Write 10 Difference between squirrel cage and slip ring with your own words

Q: Three parallel three-phase loads are supplied from a 207.85-V rms, 60-Hz three-phase supply. The…

A: Given data, Voltage V = 207.85 V Frequency f = 60 Hz

Q: A series circuit of 27 ohms, 3.06 Henry Inductor and 0.0172 capacitor are energized by 700 Volts DC…

A:

Q: A signal shown in Fig. 2.23 is applied to the integrator. Determine the output waveform with the…

A:

Q: What is starter ? Function of starter?

A: A motor starters main job is to start and stop the motor to which it is attached. These…

Q: transistor uses

A: A unipolar transistor uses the orientation to the one pole.

Q: Q1:: A: Prove that the temperature coefficient of resistance u, at any temperature 0, a₂ Is: 1+ (0,…

A:

Q: 5. Two point particles, one with charge +8 × 109 C and the other with charge -2 × 10⁹ C, are…

A: Given data : One charge q1=8×10-9C Other charge q2=-2×10-9C Distance between charge d=4m

Q: Determine the value of ix and V. 20230° V 60Hz 10 92 ΤΗ m 0.1 F 0.5 H V

A:

Q: 5 R. 8 R₂ Is 20R3≤ 1

A:

Q: Design a non inverting Schmitt trigger circuit with VT to be adjustable from = 5 V to 10 V.

A: Solution- Non inverting schmitt trigger is given by, from KCL, Vx-VinR1+Vx-V0R2=0VxR1+R2=VinR2+V0R1…

Q: 4 (b) A Linear time Invariant systems is described as: y[n]y[n-1]+y[n-2] + x[n-1] Find the system…

A: Given: yn=yn-1+yn-2+xn-1   Required: (1) Find the system transfer function for this system.…

Q: A 50 element is set for 0.8 per unit (80%) of the CT primary current rating. For a CT with a rated…

A:

Q: 1. Power factor 2. Average power delivered by the source 3. Reactive Power 4. Apparent Power 5.…

A: The power factor is defined as the cosine angle between the voltage and current. So, power factor =…

Q: a) All NAND and inverter 5) all NOR and inverter.

A: The NAND gate and NOR gate are known as universal gates.  If all the inputs are high for a NAND…

Q: мосо, d2 x(+) d+2 2 is +2 d2 x(+) ct 2 1+1 +2

A: Last equation is given as, d2xtdt2=-δt+2+2δt+δt-2

Q: Determine the value of ix and V. 20/30° V 60Hz 10 92 IH 0.1 F 0.5 H V

A: Voltage remains same in parallel circuit Current remain same in series circuit To find the current…

Q: A 60μF capacitor in series with a voltmeter of 100000 resistance is connected across a 120-volt…

A: A 60uF capacitor in series with a voltmeter of 10000 ohms resistance is connected across a 120-volt…

Q: A 50μF capacitor is connected across a 400V dc source. It is then discharged through a voltmeter…

A: Capacitor is a energy stored device. It stores energy in the form of electric field. When charged…

Q: From the truth table below, determine the standard SOP expression. Inputs Output ABC X 000 0 001 1…

A: Given data, Truth table,

Q: Reading 3 Amps 350 Kiloohms 250 Milliamps MEGA MICRO 20 Megavolts 40 Microvolts Prefix 1 Nanofarad…

A:

Q: a) Let f(t) represents the output of an industrial system in time domain, and F(s) be its Laplace…

A: Note : Since both the sub parts are not interlinked to each other hence according to the guidelines…

Q: .1 A 0.18-um fabrication process is specified to have t = 4 nm, µ̟ = 450 cm'/N s, and V, = 0.5 V.…

A: It is given that: L=0.18 mtox=4 nm=4×10-9 mμn=450 cm2/V.sVt=0.5 VrDS=1 KΩ=1000 Ω at  VGS=1…

Q: Consider the following Transfer Function; G(s) = (s² + s-6) (s² - 2s + 6) (s² - 5s + 6) (s² + 2s +…

A:

Q: Discuss the power electronic converters used in wind energy conversion. Also, explain the converter…

A: Basic Components of Wind energy conversion  Wind turbine  Gear box SCIG / PMSG / WRSG  Generator…

Q: 2.3 A logic signal is required to give an indication when: a. the supply to an oven is on, and b.…

A: The indication is required for the following: The supply to the oven is on and the temperature of…

Q: Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t) NA…

A:

Q: 125. If voltage is equal to twice its original value, what is its corresponding change in dB? a. 3…

A: The Given is equal to twice its original values, To find corresponding change in dB.

Q: Consider a continuous-time system composed of only gains, adders and integrators having a transfer…

A: Given: Consider the continuous-time system composed of only gains, adders, and integrators having a…

Q: V T₁ Answer: 13 AN R3 R₁ V = 3 Volts, Itotal = 1/2 of 5 A = 2.5 A What will be the current l3 in…

A:

Q: 3. For the circuit shown in Fig. Q3: (v) calculate the power factor and indicate whether the circuit…

A: In this question we will find power factor and voltages across each element in sinusoidal form....

Q: iii) A three-phase, 50Hz, 6-pole induction motor runs at 950 rpm. Calculate a) the synchronous speed

A:

Q: (+ -15V 15V U1 VEE 741

A: Given data, Input is given, vi=12V, 6 V, 0 V, -6 V,-12 V Circuit diagram is given as,

Q: Consider the system shown below. M(f) (the Fourier transform of m(t)) is also shown. M (f) y(t) ∞…

A:

Q: According to the NEC, allowance for the future expansion of installations is A. an exception. B. in…

A: Answer:A:- an exception

Q: 10 V -10V Vi 一 DESIGN Si www 9+ 20 10 Vo -1.3V - 21.3V

A: Given here the input and output voltage waveforms of a design and asked to find the output voltage…

Q: what is the size of decoder for 16 x 4 ROM

A: We know that  DECODER: It is a combinational circuit, which contains N-inputs , 2^N outputs and one…

Q: For the circuit shown in Fig. Q4. calculate the current (I) flows for each passive element in polar…

A:

Q: Find the convolution between x(t) and hitt AX(t) 4 h(t) st. # 1 y(t) = x (t) Ⓡ htt), the find ycwW),…

A: Fourier Transform is used to analyze the frequency response of Non periodic signal Fourier series is…

Q: The quality factor Q of a circuit at 18 MHz is 50. The equivalent bandwidth is Blank 1 kHz.

A: To find the equivalent bandwidth of a circuit. Given, Quality factor Q = 50 at resonant frequency of…

Q: Convert the following circuit into a) all NAND and inverter b) all NOR and inverter

A: The given circuit can be converted into NAND and NOR base circuit by using the bubble logic.

Q: calculate the current (I) flows for each passive element in polar form. compute the average power…

A: given: source current =7sin(377t+70) resistance ,R=20 ohm inductance,L=180mH capacitance ,C=85micro…

Q: Q5. For the unity feedback system shown in Fig (5), where R(s) Do the following a. Sketch the root…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Enumerate the various types of concentrating solar collectors

A: Basically there are four types of concentrating solar collectors. 1) Parabolic trough collector. 2)…

Q: Give some features for resistances in parallel?

A: Parallel connection of resistance: Multiple resistors can be arranged in a circuit by branching off…

Q: Find the convolution between X(t) and hitt AX(U 4 h(t) st -1 1 y(t) = x (t) htt), the find Yew),…

A:

Q: 2 Find, graphically, the convolution between xit) and h(t) _-_X(t) = sint tho. _₂h(t) = S(t) =…

A:

Q: A 6 pole generator with wave wound armature has 50 slots each having 20 conductors. The flux per…

A: Given data, A generator has P=6A=2Slots=50Conductors per slot, 20ϕ=0.01 WbE=220 V

Q: 20.a. What's the primary disadvantage of using copper conductors? A. Durability B. Cost C.…

A: 20. (a) Although one of the most electrically conductive materials known, copper is easily corroded…

Q: A silicon diode at room temperature has a cross sectional area of 10μm². It is doped such that: Na =…

A:

Q: Q4. For the following electric circuit, design a close loop state space system using the pole…

A: Given circuit, Given data, Here, x=21 Resistance=x Ω                    =21 ΩInductance=0.5x H…