the cylinder is in the horizontal position? O A.0.40r O B.0.60r OC.0.30r O D.0.50r « > A Moving to another question will save this response. acer F12 PrtSc Pause Del Home Pg Up F7 F8 F9 F10 F11 F3 F4 F5 F6 Scr Lk SysRq Break Ins * % Backspace 4 5 € 6 7 8 9. W E Y U P F G K
The throat area of a c-d nozzle is 10 cm^2 and its exit is 20 cm^2. If the stagnation pressure is 1 bar, what is the exit pressure (Pe) range needed to ?chock the throat greater or equal 0.935 bar O less or equal 0.937 bar O greater or equal 0.0935 bar and less or equal 0.937 bar greater or equal 0.937 bar and less or equal 1 bar O
You have a run of overhead irrigation pipe that has 20 sprinkler heads in a 600-foot row (oneevery 30’). The effective wetting width of the run is 40 feet. If each sprinkler delivers 3 gallonsper minute, approximately how many minutes will it take to apply ½ inch of water to theirrigated area?a. 125 minutesb. 250 minutesc. 374 minutesd. 500 minutes
Please show complete and clear solution. Thank you! A hilltop subdivision takes water from a river 500 ft below it during the night through a pump storage facility. When morning comes, water will be returned to the river with the use of turbines. Entrance and exit pipes both measure 30-in in diameter and both are 2500 ft long and the flow rate is 20,000 gpm. What should be the pumping power required in horsepower if friction loss amounts to 15 ft of water? Assume that the pump is 100% efficient.
5. Pressurized tank A is supplying water to Pressurized tank B at a rate of 0.1m^3/s as shown. If the pipe is 150mm in diameter with an f= 0.016 and the viscosity of water v = 0.113x10^-5m^2/s Find: K= 0.90 P2 - 40kPa gage Air 295m Air W.S. K=0.40 H2o 25m 150m H2o TANK B K=0.90 TANK A 300m K-0.90 1. Find the Reynold's Number 2. The total Head Loss from A to B (Major and Minor). 3. The total necessary tank pressure for P1
A new water treatment plant is going to be constructed in Jacksonville to replacethe existing plant. The average annual water temperature is 19 oC. The following designassumptions for a flocculation tank have been made:Number of tanks = 1Detention time = 40 minVelocity gradient = 25 s−1Impeller type: radial, 3 flat blades, Np = 0.33Impeller diameter = 1.1 mRotational speed = 30 rpmWhat is the design flow rate in m3/d?
02: Find dimensions (b and h) of wash water channels for one filter, for the followin • Q (discharge of back wash for one filter) = 100 000 1/day. Two wash water channels are used for this filter. • Time of washing with water = 6 minutes. 3 Q2 Use( h = 1.73 b2.g