Answered: When a 4.7 uF capacitor is connected to…

When a 4.7 uF capacitor is connected to a 1 kHz source, what is its capacitive reactance? A. 4.7 ohms B. 29.5 ohms C. 34 ohms

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Find the even and odd part. g(t) = 2t²3t+ 6

A: Given signal, gt=2t2-3t+6

Q: Find the equivalent resistance between terminals A and B. R₁ = 78 ohms R2 = 37 ohms AO BO R₁ R₂

A: Given circuit: Where, R1=78 Ω,R2=37 Ω.

Q: 1. An 8-bit register contains the number 10000110. The serial number 11011011is applied to the…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: + R₁ 44444 R₂ MAMMA ми R5 или M R4 R6₂ AMA R7 www Rq www R8

Q: 2. Find the power absorbed or supplied by each element in the circuit of Figure B. 20 V I=5A P2 P1…

A: We need to find out power which is supplied or absorbed by each element in given circuit.

Q: For the figure shown below, do the following: (a) Connect the output line O6 of the decoder to the…

A: To access the data from 4K EPROM, we have used a 3:8 decoder. The memory mapping address is required…

Q: 4. Determine V₁ and V₂ using nodal analysis. Show complete solution using either elimination or…

Q: For the circuit shown, the load line is as shown in the figure. Determine the value of IB VI 430 kQ…

Q: The energy band in which free electrons exist is the first band O valence band O conduction band O…

Q: 4. Unless the state of a NAND gate latch is being change, its inputs should both be a. high b. low…

A: The NAND Gate latch is as shown below,

Q: In a short circuit test on a circuit breaker, the following readings were obtained on single…

A: Given: Time to reach the peak restriking voltage, t=50 μs. Peak restriking voltage, Vp=100 kV.

Q: 17 A motor drives a flywheel having a moment of inertia of 5 kg-m². The speed increases from 1600…

A: Given: Moment of inertia: J=5 kg.m2the speed increses from n1=1600 r/min to n2=1800 r/minso,change…

Q: ५ 4 24 ३8 ५ 4 नई 24) RT= 3.5294kn 4 s in 30 30x4 30tl 23.52941

Q: For a system consist from 3 buses and bus 1 is the slack bus. The data of the system are:- 0.25 -0.2…

Q: 2. The noise output of a resistor is amplified by a noiseless amplifier having a gain of 60 and a…

Q: Q4) Find the following: A. (1100); × (101): B. (1101)+(101); C. (10011000) BCD + (10010111)acD

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: HW3C2 4. For the network of Fig. 16.42: a. Find the total impedance ZT. b. Calculate the voltage V₂…

Q: Draw the Timing diagram for MVI B, 43,i > Fetching the Opcode 06 from the memory 2000. > Read the…

A: MVI B,43H: Move immediate 43H into register B. [B]←43H

Q: 120 V fo Ideal diodes 2.2kQ 2.2 ΚΩ 2.2 k

Q: 17. Find the amplitude and frequency of the following waves: a. 20 sin 377t b. 12 sin 27 120t

A: a) Given: The wave is 20sin377t.

Q: Q5-Obtained the syndrome table for (5,3) systematic cyclic code generated by g(x)=1+x², then find…

A: Given: For (5,3) systematic cyclic code generator polynomial, g(x)=1+x2 Received code word = [1 1 0…

Q: A symmetrical three-phase voltage source, wye connected with Van = 200 Vrms feeds a three phase load…

Q: For double sideband (DSB) signal f) What is the difficulty of synchronous demodulation (coherent…

A: SOLUTION PART-f Difficulty of…

Q: Theoretical and experimental values of five resistors in the labora Industrial value (0) Measured…

Q: Electrons pass right through a wire cross section at the rate of 6.4 x 10²1 electrons per minute.…

A: SOLUTION GIVEN Number of electron pass through Wire cross…

Q: The value of Z in figure, which is most appropriate to cause parallel resonance at 500 Hz, is 5Ω 2H…

A: Given- Parallel resonance at 500 Hz. R=5 Ω, To Find- The value of Z.

Q: Determine the input resistance Rin as indicated in the figure. Ignore resistor ro of the transistor…

A: The required input resistance can be calculated by using the small signal analysis of the given…

Q: Problem 8) The armature of a 6-pole lap wound dc shunt motor takes 400 A at a speed of 350 rpm. The…

A: Given- 6-pole lap wound dc shunt motor, P=6, current I = 400 A, speed N=350 RPM, flux per pole- ϕ=80…

Q: Determine in the given figure. Consider X= 4.5 A and Y= 5.5 A. A C 1A The value of it is X 2 A A. B…

A: The given circuit is, Where X=4.5 A,Y=5.5 A.

Q: A positional control system has a damping ratio of 0.6. The damped frequency of oscillations is 8…

A: A function or signal that exceeds its aim manifests as an overshoot.The damping frequency is the…

Q: The input characteristics of common emitter is between IE and IB O IC and VCE IB and VBE IB and VCE…

A: Given: Input characteristics of common emitter configuration is in between __________? To select:…

Q: What is short-circuiting? State one factor/ condition that can lead to it. Name a device in the…

Q: INSTRUCTION 1. 2 Simplify the given logic equation then draw the final circuit. X-(AB + BC) + BC (B…

A: This is basic problem of logic gates.

Q: The resistance of a 125 2 strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is…

A: Given: The resistance, R=125 Ω. Change in resistance, ∆R=1 Ω. Strain, ε=4000×10-6.

Q: what is the current through R4 h3 382.5 R3 Tr 5V R4 R1315K Raz 15K

A: The circuit can drawn as

Q: For the circuit shown, the load line is as shown in the figure. Determine the value of Vcc and Rc…

A: In these questions, We need to choose the correct option We are solving this problem using the…

Q: Determine the Fourier series coefficient and sketch the magnitude spectrum of the following periodic…

A: The periodic or non periodic signal is represented in sinusoidal form by Fourier series. The Fourier…

Q: Q4) Find the following: A. (1100): x (101): B. (1101)+(101): C. (10011000) BCD + (10010111)BCD D.…

Q: A 30 MVA, 13.2KV synchronous generator has a solidly grounded neutral. Its positive, negative and…

Q: 4.14 A 4800/240-V, single-phase transformer is rated at 10 kVA, and it has an equiv- alent impedance…

Q: A galvanometer with a full-scale current of 10 mA has a resistance of 10000. The multiplying power…

A: Given, Im=10 mA Rm=100 ohm Rsh=100 ohm

Q: Calculate the equivalent impedance of a circuit in which a coil of wire having a value of 5∠53.2ºohm…

Q: Determine the operation status of the silicon diode in Figure below 10k www 8v T 10 k 18v Not…

A: diode is said to be in reverse bias if anode to cathode voltage is less than 0.7. diode is said to…

Q: SOLVE FOR THE UNKNOWN CURRENTS AND VOLTAGES ASKED source: 400V balanced line to line Line 1:…

A: Voltage at a'' is not given. We can not solve the problem unless it is specified. Assumption : We…

Q: A 3-phase motor is operating with and Vod gd0s = = [100 0 5] V Idos[10-50 1] A. Currents are defined…

A: Given- Three phase motor values- Voltage- Vqd0s=10005 V Current- Iqd0s= 10-500 A To find- Energy…

Q: 1. A voltage transformer has 1500 turns of wire on its primary coil and 500 turns of wire for its…

Q: Sketch the continuous-time signal below and specify if the signal is: a. Causal/ non-causal/ anti…

A: Given: ft=1t<-1-t-1<t<1-1t>1

Q: For the circuit shown in the figure below, find the output impedance. Assume V₁ < 0. Vcc RE VinoQ₁ -…

Q: 6. Draw the Wheatstone bridge circuit diagram and explain how it can be used to measure an unknown…

Q: Two loads are connected in parallel to a source of emf whose voltage is (110 + j63.5). if the branch…

A: In this question, We need to determine the total current, equivalent impedance, total power and…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

When a 4.7 uF capacitor is connected to a 1 kHz source, what is its capacitive reactance?
A. 4.7 ohms
B. 29.5 ohms
C. 34 ohms
D. 213 ohms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
List the five capacitor replacement rules.
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A 10.0-μF capacitor and a 2.00-H inductor are connected in series with a 60.0-Hz source whose rms output is 100 V. Finda. the rms current in the circuit.b. the voltage drop across the inductor. c. the voltage drop across the capacitor.
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7
A capacitor C is connected in series with a 400 resistor across a supply of frequency 60 Hz. A current of 3 A flows and the circuit impedance is 500. Calculate: (a) the value of capacitance, C, (b) the supply voltage, (c) the phase angle between the supply voltage and current, (d) the p.d. across the resistor, and (e) the p.d. across the capacitor. Draw the Phasor diagram.
Through a capacitor of capacitance 15 micro-farad with a frequency of 50 hz. Compute its reactance 212 ohms O 4,712 ohms O 0.0047 ohm O 0.0002 ohm
What is the value of capacitance if the capacitive reactance is 50 Q .Assume frequency of supply as 50 Hz ? a. 53.3x10-5 F O b. 5.3x10-5 F c. 6.36x10-5 E d. 63.3x10-5 F
Regarding behavior of inductors and capacitors in circuits, select the correctstatement -a) Voltage leads current in a capacitive circuit,b) Current leads voltage by 180 degrees in a pure capacitor,c) Voltage leads current by 45 degrees in a pure inductor,d) Current leads voltage in an inductive circuit,e) Current lags voltage in a pure capacitor by 90 degrees,f) Current lags voltage by 90 degrees in a pure inductor
2. What must the frequency be for a 10uf capacitor to have a reactance of 1000 Ohms? form if it