Answered: when the insulation of the equipment…

Engineering

Electrical Engineering

when the insulation of the equipment tested healthy ? justify .

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 15R: a. Must the metal frame of an electric clothes dryer be grounded? ___________ b. Is it permitted to...

See similar textbooks

Related questions

Q: What precautions must be utilized and maintained when setting up or using a Delata 4 wire system…

A: A four-wire delta system is a three-phase delta connection with a centre-tap on one of the…

Q: 17.b. Which of the following is the best example of a building supplied by a single branch circuit?…

A: According to the question we have to discuss about the best example of a building supplied by a…

Q: Which component of the power circuit serves as the brains?

A: We have to tell which component of power circuit act as brain of circuit.

Q: Explain this diagram for a dummy

A: The given circuit is as shown below,

Q: Can I use the 66-block in telephone wire distribution to its outlets? How is it distributed?

A: According to the question, we need to explain the 66-block in telephone wire distribution.

Q: Explain the major consideration required for a protective system.

A: In the power plant, the generator is one of the most expensive pieces of equipment; therefore,…

Q: What justifies the need for plenumrated cabling above the ceiling tile?

Q: 8. Where the nameplate of an air-conditioning unit specifies the minimum ampacity required for the…

Q: 4.a. The installation of motor controllers and combination load equipment is not permitted if the…

A: A motor controller is a device or combination of devices, that can control how an electric motor…

Q: When calculating a dwelling lighting load on the "volt-ampere per ft" basis, the receptacle load…

A: Given: Receptacle loads used are Floor and table lamps. When dwelling loads are calculated what must…

Q: 2. Identify and explain the safety procedures and precautions when working with tools and…

A: Electrical cables are used for sending signals and also for long distance communication. There are…

Q: What type of electrical system is used in homes?

A: Electrical wiring is all about connecting wires and cables to varied Equipment and devices like…

Q: 11. What are at least two instances where a splice is allowed to be made in underground consumer's…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: 10. Which of the following statements about ground faults is true? A. They usually occur between any…

A: Ground faults: It happens when an energized conductor develops an accidental contact with the…

Q: What would be the voltage regulation of the system?

Q: ity or enery that are used by

A: The power system consists of electric generation, distribution and customer satisfaction. In a…

Q: What is the minimum branch circuit wire size that may be installed in a dwelling?

A: Basically, the 14 AWG wiring is used for typical lightening loads in the residence.

Q: Why is it necessary to run plenumrated cabling above the ceiling tile?

Q: When the nameplate of HVAC equipment is marked “Maximum Size Fuse—50 Amperes,” is it permitted to…

A: The device that have the maximum size are generally air conditioner and the refrigerator have the…

Q: when calculating a dwelling lighting load on the "volt-ampere per ft2" basis, the receptacle load…

A: The dwelling lighting load on the "volt-ampere per ft2" basis is to be calculated for the receptacle…

Q: what section of the code prohibits supporting telephone wires from raceways that contain light or…

A: N.E.C. ARTICLE 820 article covers coaxial cable distribution of radio frequency signals or covers…

Q: Which of the following must be notified prior to equipment shutdown for repair? a. Director of…

A: In this question we will write Which must be notified prior to equipment shutdown for repair..

Q: If asked to determine the power rating (MVA rating) of an overhead line, do they mean the power…

A: The power rating of a transmission line is defined at the designing phase of the line. Power carried…

Q: Identify and explain the safety procedures and precautions that should be followed for fire…

A: Procedure that is used to install cable in buildings are as follows:- Electrical conduction for…

Q: Identify and explain the safety procedures and precautions that should be followed for fire…

A: Safety precautions for fire prevention - Always Get Ready with the emergency plan Training of…

Q: Which of the following type of insulation can be installed underground?

Q: 10.a. Which of the following is a condition of the exception that allows the grounded conductor of…

A: According to guidelines we need to solve only first question. According to the question we have to…

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: If a separate, wire-type equipment grounding conductor (EGC) is used for any reason, the EGC of a…

A: Equipment grounding Equipment grounding includes exposed conductive parts which can get energized.…

Q: 45. What section of the Code prohibits the use of sheet metal screws as a means of attaching…

A: As per the bartleby policy you can ask one question at a time so please ask other questions a…

Q: use a conventional 12 volt test light to diagnose components and wires in a computer system . True…

Q: A one-family dwelling has a 175-ampere, 240-volt service that is fed with 75⁰ C (167 degrees)…

A: One family dwelling means to construct a house which is only suitable for one family.

Q: Which of the following is an installation requirement for the grounding electrode conductor in a…

A: ANSWER - (A,C,D) is correct EXPLANATION- Option (A)- Grounding…

Q: difference betwwen fuse and circuit breaker ?

A: Fuse : A fuse can be defined as an electrical safety device which protects an electrical circuit…

Q: What do you mean by permissible current loading of an underground cable?

A: Permissible current loading: It is the maximum amount of current the cable can carry without any…

Q: 1. What motor is used in the washing machines? Explain in detail the construction and working of the…

A: Motor used in the washing machine is Universal motor. The universal motor is an…

Q: 11.a. Which of the following is a point where a grounding electrode conductor connection must be…

A: Answer 11 (a) : According to national electrical code 250-(96), Grounding electrode conductor…

Q: small appliance receptacles included in the 3 volt-ampere per square foot load calculation

A: Small appliances receptacles are those circuits devoted for the utilization of interfacing little…

Q: Explain the relevance of earthing and bonding in an electrical Installation.

A: Earthing is used to protect us from an electric shock. It is done by providing a path (a protective…

Q: Describe the various methods of laying underground cables. What are the relative advantages and…

A: Proper laying and attachment of fittings decide the reliability of underground cables. The fittings…

Q: Why is it critical to keep cable clutter to a minimum in a rack?

A: It is asked to explain why it is critical to keep cable clutter to a minimum in a rack.

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

when the insulation of the equipment tested healthy ? justify .

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

True or False If a metal rack is properly grounded the equipment that is mounted on the rack and in good electrical contact with it is considered to be grounded
Explain the relevance of earthing and bonding in an electrical Installation.
Q.7: Air-condition system being in every organization. How the Maintenance of Air Conditioning System take place. What are preventative measures required?
a. Must the metal frame of an electric clothes dryer be grounded? ___________ b. Is it permitted to ground the metal frame of an electric clothes dryer to the neutral conductor? ___________
Determine the size and type of wire to he installed to a building with temperature that reaches 80-90 degrees with the following loads. 10pcs. Of 200- watt bulb 15pcs. Of 100-watt bulb Single phase, 230 source. And if you would be installing the wire inside an EMT conduit, what size would you use assuming that there would be 4 wires inside the EMT
10 What layer is used to smoothen the irregularity of the surface of the conductors of Underground Cables? A. METALLIC SHIELD B. CONDUCTOR SCREEN C. INSULATION D. SERVING
8/ Which layer in the construction of Underground Cables protects the Steel Wire or Tape from atmospheric contaminants and agents? A. INSULATION B. ARMORING C. BEDDING D. SERVING
7.B. The size of a grounding electrode conductor for a service or separately derived system is generally basedon the size of the largestA. ungrounded supply conductor.B. equipment grounding conductor.C. grounded electrode.D. bonding jumper.7.C. Which of the following statements about bonding is true?A. The joint or termination must offer opposition in the circuit for effective electrical connections.B. Effective bonding keeps impedance high if a fault should occur.C. The entire electrical safety circuit is only as good as its strongest bonded link.D. Bonding connections must endure high levels of fault current until overcurrent protective devices can operate.
What precautions must be utilized and maintained when setting up or using a Delata 4 wire system that is to serve both 240 V and 120 V single phase loads?
Which materials is not used as in the Insulation Layer of the Underground Cable? O A. PVC O B. XLPE O C. IMPREGNATED PAPER O D. HESSIAN TAPE
17- The electromechanical breakdown depend on the type of the dielectric between two electrodes a- Right. b- Wrong 18- Basic Insulation Level (BIL) is related to the design consideration of the electric device, while Basic protection (BPL) level is related to protection level of the that device. a Right. Wrong. b- 19- As the voltage regulation increased, receiving end voltage will be reduced. Right. b- Wrong 20- We can be using Solar power generation field as a power factor and voltage profile enhancement in Distribution system. (aRight. b- Wrong. 21- From the general electrostatic theories, the field strength at breakdown is given by: a Eb = V/ do =0.6 [Y/ (€ o Er) ] 0.5. b- Eb V/ do = 0.6 [Y / (€ 0/Er )] 0.5. C- Eb V/ do = 0.6 [ Y/(Eo Er) 20.05. d- Eb V/ do = 0.6 [ Y/ (Eo Er) 10.5. 22- Consider plane electrodes with a solid insulator between them. Find the electric field strength at breakdown, if Young's modulus = 10000 (V.F/m2). and the relative permittivity is (36000 TT). If the…
a. What is the minimum power demand allowed by the Code for an electric dryer if no actual rating is available for the purpose of calculating feeder and service-entrance conductor sizing? ______________ b. What is the current draw? _____________________